1. A hollow steel tube with an inside diameter of 100 mm must carry a tensile load of 400 lb. Determine the outside diameter of the tube if the stress is limited to 12MN/m2

Q: A simplified model of a basketball hoop is shown. During a basket dunk a player hangs from the rim…

A: Given:Force applied by the player (F) = 320 lbsOutside length of the square tube (L) = 5…

Q: PLEASE ANSWER QUICKLY

A: Given data as per question Diameter = 2 in Length of bar =24 in Force = 20000 lb

Q: ach have a 20-mm diameter and happen to be parallel in the position shown. Take P = 900 N.…

A: Stress:- The load operating on the body in the unit area when a body is subject to the limitation…

Q: 3.5 m r= 0.6e-0.08y² y 0.6 m

A:

Q: 1. (50 pts) A beam is fixed on one end and free on the other. It has an open circular cross-section…

A: The objective of the question is to determine the stress state at points A, B, C, D and the maximum…

Q: Three metal rods are firmly attached to the walls and the middle rigid plate. Rod AB is made from…

A: The stress of a bar is the ratio of internal force to cross-sectional area.Mathematically,

Q: Problem 9.38 The steel pipe in (Eigure 1) has an inner diameter of 4.38 in, and an outer diameter of…

A:

Q: The homogenous bar that weighs 5000 lb is supported by a pin at C and a cable that runs from A to B…

A: Given data  Weight (W) = 5000 lb  dimaeter of cable (d) = 0.8 in To determine   Axial stress in the…

Q: 1. A steel rod that is 5.5 feet long, stretches 0.04 inches while under a 2-kip tensile load. a.…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.