1. For the beam shown in the figure below, draw the influence lines for Ra, Rc, Re, Vd and Md and determine the following maximum responses due to a concentrated live load of "a" kN, a uniformly distributed live load of "b" kN/m, and a uniformly distributed dead load of "c" kN /m. a. Maximum upward reaction at A in kN, put "0" if none. b. Maximum upward reaction at C in kN, put "0" if none. c. Maximum upward reaction at E in kN, put "O" if none. d. Maximum negative shear at D in kN, put "O" if none. e. Maximum positive moment at D in kN-m, put "0" if none. A В E F 2m 2m 4.5m 2.0m 3.0m 1.5m

1. For the beam shown in the figure below, draw the influence lines for Ra, Rc, Re, Vd and Md and determine the following maximum responses due to a concentrated live load of "a" kN, a uniformly distributed live load of "b" kN/m, and a uniformly distributed dead load of "c" kN /m. a. Maximum upward reaction at A in kN, put "0" if none. b. Maximum upward reaction at C in kN, put "0" if none. c. Maximum upward reaction at E in kN, put "O" if none. d. Maximum negative shear at D in kN, put "O" if none. e. Maximum positive moment at D in kN-m, put "0" if none. A В E F 2m 2m 4.5m 2.0m 3.0m 1.5m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1- A 2 m wide rectangular channel (n=0.015), carries a discharge of 6 m³/s. The channel is laid on slope of 0.0162. The channel width and slope changed to 1.5 m and 0.0122, respectively. (a) Calculate critical and normal depths. (b) Calculate Froude numbers. (c) Plot the water surface profile. 2- Sketch and label the type of water surface profile in (a), (b) and (c). (a) (b) (c) TTTTTTTTT L n (Small) n (Large) TTTTTTT NDL NDL CDL NDL CDL NDL MITT
Determine external indeterminacy
I need the answer as soon as possible
I need the answer as soon as possible
If the height of wave = 26.2467 ft, then the minimum depth between the lowest water level and the bottom of the break water= a. 7.99999 m b. 14.99999 m c. 5.99999 m d. None of the given answers e. 11.99999 m f. 6.99999 m
26 kN 7 kN/ m 0.7 m 0.6 m 3 0.8 m | 12 kN/ m 0.4 m
water flows at 12m^/s in a concrete trapezoidal channel n=0.015 bottom width 4m side slopes 2H:1V longitudinal slope = 0.0009.if the depth flow at a gauging station is measured as 0.8m use the direct step method to find the location where the depth is 1.0m
A rectangular channel 9 m wide carries 7.65 m3/s when flowing 0.90 m deep. What is the critical velocity? Select the correct response: 4.15 3.41 2.03 3.87
S1
Determine angle Alpha, Beta and Gamma
Describe the construction process for over-excavation of a building:
4.65. Derive an expression relating the conjugate depths in a hydraulic jump when the slope of the channel is equal to So. [Hint: Assume that the length of the jump is equal to 5y2, and that the shape of the jump between the upstream and downstream depths can be approximated by a trapezoid.]