1. Air at a temperature of 300 K flows over one side of a flat plate of width 1 m at a velocity of 20 m/s. The plate has a constant surface temperature of 350 K. Assume Rex, =5×10³. a) What is the velocity boundary layer thickness at the end of the plate if L = 0.25 m? What if L = 1 m? b) Calculate the drag on the plate if L = 0.25 m. What is the drag if L = 1 m? c) Find the heat transfer rate from the plate to the air if L = 0.25 m. What is the heat transfer rate if L = 1 m. d) A small diameter wire is placed at the leading edge of the flat plate. This wire trips the flow, causing it to be turbulent over the entire length of the plate. Repeat the calculations performed in a), b) and c) for this condition.

1. Air at a temperature of 300 K flows over one side of a flat plate of width 1 m at a velocity of 20 m/s. The plate has a constant surface temperature of 350 K. Assume Rex, =5×10³. a) What is the velocity boundary layer thickness at the end of the plate if L = 0.25 m? What if L = 1 m? b) Calculate the drag on the plate if L = 0.25 m. What is the drag if L = 1 m? c) Find the heat transfer rate from the plate to the air if L = 0.25 m. What is the heat transfer rate if L = 1 m. d) A small diameter wire is placed at the leading edge of the flat plate. This wire trips the flow, causing it to be turbulent over the entire length of the plate. Repeat the calculations performed in a), b) and c) for this condition.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

solve 30-40 minutes hand written asap..i'll rate
Please solve, include the diagrams, and do not copy from other bartleby answers. Handwritten solution is more preferred than typed. A 40-mm diameter, 522-mm length shaft is drilled, for a part of its length L1, to a 20 mm diameter and for the remaining length L2 to a 30 mm diameter drill hole. If the allowable shear stress is 86 MPa, find the maximum power that the shaft can transmit at a speed of 226 rev/min. If the angle of twist in the length of 20 mm diameter drill hole is equal to that in the 30 mm diameter drill hole, find the length of the shaft that has been drilled to 20 mm and 30 mm diameter.
please help with solving.student no is 128425. please also draw fbd
PLEASE SOLVE THE PRESSURE AT POINT A AND B
Solve please. Should correct
Show the complete solution with FBD Use 4 decimal places for final answer.
5 The best size wire is fitted in a groove of a metric screw such that the wire touches the flanks of the thread on the pitch line as shown in the figure. The pitch (p) and included angle of the thread are 4 mm and 60°, respectively. The diameter of the best size wire is mm (round off to 2 decimal places). Pitch line Flank 60⁰ Wire 0.25p -0.5p-
The steel shaft with two different diameters rotates at 4.6 Hz. The power supplied to gear C is 47 kW, of which 26 kW is removed by gear B. Find the angle of rotation of gear A relative to gear Cif d = 56.3 mm, h = 66 mm, L = 4 m, M = 2.7 m, and G = 83.13 Gpa. Round off the final answer to two decimal places.
Thanks!
Solve 10 mins plzzzzz....This is the answer only write hand written plz.... I'll give you multiple upvote
Q1
1