1. A crank rocker mechanism has the following link lengths: Lo=47mm, L1=17mm and L2=21mm. If the theoretical transmission angle ranges from 40° to 140 °, determine a. Theoretical Range of L3 b. Value of the link L3 so that pmin= 40⁰ c. Actual pmax d. Value of the link L3 so that omax= 140° e. Actual omin

Q: solve and show every step with right answer

A: Data given - Rectangular cross section 225×75 mm2 Torsional moment = 20kN Axial Compressive force =…

Q: The given frame is subjected to the applied loads P and Q. Note that members ABC and CDE are…

A: Given  To Find: FAF, FBG, FDG,FEH

Q: In Part a, could you please explain where the 4 comes from on the line before the answer.

A:

Q: solve both

A: Power input, Gear speed of input shaft, Gear ratio, Power loss,

Q: Says.003 is wrong

A:

Q: For #16.6 on page 669, do the followings: 1) Draw the top, the front, and the right-side…

A:

Q: The figure shows a shaper machine that uses Whitworth quick return mechanism wherein the different…

A: Given Data OA=75cm OP=50cm CA=150cm CD=135 cm

Q: The hand writing is not very clear :(

A: Basically the miller indices are the set of numbers which define the particular plane in the crystal…

Q: Help , Handwritten only. No Chatgpt

A:

Q: A 2.10kg pole is attached to a wall with a hinge as shown. A 5.80kg sign is suspended at the other…

A: Given data: mp=2.10 kgM=5.8 kgD1=1.3 mD2=3.2 mα=19.0° Need to determine the torque on the pole due…

Q: 4. How many datums are shown on the print? 5. What three symbols are used to describe the small…

A: What there's symbols are used to describe the small hole

Q: 200 m The spool has a mass of 40 kg and a radius of gyration of k-0.65 m. If the 20 kg weight is…

A:

Q: The number of teeth on a gear is 27 and the outside diameter is measured as 10 mm. The module of the…

A: Given Data No. of teeth is 27 Outside diamtere is 10mm

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.