1. Consider a satellite communication link as shown below: 5 LINK EARTH STATION DOWN LINK EARTH STATION (a) Assuming earth station A gain is 25 dB, earth station B gain is 30 dB, satellite gain is 20 dB, and uplink/downlink path loss is 80 dB each,, calculate the path loss (dB) of the entire communication system. (b) Find the received power in dBm, if the input power is: (i) 1W (ii) 5 W.

1. Consider a satellite communication link as shown below: 5 LINK EARTH STATION DOWN LINK EARTH STATION (a) Assuming earth station A gain is 25 dB, earth station B gain is 30 dB, satellite gain is 20 dB, and uplink/downlink path loss is 80 dB each,, calculate the path loss (dB) of the entire communication system. (b) Find the received power in dBm, if the input power is: (i) 1W (ii) 5 W.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

AM channel has single sideband power equal to 10% of the carrier power. The * :modulation index m is
QUESTION 2 if a wireless system goes into outage when the received signal-to-noise ratio below 3 dB. If the maximum outage probability is 2% and noise level is -85dBm, determine the minimum average signal power in dBm.
ExampleUnder clear-sky conditions, the downlink[C/N] is 20 dB, the effective noise temperatureof the receiving system being 400 K. if the rainattenuation is 1.9 dB, calculate the new [C/N].Assume the medium temperature of 290K andthe coupling coefficient is 100%.
Q. No 2. The A.M transmission is used for long distance and video communication instead of F.M. why? Also analyze the effect of noise and environmental conditions (i.e. moister, temperature and geographical terrain) on both modulation schemes and elaborate which modulation scheme will be more affected by noise and environmental conditions? (Your answer should be technical and to the point).
The A.M transmission is used for long distance and video communication instead of F.M. why? Also analyze the effect of noise and environmental conditions (i.e. moister, temperature and geographical terrain) on both modulation schemes and elaborate which modulation scheme will be more affected by noise and environmental conditions? (Your answer should be technical and to the point).
5. What is the relation between carrier frequency of received signal and the intermediate frequency of super-heterodyne receiver.
Problem 2. Suppose for a certain FM system the demodulated SNR is 38 dB with a receiver threshold of 14 dB. The baseband signal has a 5 KHz bandwidth. The noise density level is No = -110 dBW/Hz. a. Determine the FM index, 3. b. What RF bandwidth is needed for transmission for this system. c. Find the required received carrier power level.
6. What is the relation between carrier frequency of received signal and the intermediate frequency of super-heterodyne receiver.
! (asap)