1. Draw the shear and moment diagram of the beam below using equation method. 6.9 The intensity of the distributed load on the simply supported beam varies lin- early from zero to wo. (a) Derive the equation of the elastic curve. (b) Find the loca- tion of the maximum deflection. Express answer in terms of El. A 6m FIG.P6.9 Wo=14kN/m B X

Q: P02: The beam of Fig. 2 has a simple span of 20 ft and supports a dead load including its own weight…

A: span= 20 ft DL= 1 klfLL = 0.7 klff'c = 3000 psi To find- 1) Instantaneous deflection for D+L2)…

Q: Determine the deflection at midpoint between the supports A and B for the beam loaded as shown in…

A: ##Calculation of deflection at  Mid point of A and B support using Unit load method ####

Q: Question 5 For the cantilever beam and loading shown in Fig. Q5, determine the deflection at B and…

A:

Q: Q. 5 Determine the deflections at B and C for the beam shown in Fig. 5 using the moment- area…

A:

Q: 1 t/m - 3m Fig. 1.112 4mt 6m Fig. 1.113 3t/m (2) Using the double integration method, derive the…

A: EI = Elastic modulus = 5000m 2t The double-integration method of determining the equation of the…

Q: 4. Deflections in Beams A solid, round simply supported steel shaft has a diameter of 38 mm and a…

A:

Q: B.2. Elementary beam theory predicts that the axial bending stress ox in a prismatic beam is given…

A:

Q: Q.3 Determine the slope and deflection at D for the beam shown below by the conjugate beam method.…

A: Calculating the reactions: ∑MA=0RB(6)-4(9)-8(3)=0RB=10 KN∑Fy=0RB+RA=6-4=0RA=2 KN

Q: 1. If the shear at a point 1m from the roller support is equal to -217.65765765766kN, determine the…

A: Moment Area Method: The region under the curvature diagram between two points is adequate to the…

Q: Determine the maximum deflection of the steel beam shown below. E = 200 GPa, /= 60x106 mm4. KAAAAAAA…

A:

Q: Q. Determine the slope at the supports of the beam shown in Fig. I using the double integration…

A: The beam is illustrated as:E = 29000 kips/in.2I = 3500 in.4 For convenience, we will convert the…

Q: Determine the slope and deflection at point B of the steel beam shown. The reactions have been…

A: Consider the free body diagram of the given beam as shown below. Concentrated load, W=5 k Total…

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.