1. The utility functions for auto and transit are as follows: Auto: U = -0.46- 0.35T, -0.08T, - 0.005C Transit: UT = -0.07 - 0.05T - 0.15T2-0.005C Where: T1 - total travel time (minutes) T2 - waiting time (minutes) C- cost (cents) The travel characteristics between two zones are as follows: Auto Transit T1 T2 20 30 6. 8. 320 100 Determine the percent of travel in the zone by auto and transit using logit model.

1. The utility functions for auto and transit are as follows: Auto: U = -0.46- 0.35T, -0.08T, - 0.005C Transit: UT = -0.07 - 0.05T - 0.15T2-0.005C Where: T1 - total travel time (minutes) T2 - waiting time (minutes) C- cost (cents) The travel characteristics between two zones are as follows: Auto Transit T1 T2 20 30 6. 8. 320 100 Determine the percent of travel in the zone by auto and transit using logit model.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

thermostat, which will turn the heat on when the room temperature drops h degrees below its set point, Ts, and cuts heat off at a temperature h degrees higher than Ts . The system heats at a constant rate Q (thermal units per time unit), and the volume of the room is V, so, if the room were perfectly insulated, the heating system would raise the temperature of the room at the rate KVQ (degrees per time unit), where K is a constant of proportionality giving the change in temperature per thermal unit per unit volume. However, there is a heat loss to the outside that is proportional to the difference in temperature between the room and the outside. Using the modified Euler method, write a FORTRAN program to simulate this system, if the room temperature at time is T(t), T(0) = To, and the outside temperature, Tout' is given by: Case (1) : Tout is constant < Ts Case (2) : Tout = A sin(wt + 4)| , %3D reflecting daily cycles. A is temperature range, 2n/w is the period of a cycle, and o is the…
A function named validGPA() to validate the GPA. A valid GPA value must be between 0 and 4 inclusive. The function must return the value of GPA and must take value of GPA as parameter.
Suppose you are trying to make a schedule for use of the auditorium for different clubs in a school. The auditorium can be used in the afternoons from Sunday to Thursday. There are five clubs: Music, Drama, Dance, Photography, Computer. There are a few rules that must be followed: a)The auditorium can be used by only one club on a day. b)Computer club wants to use on Monday or Thursday. c)Drama club wants on Wednesday or Thursday. d)Music club is fine with any day. Dance club wants on Monday or Wednesday. e)Photography club wants on Sunday, Tuesday or Wednesday. Formulate this problem as a CSP. Draw the constraint graph. Show the steps followed by backtracking search algorithm and derive a solution.
Consider the following two functions: def f1(x): if (x > 0): x = 3*x x = x / 2 return x def f2(x): if (x > 0): x = 3*x x = x / 2 return x For what values of x will f1 and f2 return the same value? For x< 3/2 When x is zero or positive Any value of x For negative values of x only
A performance venue hosts many concerts a year. Performers perform several times a year for the concerts. Each concert has one or more performers and has a name and a specified seating arrangement. A concert is held in one (and only one) of several concert halls, each of which has a room number and the number of seats. Each concert generates revenues from the sales of tickets. Assume that the price of the ticket is the same for the same concert, but different prices for different concerts.Identify several attributes and a key field for each entity. Represent this situation of concerts and performers with an E-R diagram
3. Spirometry is a test of lung function that measures how much and how quickly (volume and flow) the air movement in and out of the lungs. The measurements are made using an instrument called spirometer, which can provide the following parameters: i. Forced expiratory volume in one second (FEV1) ii. Forced vital capacity (FVC) These parameters can be used to make a diagnosis and to determine the severity of chronic obstructive pulmonary disease (COPD), an obstructive respiratory disorder characterized by airflow limitation and inflammation. It happens when the ratio of FEV1 to FVC is less than 0.70. The spirometric classification of COPD severity based on FEV1 is given in Table 5. Table 5. Spirometric classification of COPD severity. Condition / Severity Normal Mild COPD Moderate COPD Severe COPD Very severe COPD FEV1/ FVC > 0.70 FEV1 > 0.80 0.50 –- 0.79 < 0.70 0.30 - 0.49 <0.30 You are required to develop a program used by a medical practitioner to analyze the condition of few group…
Trucks take up more space on the road and are slowed down more by hills and steep inclines. Each truck on the road is translated into a number of cars using the following table. Car Terrain type equivalent of one Truck level 1.7 rolling 4.0 mountainous 8.0 Write the function car_equivalent_factor(terrain_type) that takes a string containing one of the three terrain types and returns the number of car equivalents for a truck on the given terrain. You function should always return float Notes: • You can assume that the function will always be called with one of the three valid terrain types. For example: Test Result factor = car_equivalent_factor('level') 1.7 print(factor) Answer: (penalty regime: 0, 10, 20, ... %) Ace editor not ready. Perhaps reload page? Falling back to raw text area.
In mathematics, the triangle inequality states that for any triangle, the sum of the lengths of any two sides must be greater than or equal to the length of the remaining side. Write a function named, prg_question_1 to check whether three sides of given lengths would form a triangle or not. For example, for sides 12.5, 20.8, 15.0 your function must return true whereas for 4.8, 3.0, 12.0 it must return false as 4.8 + 3.0 is < 12. Do the following: 1. Follow UMPIRE process to get the algorithm. Write only the algorithm as code comments 2. Implement your function 3. Test your function for the sets of side lengths of units 10, 20, 15 and 4, 4, 10. Please follow the test criteria given in the code template
Rod cutting problem: A cutting factory buys long steel rods and then and cuts them into shorter rods, which it then sells. Each cut is free. The selling price is based on the length of the cut. The factory want to determine the best cuts in order to maximize its revenue. Below, the price that the factory can make for each length of rod is given. Determine the maximum revenue, rn, obtainable by cutting up the rod and selling the pieces using bottom-up dynamic-programming approach. Length, I 1 2 3 4 5 6 7 Price, pi 2 4 5 6 9 10 12 r5 = ?