1. What is the pressure at the center of pipe B? +) B -y-10 kN/m3 y - 20 kN/ma 50 cm 50 cm 10 cm

Q: Air For the setup shown, a manometer was attached from a tank into a pipe with liquid (SG=0.95).…

A: Given data in question  Depths Oil of specific gravity 0.95 To find out  Absolute pressure at A Note…

Q: : - Fluid Department: - Civil Engineering 2nd stage Find the calculation for the experiment 1-…

A: Given:- St=26mm plate in tilt position and plate in perpendicular position To find:- 1- actual force…

Q: 1. Atmospheric pressure is about 80 kPa (absolute). Water pressure at the base of a water tower is…

A: In this question I  have to question but according to our guidelines we can answer only one…

Q: 1) Consider a chunk of fluid that is initially shaped as shown hanging off of the edge of a table in…

A: Let us consider the given shape "A" Assuming that the fluid section labeled is able to maintain its…

Q: 3. Water flows at the rate of 5 ft/s through an inclined pipe. At point A, where the diameter is 12…

A:

Q: Driven by pressurized air in a tank, water flows through pipes (L1₁ = 40 m, L2 = 80 m, L3 = 20 m) of…

A: Given: A flow of water through pipe of length L1, L2 and L3 as shown in the figure Dynamic…

Q: hydrostatic force

A: To find : ratio of the hydrostatic force exerted on the base and on any one of the vertical side

Q: Two pipes namely A and B are connected by a mercury manometer (SHg = 13.6). The fluid in both pipes…

A: SHg=13.6 To find h'

Q: If the pressure in a tank of oil (spec. gr.= 0.80) is 60 lb/in 2 , what is the equivalent pressure…

A:

Q: The height of the fluid inside the tube after immersion is 1/8 the height of the cylinder glass…

A: Calculating the height of tube: h=6+(h/8) 7h/8=6 h=0.0685 m

Q: 1. A large tank contains a layer of oil floating on water as shown in the figure below. The flow is…

A: Given data  Specific gravity of oil = 0.8  Density of water = 1000 Pa  Acceleration due to gravity =…

Q: An incomprehensible Newtonian fluid flows in a laminar regime in a groove formed by tw walls that…

A: The question is based on the incompressible non-Newtonian fluid flows through a laminar regime in a…

Q: The gage pressure in a gas tank is 3.75 atmospheres. Compute the pressure head in meter of water? Do…

A:

Q: EXAMPLE 10.4. The three pipes in figure are cast iron with characteristics as shown in table. The…

A:

Q: 25. Which of the following cannot be the value of absolute pressure of a fluid at any point? a) 0 b)…

A: Absolute zero pressure is the refrence used for measurement of absolute pressure. Absolute zero…

Q: TANK TANK DATUM DATUM DRAW AND LABEL PRESSURE HEAD (STATIC) DRAW AND LABEL VELOCITY HEAD Pressure…

A:

Q: solve and give an explanation. thank you i am confused, shouldn't the pressure  be negative because…

A: Using basic principle

Q: PROBLEM 10: For the manometers shown, Determine the 18 in difference in pressure between A and B in…

A:

Q: 7. Total pressure is an addition of static pressure and a) Dynamic pressure b) Stagnation pressure…

A: The total pressure, also known as stagnation pressure, is the maximum pressure that can be found in…

Q: M1 U5: Use the general solution in determining the total hydrostatic force acting on the submerged…

A:

Q: The U-tube manometer in Figure 1 is open to the atmosphere. It is connected to a tank. There are 4…

A: Pressure measurement using u tube manometer

Q: Water is flowing through a pipe 1/3 ft. inside diameter into a pipe 1'' in diameter at a rate of…

A: Given: P1 = 275.8 KPa  Q= 12.62 lps  D1= 1/3 ft D2 = 1inch Required : P2

Q: Fluid mechanics, I need solutions in 15 minutes please.

A:

Q: Oil flows from one tank to another when the gate valve is fully opened. All pipe diameter is 20mm…

A: Given data:- Flow entrance, K=0.5 Gate valve, K=0.19 90 degree Elbow, K=9 Density of oil, ρoil=920…

Q: The branching of a blood vessel is shown. Blood at a pressure of 100mg Hg (13.3kPa) flows in the…

A: Given data  Discharge  Angle Diameter  We will use make of Momentum equation to solve this question.…

Q: lock is 10 Nt. The area of the contact surface between the bilock and fluid is 10 m². (27) Nt 1mm 30…

A: Given dataA=10cm2=10×10-4m2, μ=0.2 Nsm2,dy=10-3mShear force Fs=27- Psin30°=27-10×0.5=22 NThus Shear…

Q: 4. Show the effect of each of the following on the position of the pressure center (h.): a. Fluid…

A:

Q: An incompressible fluid is initially undergoing turbulent flow, and the flow rate is slowly…

A: As multiple questions are asked and as per the guidelines only first question will be answered.Flow…

Q: Mercury (5.g. = 13.6) 0.4 ft y Oil B (s.g. = 0.91)

A:

Q: 5.5 in. Open 1.4 in. Water Unknown fluid Open 4.9 in. 3.3 in.

A:

Q: 8. If the pressure remains a constant, then a) Vr1 > Vr2 b) V1 < Vr2 c) Vr1 = Vr2 d) Vr1 is a zero

A: The correct option to this question is option (c).

Q: Select the true statements about the various pressure definitions (check all that apply). O Absolute…

A: The examination of applied stress by such a body (liquid as well as gas) on a surface is known as…

Q: Q5. Determine the volumetric flow and the pressure in the pipe at A if the height of the water…

A: Volumetric flow Pressure in the pipe at A

Q: In a vertical pipe conveying oil of s= 0.2, two pressure gauges have been installed at A and B where…

A: s = Specific ravity of oil = 0.2ρ0 = Desnisty of oil = 0.2×ρw = 0.2×1000 = 200 Kg/m3dA = Diameter at…

Q: This subject is fluid mechanics,i dont know how to solve this.please help me before exam.

A: Flow rate of orifice meter, Q = C A1 A2 2ghA12-A22 .............................. (1) Where C…

Q: Fluid mechanics, i need solutions in 10 minutes please. MCQ/An inclined rectangular gate with water…

A: Consider the free body diagram of inclined rectangular gate submerged in water as shown below.…

Q: 7.4 J The courthouse record for a 1902 property survey at Ketchikan, Alaska, lists the magnetic…

A: Given:- The magnetic direction of a property boundary = S 82°44' W The declination of the property =…