1. Refer to Figure below For H = 6 m, y = 17.0 kN/m³, 4' = 36°, c' = 0, ß = 85°, a = 10°, and 8' = 24°, assume %3D that the backfill is in the active state and use Coulomb’s equation to determine the magnitude, location, and direction of the active thrust on the wall. 2. what would be the active thrust Pa there is a surcharge of 25 kN/m² at the ground level? when

1. Refer to Figure below For H = 6 m, y = 17.0 kN/m³, 4' = 36°, c' = 0, ß = 85°, a = 10°, and 8' = 24°, assume %3D that the backfill is in the active state and use Coulomb’s equation to determine the magnitude, location, and direction of the active thrust on the wall. 2. what would be the active thrust Pa there is a surcharge of 25 kN/m² at the ground level? when

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q 11.7
| 166 kPa 54 kPa x 33 kPa Stresses on a x-y Cubic Element in the 0₁-03 plane. Questions 4-10 Draw Mohr's Circle for the stress condition shown above to answer the questions.
UPVOTE WILL BE GIVEN. WRITE THE COMOLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATION NEEDED. BOX THE FINAL ANSWER.
Q2. Which of the two retaining walls in Figure 2 produces a larger horizontal component of active thrust? y = 18 kN/m³ $'= 34° c' = 0 kPa 14 H=7m H = 7m Figure 2 115°
The retaining wall shown above is subjected to an active earth pressure distribution as illustrsted in the figure. What is the eccentricity of the resultant load acting on this wall (measured from the centre of the wall)? XX w=240 kN/m 5m length W 2m 35 kPa O 0.31 m O 0.61 m O 0.23 m O 0.41 m
For the wall shown in the figure: A) Calculate the distribution of pressures according to Rankine, assuming an active state. B) Calculate the Thrust and its point of application. q=2.0 ton/m2 ↓ ↓ ↓ ↓ ↓ ↓ Y = 1.60 ton/m3 ARENA Y' = 0.60 ton/m3 C = 0 ton/m2 = 33° NAF H1 2.0 m H2 = 8.0 m
Q. Result. Thurst
Q5: In the case of the retaining wall depicted below. Calculate the lateral earth fore at rest per unit length of the wall. Determine the location of the resulting force as well as its magnitude. [25] y = 16.5 kN/m $ = 30 C = 0 Ground v Water table 2.5m Yur = 19.3 kN/m 0 = 30 C = 0 2.5m Good Luck
12.3 Refer to Figure 12.12a. Given: H = 4 m, y = 16.5 kN/m³, ' = 30°, c' = 0, and B = 85°. Determine the Coulomb's active force per meter length of the wall and the location and direction of the resultant for the following cases: a. a 10° and 8' = 20° b. a = 20° and 8' = 15°
The following figure shows a section of an anchored retaining wall embedded into a saturated stiff clay layer. The sand has a unit weight of = 18 kN/m³, c' = 0 kPa and o' = 34º. The clay has a unit weight of = 20 kN/m³, c₁ = 80 kPa and = 0°. A uniform pressure of 40 kPa is applied on the soil surface. The short term stability of the wall is considered in an undrained analysis. Use the Rankin's theory of lateral earth pressure to determine the active and passive horizontal stresses. You should apply the requirements of AS 4678 and the partial factors of safety method in estimation of soil pressures. Assume the soil is in-situ and use a structural classification factor of ₁ = 1. 3m 1m Water table 1.5m 40 kPa Not to Scale Sand Clay Ta
H.W 2: _Find the collapse load (Wu) for the isotropic slab shown below by using yield line theory. Assume m* =m= 25 kN.m 6 m 4 m 3 m 3 m
For the frictionless wall shown in Figure No 1, Calculate the following: (a) The active lateral earth pressure distribution with depth.  (b) The passive lateral earth pressure distribution with depth(c) The magnitudes and locations of the active and passive forces.  (d) The resultant force and its location.  (e) The ratio of passive moment to active moment. Note: UDL should be considered as mentioned in the figure