1. A cylinder of Radius 30 cm is rolling along the surface with constant speed of 60 cm/sec a. What is the rotational speed of the cylinder about its axis? b. What is the magnitude and direction of the acceleration of the points on it surface. c. what is the velocity of the point at the top of the cylinder at any moment d. what is the velocity of the point of the cylinder which is in contact with the floor at any moment

1. A cylinder of Radius 30 cm is rolling along the surface with constant speed of 60 cm/sec a. What is the rotational speed of the cylinder about its axis? b. What is the magnitude and direction of the acceleration of the points on it surface. c. what is the velocity of the point at the top of the cylinder at any moment d. what is the velocity of the point of the cylinder which is in contact with the floor at any moment

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The air around the spinning baseball in the following figure (top view) experiences a faster speed…

A: Given data:- The given time taken to travel, 18.44 m The given traveling speed in x direction, 40…

Q: A stone weighing 45 N to one end of a cord 0.90 m long. The stone is then whirled in a vertical…

A: Consider the given data Weight of the stone=45 Nlength of the cord=0.90mBreaking strength of the…

Q: (90 + a) km/h 20 Mg 25 Mg A В Figure Q1 (a)

Q: Now the elevator is moving downward with a velocity of v=-2.7 m/s but accelerating upward with an…

A: Step 1:Let mass of the elevator is MVelocity is −2.7m/sUpward acceleration of the elevator is…

Q: f F= 47.6 N and M = 1.8 kg, what is the magnitude of the acceleration of the suspended object? All…

A: F= 47.6 NM= 1.8kgAll surfaces are frictionlessTo find:Magnitude of acceleration

Q: A toboggan approaches a snowy hill moving at 10.1 m/s. The coefficients of static and kinetic…

A: Given Data - v = 10.1 m/s Angle = 45° Static friction coefficient = 0.41 Kinetic friction…

Q: Determine the moment (in ft lb) created by the weight of the traffic light about point O. The…

A: We have the arrangement as:

Q: A plate in the gap between two fixed blocks is being pulled with a constant force of 65.6 N. The…

A: A=2×(L×w)=2×(0.5m×0.5m)=0.5m2

Q: True or false

A: Note:- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: 2. Block A is being pushed up the side of a wall. Kinematics dictates that motion can only be in the…

Q: The 6-ft-radius waterwheel in Fig.P2.149 is being used to lift water with its 1-ft-diameter…

A: Given: The radius of waterwheel is 6 ft. The diameter of half cylinder blades is 1 ft. The…

Q: 2. The container in the figure is 3.5 ft. wide and is filled with crude oil to a height of 4 ft.…

Q: to transport a load from flight altitude to the ground with average vertical speed of 3 m/s. The…

Q: A cylindrical vessel 15 cm diameter and 40 cm long is completely filled with water. The vessel is…

Q: Block B rests upon a smooth surface. If the coefficients of static and kinetic friction between A…

Question

1. A cylinder of Radius 30 cm is rolling along the surface
with constant speed of 60 cm/sec
a. What is the rotational speed of the cylinder about
its axis?
b. What is the magnitude and direction of the
acceleration of the points on it surface.
c. what is the velocity of the point at the top of the
cylinder at any moment
d. what is the velocity of the point of the cylinder
which is in contact with the floor at any moment

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Fluid mechanics
The figure shown is on a fixed frictionless axle. It has a moment of inertia of 1 = 50 kg-m². The forces acting on the object are F₁ = 100 N, F₂ = 200 N, and F3 = 250 N acting at different radii R₁ =60 cm, R₂ = 42 cm, and R3 = 28 cm. Determine the angular acceleration of the object. F F2 R₂ R F3
A box of mass 5 kg is pulled vertically upward by a force of 68 N applied to a rope attached to the box. Determine the rate of acceleration of the box and the vertical velocity of the box atter 2 secs of motion. 3.81 m/s^2, 7.58 m/s O 3.81 m/s*2, 7.82 m/s O 3.79 m/s*2, 7.58 m/s O 3.79 m/s^2, 7.82 m/s
5. In preliminary design studies for a sun- powered car, it is estimated that the mass of the car and driver will be m kg and the torque produced by the engine will result in a F, newton tangential force on the car. Suppose that the car starts from rest on the track at A and is subjected to a constant F, newton tangential force. Determine the magnitude of the car's .newton velocity and the normal component of R m END A START • l m m = 102 kg Figure 5. F. = 120 296 force on the car when it reaches B. .m R = 94 .m
SITUATION. On a frictionless, horizontal air track, a glider oscillates at the end of an ideal spring of force constant. The graph in the figure below shows the acceleration of the glider as a function of time. a (m/s²) 12.0 6.0 t(s) 010 0.20 030 0.40 0 -6.0 -12.0 → Zoom image Find the maximum force the spring exerts on the glider in Newton. O 3.03 2.61 O4.01 O2.05
The ladder and the person weigh 30 lb and 180 Ib, respectively. The center of mass of the 12-ft ladder is at its midpoint. The coefficient of static friction between the ladder and the floor is 0.50. What is the largest value of the angle ALPHA for which the person could climb to the top of the ladder without it slipping? The ladder and the person weigh 30 lb and 180 Ib, respectively. The center of mass of the 12-ft ladder is at its midpoint. The coefficient of static friction between the ladder and the floor is 0.5 and the coefficient of friction between the ladder and the wall is 0.3. What is the largest value of the angle ALPHA for which the person could climb to the top of the ladder without it slipping?
The 28000-1b airplane is flying in the vertical plane at 390 ft/s. At the instant shown, the angle = 30°, and the cartesian components of the plane's acceleration are a = -5 ft/s², ay = 25 ft/s². Figure < 1 of 1 Part A What are the tangential and normal components of the total force acting on the airplane (including its weight)? Enter your answers numerically separated by a comma. Ft, Fn = Submit Part B * Incorrect; Try Again; 4 attempts remaining ■AΣ vec de/dt = Previous Answers Request Answer What is de/dt in degrees per second? (Figure 1) Submit VAZ † vec Request Answer ? ? lb °/s
Question 2: A 40 lb suitcase slides down a 20ft ramp with an initial velocity of va= 10 ft/sec. The coefficient of kinetic friction on the ramp is equal to 0.2. Determine the point where it strikes the ground at C and how long it takes to go from A to C. A/ 20 ft 30 B 4 ft C -R-