1. At what rate is thermal energy being generated in the 2R-resistor when &=21 V and R 3.0 o?R.2RRSelect one:a. 13.5 Wb. 18.4 WC. 1.5 Wd. 6 We. 24 WOO Shot by Hisense H12

The circuit consisting of multiple resistances is solved by calculating the equivalent resistance of…

Answered: 1. At what rate is thermal energy being…

Science

Physics

1. At what rate is thermal energy being generated in the 2R-resistor when e= 21 V and R 3.0 o? %D R. 2R R ww

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 40P: A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V....

See similar textbooks

Related questions

Q: A current of 10 A flows through an 2 Q resistor. What is the voltage across it? 5 V 40 V 91 V 20 V…

A: Current (I) = 10 A Resistance (R) = 2 ohm

Q: A wire is 1.4 m long and 1.2 mm2 in cross-sectional area. It carries a current of 3.9 A when a 2.9 V…

Q: A student left his V = 9.0 V, P = 7.0 W radio turned on at full volume from 9:00 PM to 2:00 AM. How…

A: Solution: Given Values, Power(P)=7.0 W Voltage(V)=9.0 V It is given that, Full volume from…

Q: E. The conductive tissues of the upper leg can be modeled as a 40-cm-long, 12-cm-diameter cylinder…

A: Solution:-Given thatLength (L)=40 cm=0.4 mdiameter (d)=12 cm=0.12 mResistivity of muscle=13…

Q: Taking R = 2.20 k and E = 190 V in the figure below, E b + R mA 4R 3R 2R d + 28 determine the…

A: R =2.20kohm, ε =190v for loop abca ε = I1R+4R(I1-I2) or ε =5R I1-4RI2 ___________(1) For loop eace…

Concept explainers

Resistivity

Resistivity is a characteristic property of the conductor’s material that measures the extent to which the material opposes the flow of current. It is denoted by the Greek letter “rho”. Electrical resistivity, also known as specific resistance, depends on the nature of the material of the conductor and is unaffected by its dimensions.

Question

1. At what rate is thermal energy being generated in the 2R-resistor when &=
21 V and R 3.0 o?
R.
2R
R
Select one:
a. 13.5 W
b. 18.4 W
C. 1.5 W
d. 6 W
e. 24 W
OO Shot by Hisense H12

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
An all-electric car (not a hybrid) is designed to run from a bank of 12.0-V batteries with total energy storage of age of 2.00 107J. If the electric motor draws 8.00 kW as the car moves at a steady speed of 20.0 m/s. (a) what is the current delivered to the motor? (b) How far can the car travel before it is out of juice"?
In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
Unreasonable Results (a) What current is needed to transmit 1.00 102 MW of power at 10.0kV? (b) Find the resistance of 1.00 km of wire that would cause a 0.0100% power loss. (c) What is the diameter of a 1.00-km-long copper wire having this resistance? (d) What is unreasonable about these results? (e) Which assumptions are unreasonable, or which premises are inconsistent?
How does the resistance for copper and for silicon change with temperature? Why are the behaviors of these two materials different?
Using your understanding of the nature of internal energy and temperature, explain why we might expect the resistance of a solid to increase if its temperature increases.
A Van de Graaff generator (see Fig. 25.23) is operating so that the potential difference between the high-potential electrode and the charging needles at is 15.0 kV. Calculate the power required to drive the belt against electrical forces at an instant when the effective current delivered to the high-potential electrode is 500 A. Figure 25.23 Schematic diagram of a Van de Graaff generator. Charge is transferred to the metal dome at the top by means of a moving belt.
A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V. (a) What average current does the phone draw from its battery? (b) Calculate the energy stored in a fully charged battery if the phone requires charging after 5.00 hours of use.
Unreasonable Results (a) To what temperature must you raise a resistor made of constantan to double its resistance, assuming a constant temperature coefficient of resistivity? (b) To cut it in half? (c) What is unreasonable about these results? (d) Which assumptions are unreasonable, or which premises are inconsistent?
Integrated Concepts (a) What is the cost of heating a hot tub containing 1500 kg of water from 10.0°C to 40.0°C, assuming 75.0% efficiency to account for heat transfer to the surroundings? The cost of electricity is 9 cents/kW h. (b) What current was used by the 220-V AC electric heater, if this took 4.00 h?
Check Your Understanding Handheld calculators often use small solar cells to supply the energy required to complete the calculations needed to complete your next physics exam. The current needed to run your calculator can be as small as 0.30 mA. How long would it take for 1.00 C of charge to flow from the solar cells? Can solar cells be used, instead of batteries, to stall traditional internal combustion engines presently used in most cars and trucks?
A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?