1- There following data are obtained from streamflow measurement in a river cross section. Estimate the average discharge from this cross-section. Distance from the left corner (m) 0 Water depth (m) 0 Flow velocity at 0.2 d (m/s) 0 Flow velocity at 0.8 d (m/s) 0 4 5 9.0 5.38 0.8 0.6 1 2 3 1.35 3.31 5.0 0.6 0.7 0.85 1.0 0.2 0.3 0.5 0.6 6 3.78 0.7 0.4 7 1.78 0.6 0.3

1- There following data are obtained from streamflow measurement in a river cross section. Estimate the average discharge from this cross-section. Distance from the left corner (m) 0 Water depth (m) 0 Flow velocity at 0.2 d (m/s) 0 Flow velocity at 0.8 d (m/s) 0 4 5 9.0 5.38 0.8 0.6 1 2 3 1.35 3.31 5.0 0.6 0.7 0.85 1.0 0.2 0.3 0.5 0.6 6 3.78 0.7 0.4 7 1.78 0.6 0.3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

3. The inflow hydrograph in the table is for flows observed at a river cross-section over two days. Your job is to develop the outflow hydrograph for the next cross-section 3 mi downstream using Muskingum K = 11 hr and X = 0.13. Plot both hydrographs on a single graph. Time (hr) Inflow (cfs) Outflow (cfs) 100 100 6. 300 12 380 18 500 24 400 30 310 230 100 36 42
Question No. 22 The ordinates of a 2-h unit hydrograph at I hour intervals starting from time t = 0, are 0, 3, 8, 6, 3, 2 and 0m³/s. Use trapezoidal rule for numerical integration, if required. A storm of 6.6 cm occurs uniformly over the catchment in 3 hours. If o -index is equal to 2 mm/h and base flow is 5 m³/s, what is the peak flow due to the storm?
Given below are ordinates of hydrograph, separate the base flow from direct runoff flow by using the fixed base method, and then find the unit hydrograph (UH) with all graphics. Note: using basin area 8000 km² Time (day) 0 1 2 3 4 5 6 7 8 9 10 11 12 Flow (m³/s) 200 180 180 220 300 500 450 420 350 300 220 180 160
Route the inflow hydrograph tabulated in the following table through a river reach for which x = 0.2 and K = 2 days for only the first three days. Use a routing period At=1 day and assume I = O for the first day. Time (day) 1 2 3 Inflow (cfs) 4000 7000 11000 :
Given the following data for a stream of uniform flow: A = 8.98 sq.m. (average stream cross section) P = 10.76 m (Wetted perimeter) S = 0.008 (slope of stream bed) n = 0.020 (roughness coefficient). Assuming a constant stream bed slope and little variation in the cross section and condition of the bed, determine the average velocity of the stream using Kutter’s coefficient, and the corresponding discharge.
Q2/ Given below are ordinates of hydrograph, separate the base flow from direct runoff flow by using the fixed base method, and then find the unit hydrograph (UH) with all graphics. Note: using basin area 8000 km? Time (day) Flow (m'/s) 0. 1 3 4 6. 450 7 8 10 11 12 200 180 180 220 300 500 420 350 300 220 180 160
solve fast
A river model is constructed to a horizontal scale of 1: 1000 and vertical scale of 1: 100. If the model discharge were 0.1 m/s, then the discharge in the river (in m3/s) would be:
Problem 1 x=8 A scaled model of a proposed dam is used to predict the flow conditions in the prototype. If the design flood discharge over the spilway is (15000+X00) m/sec, calculate the flowrate that should be established in the model to simulate the flow. Also determine the velocity at the specific point in the prototype, if a velocity of 1.2 m/sec is measured at a corresponding point in the model. Assume the scale ratio as 1:50.
For a two dimensional flow field, the stream function Y is given as Y ²²2 (2²-2² - x²). The magnitude of discharge occurring between the stream lines passing through points (0, 3) and (3, 4) is:
Estimating the flow (discharge) in a stream from measurement with a current meter. the data tabulated below Distance from edge of stream (m) Average Depth (m) 0.2 depth 0.8 depth Velocity (m/sec) 0-2 2-3 3-4 4-5 5-6 6-7 1.3 0.6 0.4 1.7 0.8 2.0 2.2 1.8 1.4 0.6 0.6 0.9 1.1 1.0 0.9 0.7 0.7 0.6 7-9 0.6 0.7 0.4
3 and 4 only thanks!