1. How fast can a 46-byte block of data be transmitted on a 10 Mbps Ethernet packet and a 16Mbps Token Ring packet? 2. If you have an operating frequency of 750 MHz, what lonath cf a nairf cond uctors is considerod to pair f tors is

1. How fast can a 46-byte block of data be transmitted on a 10 Mbps Ethernet packet and a 16Mbps Token Ring packet? 2. If you have an operating frequency of 750 MHz, what lonath cf a nairf cond uctors is considerod to pair f tors is

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: Suppose a packet is 10K bits long, the channel transmission rate connecting a sender and receiver is…

A: To solve this problem we will be require the two formulas Round trip time = 2*Propagation Delay…

Q: Data communication Suppose that the spectrum of a channel is between 8 MHz and 10 MHz, and the…

A: In the realm of data communication, the efficient utilization of available bandwidth is crucial to…

Q: With proper justification, suggest a suitable protocol(s) that can be used to communicate between…

A: 1) Raspberry Pi to SD card : SD Card support pins like GND, 3V3, 5V, CS, MOSI, SCK, MISO, GND. It…

Q: Discuss the performance differences in choosing short and long timers/timeouts as a designer for the…

A: Answer:

Q: Discuss the performance differences in choosing short and long timers/timeouts as a designer for the…

A: Numerous problems become evident when requests take longer than usual to complete and may never be…

Q: Q.5.4 Explain what the primary differences between asynchronous connections, synchronous, and…

Q: what is a modem connection speed in kbps, if the circuit symbol rate is 13 thousand of symbols per…

A: Given, symbol rate 13000 symbols/second and since each symbol carries 3 bits, that is 3 bit /…

Q: Ibps and propagation spe of the cable is one bit delay

Q: Define the protocols used by (central) hub polling and token passing polling schemes and compare…

A: Control accessed protocols are used by the hub polling and token polling. Here only that station can…

Q: 7. Determine the hexadecimal equivalent of the following Ethernet address: 01011010 00010001…

Q: A network layer payload that is 60 bytes long is intended to be sent over a 10BaseT Ethernet be…

A: Solution: Given data : Network layer payload is 60 bytes.

Q: A 10-Mb/s Classic Ethernet transmits data packets obtained from the Network Layer. Assume for…

A: please check the step 2 for solution

Q: The CIA trend is defined and discussed, the three CSMA protocols are compared, and their usage in…

A: According to your question CSMA / CD (Carrier Sense Multiple Access or Collision Detection) is a…

Q: Channel utilization with pipelining. Suppose a packet is 10K bits long, the channel transmission…

A: Packet size = 10K bitsTransmission Rate = 10 MbpsRound Trip Propagation delay = 10msChannel…

Q: four sentences, describe Pure Aloha in Multiple Access Pro

A: Pure Aloha in Multiple Access Protocols

Q: Suppose you are designing a sliding window GBN protocol for a 5 Mbps point to point link, which has…

A: Find the required answer with calculation given as below :

Q: Assume that a reliable delivery of data from a machine M1 to another machine M2 is provided through…

A: For providing reliability in a network scenario where data is transmitted from machine M1 to machine…

Q: You were given the task of putting various network architectures to the test by linking five nodes…

A: To put various network architectures to the test by linking five nodes together where there are four…

Q: A Computer o11 the 4 Mbps network is regulated by a token bucket. The bucker is filled at a rate of…

A: Please refer below for your reference: Given: Rate r = 1Mbps Capacity c= 8Mb full rate m= 6Mbps

Q: The Frame Check Sequence (FCS) is implemented in Ethernet using a technique known as Cylic…

A: Introduction: The Frame Check Sequence (FCS) is implemented in Ethernet using a technique known as…

Q: This is the data frame for: Idle Select one: O O O Frame Start DO D1 D2 D3 D4 D5 D6* D7* D8* P* Stop…

A: Lets examine the dataframe 1) It can't be SPI protocol as it doesn't have start, stop and pairty…

Q: Ethernet System 10Base-5 10Base-2 10Base-T 10Broad-36 10Base-FL 10Base-FB 10Base-FP 100Base-T…

A: 10BASE - 5 10 - maximum theoretical bandwidth of 10 Mbit/s BASE - type of communication channel…

Q: A 100M-bit Ethernet has the following topology Hub The maximum length of each cable is 100m. The…

A: 64 bytes least bundle length is certainly not a self-assertive number. In a 10Base5 actual layer…

Q: As a designer for the data-link layer simplex stop-and-wait for noisy channel protocol, discuss the…

A: Many kinds of failures become apparent as requests taking longer than usual, and potentially never…

Q: mpare the Go-back N protocol with the rest of the protocols for effective frame transmission in…

A: Lets see the solution.

Q: An isochronous connection and a synchronous connection can be explained by comparing and contrasting…

A: Given: An asynchronous connection is one in which two or more parties are connected at the same…

Q: What are advantages and disadvantages of random access based multiple access protocols? Why slotted…

A: Multiple Access Protocols: The Data Link Layer is responsible for the transmission of data between…

Q: What is the shortest possible size for a valid Ethernet frame?

A: Answer:

Q: From the IEEE Standard Notation, state the notation of each Ethernet System. For example, the…

A: Below is the complete explanation about the IEEE Standard Notation of each Ethernet System in…

Q: Suppose you are designing a sliding window protocol for a 2Mbps point to point link to the moon,…

A: According to the information given:- We ahve to find minimum number of bits you need for the…

Q: Describe in detail with an example and application each of the following CNN architecture: Vggnet…

A: The community has called the runner-up at the ILSVRC 2014 competition VGGNet, which was constructed…

Q: Consider a channel with spectrum between 4 MHz and 6 MHz and SNRdB = 20. Using Shannon’s formula,…

A: The maximum capacity of the channel

Q: What is the total delay (latency) for a frame of size 78 million bits that is being sent on a same…

A: Given, Frame of size = 78 million bits = 78 × 106bits = 78000000 bits Queuing time = 83 μs = 83×…

Q: Efficiency Principle: Ethernet V1 access protocol was designed to run at 10 Mbps over 2.5 Km using…

A: In V1 access protocol we have, Bandwith (B) = 10Mbps Distance (D) =2.5 Km Packet size (S) = 1500…

Q: A Go-Back-N (GBN) ARQ scheme has been designed with window-size W = 10 such that it is fully…

A: Given that, In Go-Back-N ARQ scheme, Window size w= 10 Frame size= 20,000 bits There are no errors…

Q: Each time slot contains 148 bits. Just 114 of these 148 bits reflect speech or other info. The…

A: The answer is

Q: & wait proto the propagatio

Q: Consider the following destination address of standard Ethernet 42:10:1B:2D:06:EE What is the type…

A: The given destination address of standard Ethernet is : 42:10:1B:2D:06:EE

Q: Find the interface identifier if the physical address in the EUI is FC-AB-00-FE-00-AA-FF-FE16 using…

A: HEX: FCAB00FE00AAFFFEBIN: 1111 1100 1010 1011 0000 0000 1111 1110 0000 0000 1010 1010 1111 1111 1111…

Q: e size of 20 sıze asec. To ac ts requirec

Q: Consider sliding window protocol for 80Mbps point - to - point link with propagation delay of 2 sec.…

A: Given, Bandwidth = 80 Mbps Frame Size = 4 KB = 4096 * 8 bits = 32768 bits Propagation delay = tp = 2…

Q: Assume that a reliable delivery of data from a machine M1 to another machine M2 is provided through…

A: The transport layer would be the best layer to choose in order to guarantee the accuracy and…

Concept explainers

VLAN

VLAN stands for Virtual Local Area Network, and it is created from one or more local area networks. A Virtual Local Area Network (VLAN) is a customized network made up of one or more LANs. It allows a set of devices from different networks to be converted into a single logical network. As a result, a virtual LAN that is managed similarly to a physical LAN emerges.

Question

Computer Science
1. How fast can a 46-byte block of data be
transmitted on a 10 Mbps Ethernet packet and a
16Mbps Token Ring packet?
2. If you have an operating frequency of 750 MHz,
what length of a pair f conductors is considered to
be a transmission line?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Design an Ethernet network to connect a single client PC to a single server. Both the client and the server will connect to their respective workgroup switches via UTP. Their workgroup switches are connected directly by a trunk link. The two switches are 900 meters apart. They need to communicate at 800 Mbps. Your design will specify the locations of any switches and the transmission link between the switches. Then add another client next to the first client. This client will also communicate with the server and will also need 800 Mbps in transmission speed. Again, your design will specify the locations of switches and the transmission link between the switches.
800 b frames are sent over a 500 kbps communication channel. The communication channel usesGBN protocol with 3 bit sequence numbers. The propagation delay is 20 ms. Confirmationsare of size 500 b. Headers and control information are negligible in size.What is the maximum efficiency of this channel?
Consider a full-duplex 512 kbps link with length 36,000Km connecting two hosts. The data frames carry a useful payload of size 6000 bits. Assume that both ACK and data frames have 400 bits of header information, and that ACK frames carry no data. The propagation speed along this link is 3×108 m/sec. a) What is the RTT on this link? b) What is the effective useful data throughput, in kbps, when using Stop-and-Wait?
Shielded twisted-pair (STP) cabling was first made popular by IBM when it introduced Type classification for data cabling. Though to purchase and install than UTP, STP offers some distinct advantages. Shielded twisted-pair (STP) cable can up to 600MHZ. STP has an more currently support applications requiring shield that consists of braided . The shield surrounds the 150-ohm, 22 AWG, two-pair conductors. Each is insulated with a to install than UTP. STP cabling solely material and then each twisted pair is individually shielded. STP cabling is because it provides better EMI protection and potential bandwidth, installers consider using fiber-optic cable instead. conductor copper material bandwidth expensive dielectric inner glass Cheap lower Interference expensive WAN higher outer
Suppose you are designing a sliding window protocol for a 1-Mbps point-to-point link to a stationary satellite revolving around the earth at 3 x 104 km altitude. Assuming that each frame carries 1 KB of data, what is the minimum number of bits you need for the sequence number in the following cases? Assume the speed of light is 3 x 108 m/s. (a) RWS=1 (b) RWS=SWS
An 100 Mbps (mega-bit-per-second) is the most popular Ethernet standard. How many bits are in transit during 1 millisecond propagation delay?
In your opinion, compare and discuss the suitability of serial communication protocolsin the following application cases given in the table: