1. When the same amount of water and acetone were allowed to flow on a slope, it was observed that acetone flowed faster than water. Why do you think acetone flowed faster compared to water?
Q: 1. You have a shortage of drinkable water in your town and are trying to prepare safe drinking water…
A: The amount of water that comes in and going out is at the same rate. So if the motor is fast then…
Q: 1. A laboratory requires 2000 cm° of an antifreeze solution consisting of 30 mol % methanol in…
A: To solve this problem, we can use the concept of partial molar volumes and mole fraction. Let's…
Q: 4. You have 1 kg of water and you want to use that to melt 0.1 kg of ice. What is the minimum…
A: Given data: The mass of water is m=1 kg. The mass of ice is m'=0.1 kg.
Q: 1. There are 1000 m3 of glycerin in a container at 15°C. What is the difference in volume if the…
A: As the temperature is increased the density of glycerin decreases due to the fact that molecules…
Q: 5. Give examples of solids that expand or contract due to temperature changes?
A: Most substances expand on heating and contact on cooling as a change on the temperature of the body…
Q: Rating after verification . Tks
A: Given data:Length of pipe, L=1000mDiameter of pipe, D=0.2mKinematic viscosity, υ=10−6m2/sflow rate…
Q: 3) Calculate the osmotic pressure of 25% C 37) of the urea solution at temperature 1070.7 KPa…
A:
Q: explain the solution in details
A:
Q: None
A: To determine which statement is true, we first need to understand what water hardness is and how it…
Q: 3. The following graph describes the material's behavior under stable creep conditions at T-732 °C.…
A: The graph in the image describes the material's behavior under stable creep conditions at a…
Q: 2. Does a substance that heats up quickly have a high or a low specific heat capacity? Explain?
A: Specific heat capacity is the heat capacity possessed by the sample divided by the mass of it.
Q: 5. The density of water at 4°C is 1,000 kg/m³. What is the water's density at 94°C? (where ß = 207 x…
A:
Q: 4. Temperature effect on the decomposition of drug Y was evaluated at two temperatures; 40 and 60°C.…
A:
Q: 2. What is the temperature of an 11.2-L sample of carbon monoxide, CO at 744 torr if it occupies…
A:
Q: 5. The experimentally determined density of a material is lower than expected based on the…
A: 5. This material might be ice. The density of water in its liquid form is greater than the density…
Q: 14. 5 kg of liquid seawater with initial temperature 0°C and salinity 3 percent (by mass) is mixed…
A:
Q: 6. The relationship between the coefficient of volume expansion ß and the coefficient of linear…
A: We know the expression for cofficient of linear expansion is α =β2=γ3 So the realtion between…
Q: Choose which term among the following refers to each statement in numbers 1 to 4. A. Surface tension…
A: Given: Options A Surface tension B. Viscocity C. Boiling point D. Heat of Vaporization
Q: The triple point in the PVT diagram for pure substances is a. The top of the dome for the…
A: It is asked to choose the correct option for the triple point in the PVT diagram for pure substance.
Q: An aqueous solution of ammonium sulfide, (NH,),S, is made by dissolving 7.64 grams of ammonium…
A: The weight by volume percentage (w/v %) is defined as the mass of solute in grams per 100 mL of…
Q: 200 g of Coke with temperature of 20 degree celcius was mixed with 20 g of ice at 0 degree celcius.…
A: Given , mass of coke , mcoke =200g Temperature of coke = 20 degree celcius mass of ice ,mice = 20g…
Q: 1. Explain the phase change of the cubes of ice turned into water vapor.
A: At first fusion occurs ie with increase of temperature the ice reaches to temperature 0°C and start…
Q: shampoo
A:
Q: You have a summer job with a company that designs cookware. Your group is assigned the task of…
A: Given information: Here, Ti and Tf are the initial and the final temperature of the water…
Q: gine. Starting at the same maximum operating temperature, which would be more
A:
Q: Solid "A" is hard and has a higher melting point. And it does not conduct electricity at the molten…
A: Given: Solid "A" is hard and has a higher malting point which does not conduct electricity at the…
Q: In a solid, the attractive and repulsive forces between the molecules tend to maintain them at…
A:
Q: 1. How much heat is required to change the temperature of lead from 15°c to 65°c?
A: The specific heat capacity of lead is 0.129 J/goC. The heat required to rise the temperature from…
Q: 8. A mass m = 0.046 kg of benzene vapor at its boiling point of 80.1 °C is to be condensed by mixing…
A:
Q: 7. A mass m = 0.060 kg of benzene vapor at its boiling point of 80.1 °C is to be condensed by mixing…
A: Heat from benzene vapor is absorbed by water to condense benzene vapor. Q=mblv Q=mwCw∆T Equate both…
Q: 8. In a mixture of weak acid and its salt, the ratio of the concentration of acid to salt is…
A: Solution: As per the given statement, We know that, PH=PKa+logbase/acid
Q: Calculate for the final boilir aqueous solution of KBr. The b water is 0.512 °C kg mol·1, anc…
A: We have givenAqueous solution of KBr (M)= 2.70 MBoiling point constant (k)= 0.512 °C Kg mol-1and…
Q: 1. A fan connected to a grain dryer will move 12,500 cfm of air. The dryer system has a heater that…
A: The rate at which groundwater moves through a specific well or aquifer cross-section is referred to…
Q: | 4. Convert 4.8 kg to pounas (1 iD = 453.0 g) 5. An object has a mass of 666 g. When this is added…
A:
Q: Calculate the molality of chloride ions in an aqueous solution of magnesium chloride in which the…
A: The mole fraction of magnesium chloride is given as, 0.0150 The mass of sodium hydroxide is given…
Q: A solution containing 90% by volume of alcohol (in water) runs at 1 gal/min into a 100-gal tank of…
A: Given: Volume is 90 % Alcohol volume is 1 gal/min Volume of pure water is 100-gal
Q: 2. (14.13) How long does it take a 750-W coffeepot to bring to a boil 0.75 L of water initially at…
A:
Q: The heat of combustion of firewood is 4x10^3 cal/g. What is the amount of wood that he must burn to…
A: Heat combustion, H = 4×10³ cal/gEnergy, E = 4.76×10⁵ BTU = 4.76×10⁵×252 cal = 1.2×10⁸ calMass of…
Q: 1. A spray can is used until it is empty except for the propellant gas, which has a pressure of 1344…
A: We are authorized to answer one Question at a time, since you have not mentioned which question…
Q: 1. Derive the expression for the change in volume [AV = B.V₁.AT] using the expression of linear…
A: Note : Hey there, since you have posted multiple questions. We have solved the first one for you.…
Q: For what of range of pressures will a temperature increase lead to melting? (Put your answer in the…
A: Concept used: Pressure temperature curve is given. Triple point is a point at which all three phases…
1. When the same amount of water and acetone were allowed to flow on a slope,
it was observed that acetone flowed faster than water. Why do you think
acetone flowed faster compared to water?
2. If you heat the same amount of water and acetone, you will observe that
acetone boils faster. Why does acetone boil faster than water?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps