03: A sample of natural gas from the Texas field has the specific gravity 0.712(air-1), this gas contains nonhydrocarbon compounds (carbon dioxide, nitrogen and hydrogen sulfide) around (1.9,2.45,11.13) mole % respectively. By using appropriate equations find the gas deviation factor at reservoir temperature 215 °F and pressure 2395.30 psig. Component CH4 C₂H6 C3H8 i-C4H10 N₂ CO₂ H₂S 16.043 30.070 44.097 58.124 28.01 44.01 34.08 708 550 Mole Weight Pa psia Tei R 668 343 616 529 666 735 493 1071 227 574 1306 624

Q: I NEED ANSWER FOR C AND E The combustion gases from an industrial furnace using a hydrocarbon fuel…

A: From the given orsat analysis we will obtain the carbon, hydrogen in feed, and water vapor moles in…

Q: A coal source contains 1.1% sulfur by mass. If 2.0 × 10* kg of coal is burned and forms oxides,…

A: Given: mass of coal = 2×104 kg and contain 1.1% sulfur by mass and M.W of sulfur = 32 kg/kmole mass…

Q: Liquid benzene (A) in a laboratory tube with a vapor pressure of 0.20 atm at a temperature of 298 K…

A: Evaporation rate for the system is asked.

Q: A mixture of 100 k mole which contain 70% mole percent n-pentane and 30% n-heptane are vaporized at…

A: Distilling a mixture of n-pentane and n-heptane allows us to separate them based on their boiling…

Q: Q2 A gas mixture is composed of nitrogen (Na), oxygen (O:), and argon (Ar). composition of the gas…

A: Given, molar composition of the gas mixture is 65% nitrogen, 20% oxygen and 15% argon.Molecular…

Q: # 4: What is the amount of energy given up by 300 kgs of ethanol that is initially at a saturated…

A: Given: 300 kg of ethanol ( 1 atm and 78.5 °C) Condensed and subcooled at 15 °C (1 atm) Consider…

Q: The exit gas from a drier in a chemical plant consists of an N2-CS2 mixture (30) containing 3.0…

A: The schematic diagram for the given absorption column is prepared as shown. Given molar flowrate of…

Q: Problem 29-6E. Natural gas from a "fracking" operation containing hydrogen sulfide vapor enters to…

A: A mixture of H2S and CH4 is contacted with a brine solution to separate the H2S from the mixture.

Q: Number 2 A piece of beef steak 5 cm thick will be frozen in the freezer room -25°C. This product…

A:

Q: 2) Benzene-Toluene Separations. We wish to separate benzene from toluene in a sieve-plate…

A: "Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Groundwater contaminated with 1,1,1-trichloroethane (TCA) is to be air-stripped at 25°C and 1.1 bar…

A:

Q: This example illustrates the use of liquid-liquid phase equilibria in material balance calcu-…

A: Assume outlet phases are in equilibrium. The solubilities of the components at 200C are:EDC in…

Q: Question 4-Propane gas (C3H8) is used as a propellant in aerosol cans. a. Calculate the density of…

A: Note: As per our guidelines, we are only allowed to answer first three subparts. To get the…

Q: Give the state of the system, phases present, compositions (more volatile) represented by each…

A: Given the T xy diagram of butane-Pentane System at 1.5 atm .  As pentane is heavier in nature than…

Q: the tube, and the wall temperature is maintained at 55°C. What fraction of the vapour will condense…

A:

Q: The following table shows the boiling pressure of pure acetone at different temperatures: T (°C)…

A:

Q: A total feed of 100 hr kmole having an overall composition of 45 mol % toluene and 55 mol % benzene…

A: Hi, thank you for the question. As there are more than 3 sub-parts, we are allowed to answer only…

Q: Calculate the mass flux (kg/m2-s) for the following tank leaks given that the storage pressure is…

A: Introduction The rate of mass flow is referred to as mass flux in physics and engineering. kg/m2sare…

Q: distillation column

A:

Q: A mixture containing 40 kg A and 60 kg B is contacted with are solvent in a single-stage process.…

A: This is problem of extraction. We are given relative abundance in raffinate and selectivity from…

Q: Consider acetone at 298 K kept in a beaker, which is open to atmosphere. The vapor pressure of…

A: given = T = 298 KP = 30.544 KPa WKT, from ideal gas law C = PRTC = 30.544*1000 Pa(8.314…