1. A student weighs an empty special round bottom flask and stopper. He finds the mass to be 56.972 g. He then adds about 5 mL of an unknown liquid and heats the flask in a boiling water bath at 100°C. He allows all the liquid to vaporized and then removes the flask from the bath, stoppers it, and lets it cool. Upon cooling, he briefly removes the stopper, then replaces it and weighs the flask and condensed vapor, obtaining a mass of 57.917 g. The volume of the flask is known to be 240.2 mL. The barometric pressure in the laboratory that day is 743 mm Hg. What was the pressure of the vapor in the flask in atm? O 0.9776 atm O 0.98 atm 0.978 atm O 0.977 atm

1. A student weighs an empty special round bottom flask and stopper. He finds the mass to be 56.972 g. He then adds about 5 mL of an unknown liquid and heats the flask in a boiling water bath at 100°C. He allows all the liquid to vaporized and then removes the flask from the bath, stoppers it, and lets it cool. Upon cooling, he briefly removes the stopper, then replaces it and weighs the flask and condensed vapor, obtaining a mass of 57.917 g. The volume of the flask is known to be 240.2 mL. The barometric pressure in the laboratory that day is 743 mm Hg. What was the pressure of the vapor in the flask in atm? O 0.9776 atm O 0.98 atm 0.978 atm O 0.977 atm

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A chemist prepares a solution of nickel(1I) chloride (NICI,) by measuring out 1.2 x 10" umol of nickel(1I) chloride into a 250. mL volumetric flask and filling the flask to the mark with water. Calculate the concentration in mmol/L of the chemist's nickel(11) chloride solution, Round your answer to 2 significant digits.
. A sample of an ethanol-water solution has a volume of 52.5 cm³ and a mass of 49.6 g. What is the percentage of ethanol (by mass) in the solution? (Assume that there is no change in volume when the pure compounds are mixed.) The density of ethanol is 0.789 g/cm³ and that of water is 0.998 g/cm³. Percentage of ethanol = b. Alcoholic beverages are rated in proof, which is a measure of the relative amount of ethanol in the beverage. Pure ethanol is exactly 200 proof, a solution that is 50% ethanol by volume is exactly 100 proof. What is the proof of the given ethanol-water solution? proof Submit Answer % [References] Try Another Version 10 item attempts remaining
The mass of acetic acid in a 2.00 mL sample of vinegar (density of the vinegar is 1.00 g/mL) is determined to be 0.233 g. What is the mass % of acetic acid in the vinegar?
Suppose a student measured the mass of a sample that has a known mass of 40.5809 g using an analytical balance. The mass they observed was unstable, constantly jumping between 39.5 and 41.5. Choose all of the following reasons that could cause this error. O The doors to the analytical balance were not closed completely, allowing an air current to circulate inside the balance. One weigh boat was used to tare the balance while a different one was used when the sample was massed. Twice the amount of sample was placed on the analytical balance. O The sample was heated, causing a convective flow.
1. A vial with a mixture of sand and salt is placed on an analytical balance. The mass reads 3.4155 g. Some of this mixture is poured out of the vial into a beaker. The vial with the remaining mixture is then placed on the same balance. Its mass now reads 2.8540 g. What was the mass of the sand and salt mixture transferred?
Suppose you are measuring the mass of a solid sample on a balance using a weigh boat. You record the data in a table. Mass of weigh boat 2.762 g Mass of weigh boat and sample 8.802 g What is the mass of the solid sample (in g)?
For the following reaction, 6.41 grams of hydrochloric acid are mixed with excess oxygen gas. The reaction yields 1.05 grams of water.hydrochloric acid (aq) + oxygen (g) water (l) + chlorine (g)
50.00 ml of sulfuric acid was put in a 250 mL flask. 100 mL of 2.50 mol/L potassium hydroxide was put in a 100 mL graduated cylinder to the fill mark. Using an eye dropper, base was added from the graduated cylinder into the acid until the endpoint was identifed. At this point, 35.5 mL of base remained in the graduated cylinder. Calculate [sulfuric acid].
A salt solution was evaporated on a hot plate. The dish holding the solution had a mass of 238.7564 g. After drying the salt solution, the dish then weighed 241.5823. What is the mass of the dried salt?
A mixture has three components. The percentage of sand was determined to be 37.31 %, the percentage of benzoic acid was determined to be 37.45 %, and the percentage of salt was determined to be 31.69 %. Calculate the total percent recovery. Include the % unit and two decimal places in your answer.
What volume of iron (7.87 g/cm3) would be required to balance a 1.25 cm3 sample of lead (density 11.4 g/cm3) on a two-pan laboratory balance?
A solution is made by mixing 5.40 g of toluene, CH8(1), with 954. mL of chloroform, CHCI3(1). Calculate the concentration of the solute in the solution using the units given below. (Density of = 0.867 g/mL. Density of chloroform = 1.49 g/mL. Assume volumes mix additively.) toluene Enter your answers in decimal form to 3 significant figures. Do not enter units since they are already provided. Molar: molal: m mole fraction: mass percent: %(m/m) percent volume: %(v/v)