1. A piston rod, made of AISI 3140 steel, OQT 1000 F, is subjected to a repeated, reversed load. The rod is for a 20-in. air compressor, where the maximum pressure is 125 psig. Compute the diameter of the rod using a design factor based on: (a) ultimate strength, 1.62 in 1 5/8 in (b) yield strength. 1.23 in = 1 % in For AISI 3140 steel, OQT 1000 F Su = 152 5. ksi Nu = 8 Sy = 132 5. ksi Ny = 4

Q: Tutorial Sheet Part 1 (Basics) A thin-walled pressure vessel has a diameter of 45mm, a wall…

A:

Q: Consider the steel pressure vessel shown in Figure 1, intended to withstand an internal pressure of…

A: The objective of this question is to use ANSYS Workbench to simulate the performance of a steel…

Q: Using the sample set of readings provided for Experiment 1 and taking the Young's Modulus of steel…

A: i hope its helpfull.thank you.

Q: mechanical design A steel cantilever is 200 mm long is made from AISI 4340 quenched and tempered at…

A: after using scientific calculator The diameter d of the cantilever is approximately 5.2 mm

Q: 1. Determine the diameter size of rods AB, BC and C if ay = 3600 MPa and the safety factor SF= 2.…

A: Determine the diameter size of rods AB, BC and CA, if Yield stress = Sy = 3600 MPa and the safety…

Q: The end plates of a high pressure boiler accumulator are fixed using a number of bolts of M16 × 2-…

A: Any action that can change the state of motion is called force. Force is described by its magnitude,…

Q: An aircraft engine develops 150kW at 1500rpm. The engine output shaft is steel which fails when the…

A:

Q: A 220 kg box is hanging from a steel wire with a Young's modulus of 200 GPa. You have a design…

A:

Q: 1. A cold-drawn AISI 1015 steel tube is 300 mm OD by 200 mm ID and is to be subjected to an external…

A: Given data - Outer diameter - 300 mm Internal diameter - 200 mm Yield strength = 600 Mpa It is asked…

Q: Parvinbhai

A: The objective of the question is to design a suitable column given the load, material, and boundary…

Q: Q 3\A rectangular bar is cut from an AISI 1018 cold-drawn steel flat. The bar is 60 mm wide by 10 mm…

A:

Q: 7. A cylindrical steel bar is subjected to repeated compression-tension stress cycling along its…

A:

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.