1. A single-bolted double-cover butt joint is used to connect two plates which are 8 mm thick. ssuming 16 mm diameter bolts of grade 4.6 and cover plates to be 6 mm thick, calculate the rength and efficiency of the joint , if 4 bolts are provided in the bolt line at a pitch of 45 mm s shown in Figure 1. Also, determine the efficiency of the joint if two lines of bolts with two olts in each line have been arranged to result in a double bolted double cover butt joint.

1. A single-bolted double-cover butt joint is used to connect two plates which are 8 mm thick. ssuming 16 mm diameter bolts of grade 4.6 and cover plates to be 6 mm thick, calculate the rength and efficiency of the joint , if 4 bolts are provided in the bolt line at a pitch of 45 mm s shown in Figure 1. Also, determine the efficiency of the joint if two lines of bolts with two olts in each line have been arranged to result in a double bolted double cover butt joint.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

When are the punch lists needed?
Significance of architectural lettering in technical drawing and engineering drawing?
Construct a diagonal scale and show on it a distance of 1.12 inches.
autocad
Within the specifications,write the order of precedence?
Define GIS.
Examples and explanations of the following coordinate systems are provided. • Object Coordinate system • World Coordinate system • Camera Coordinate system • Screen Coordinate system •.
What is a drawing scale? Why is it important to use in Engineering drawing?
How to use architect (USA), engineer(USA) and metric scales? Task: draw horizontal lines to scales or sizes indicated. 1. Architect scale: a. 4 9"/16 (Full Scale) b. 12 3"/8 (6"=1'-0) c. 21 7"/8 (3"=1'-0) 2. Engineer scale a) 13.4" (half size) b)5.85" (1=1) c) 63.5 ' (1"=10'-0) 3. Metric scale a) 715 mm (1=5) b) 33 cm (Half size)
prepare and submit a 3D isometric projection drawing based on the 2D Multiview object drawing (Top, Front and Right Side View) as given in a full scale. The drawing should include the border line, title block and detail information of the drawing
L Plan 1 Plan 2 Plan 3 Indicate which of the section lines above corresponds to the section drawing shown below:
What is the proper procedure to place a text callout on a detail view? O Use MTEXT command and draw a line with an arrow O Use the MLEADER command O Use the MTEXT command and draw a PLINE