1. Calculate the rate of flow or seepage flow per meter length of the sheet pile at right angle to the cross section shown .K =6.5 x 10-6 m/sec Sheet pile ws 4.3 m 5 m 0.7 m 4 m 10 m Impermeable layer

1. Calculate the rate of flow or seepage flow per meter length of the sheet pile at right angle to the cross section shown .K =6.5 x 10-6 m/sec Sheet pile ws 4.3 m 5 m 0.7 m 4 m 10 m Impermeable layer

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Example A flow net for flow around single row of sheet piles in a permeable soil layer is shown in the figure. Given Sheet pile kx = k = k = 5xl10-3 cm/sec. Determine: 1. How high (above the ground 0 surface) the water will rise if piezometers are placed at points a, b, c, and d. 2. The total rate of seepage II II -4.5 Nr= 3 through the permeable layer per unit width. 3. The rate of seepage through the flow channel II per unit width (perpendicular to the section shown) -9.0 Datum Imnermeahle laver
Flow Nets A single row of sheet piles is driven into a permeable layer as shown in the figure. Given: • Hị = 5.5 m • H2 = 4.4 m Calculate the seepage loss per meter length of the sheet pile (at right angles to the cross section shown). Bear in mind that in the flow net of the system the number of flow channels is Nf = 4 and the number of potential drops is Na = 8. + Sheet pile H H2 D k = 4 × 10-4 cm/sec Impermeable layer Round your final answer to three significant figures. ® m³/ day /m 1.
A flow net for flow around a single row of sheet piles in a permeable soil layer is shown in Figure below with a scale as shown. Given that kx = kz=k = 4 x 10-3 cm/sec, determine How high (above the ground surface) the water will rise if piezometers are placed at points a and b The total rate of seepage through the permeable layer per unit length The approximate average hydraulic gradient at c factor of safety against piping x=1.6 y=2.8
29. Seepage takes place beneath a concrete dam shown below resting on a fine, sandy silty soil having a permeability of 5 X 10-4 cm/s and a saturated unit weight of 19 KN/m3. A sheet pile is also provided at the upstream end of the dam in an attempt to reduce the seepage. Determine the quantity of seepage in m3/day per meter width, the safety factor with respect to piping, and the uplift thrust on the dam. 25 m 6m 1.75 m. 3.5 m 20 m 10 Impervicus stratum Fig 29 - Prob 29
A 20-m-long concrete pile is shown in Figure P9.1. Estimate the ultimate point load Q, by a. Meyerhof's method b. Vesic's method c. Coyle and Castello's method Use m = 600 in Eq. (9.26). 9.1 Concrete pile 460 mm x 460 mm Loose sand di = 30° y = 18.6 kN/m3 20 m Dense sand d'2 = 42° y = 18.5 kN/m3 Figure P9.1
Q-4: The following figure shows the flow net for seepage of water around a single row of sheet piles driven into a permeable layer. Calculate how deep the sheet pile should be driven (h) to achieve factor of safety = 3 against downstream heave, given that ysat for the permeable layer = 18 kN/m3. (Note: Thickness of permeable layer T = 18 m) H₁ = 10 m (h) Heave zone Sheet pile ►||1| Impermeable layer H₂ = 2 m Ysat 18 kN/m³
Problem (3) The flow net for water seepage is shown in the figure below, where the permeable soil layer has a saturated unit weight: %a-17.7 kN/m°. Calculate: a) Seepage force per unit volume Sheet pile H = 3 m Heave zone На 0.5 m Ysat = 17.7 kN/m3 rmeable layer Figure 6.9 Flow net for seepage of water around sheet piles driven into permeable layer
A dam, shown in Figure 5 retains IO m of water. A sheet pile wall (cutoff curtain) on theupstream side, which is used to reduce seepage under the dam, penetrates 7 m into a 20 mthick silty sand stratum. Below the silty sand is a thick deposit of clay. The averagecoefficient of permeability of the silty sand is 2.0 x 10-4 cm/sec. Assume that the siltysand is homogeneous and isotropic.(i) Draw the flow net under the dam.(ii) Calculate the seepage rate, q per meter length of the sheet pile.
3. Consider the sheet pile wall shown below. Assume the water is 20m above the ground surface on the left side of the sheet pile and the wall penetrates 18m below the ground surface. Using the flow net shown below and assuming k=0.05 m/day. Calculate: 1) quantity of water flow in 5 days for each meter length into to page, and 2) the water pressure at point A. 5m B
6.12 For the same dam and the same soil conditions as in Problem 6.11, a 4-meter-long vertical sheet pile is added at the left end of the dam base: (a) Draw the flow net by using N, = 3. (b) Compute the flow rate q under the dam. (c) Compute the water pressures at the heel (A) and toe (B) sections of the base of the dam based on the drawn flow net. 20.0 m z (m) 17.0 12.0 10.0 8.0 4.0 Sandy soil k=0.0035 cm/sec
A flow net for seepage under a sheet pile wall has n₁= 4, n=8 and the permeabilities of the soil in the horizontal and vertical directions are: K₁ = 8 x 10-¹5 m/sec and K₁=2x10-5 m/sec. If the head loss through the soil is 2 m, the quantity of seepage per meter length of the wall will be
1) A 0.5 meter diameter (D) concrete pile is driven into a sand deposit with y moist = 18.7 kN/cubic meter and o= 31 degrees. The water table is very deep. a. Assume Nq = 68.2. b. Assume K= 0.727 (Effective Earth Pressure Coefficient) c. Assume ô (friction of concrete surface to sand) = 24.8 (0.8 Tan 4) ESTIMATE PILE SHAFT ULTIMATE CAPACITY ASSUMING PILE IS 40 METERS LONG USING MEYERHOF'S METHOD. Assume critical depth is 15D. Hint: pile perimeter is 1.571 M