02. The member consists of the steel rod AB that is screwed into the end of the bronze rod BC. Find the largest value of P that meets the following design criteria: () the overall length of the member is not to change by more than 3 mm; and (i) the stresses are not to exceed 140 MPa in steel and 120 MPa in bronze. The moduli of elasticity are 200 GPa for steel and 80 GPa for bronze. A 1.0 m Steel SUMMARY OF ANSWERS A = 480 mm? P kN B 3P

Q: The bar 1 consists of an aluminum cover and a brass core. The data is presented in the table.…

A: Please refer explanationExplanation:Step 1: Step 2: Step 3: Step 4:

Q: 2. The tensile link shown is flat, is 5 mm. thick, and carries an axial loac a. Compute the maximum…

A: GIVEN- Axial load (P)=1350 N Thicknesss (t)= 5 mm

Q: 8 ksi, øy = -4 ks The normal stresses at a point in a steel member are ox 10 ksi. Using E = 29 × 10³…

A: Given data in question  Stresses Elasticity modulus  Poissons ratio To find out  Normal strains

Q: When the normal stresses are at their maximum or minimum values, the shear stresses are zero. We can…

A: 1- Yes when normal stresses are maximum or minimum, then at that element shear stress is zero. 2-…

Q: 2- The Tensile stress of AISI 1035 Cold-dra (a) 550 MPa. (b) 500 MPa. (c) 450 MPa.

A: AISI stands for American Iron and Steel Institute- AISI 1035 is a water resistance carbon steel.…

Moments

There are various practical applications of the concept of moments, like a rotation of the crank due to linear motion of the piston, the moment of inertia and its use in designing beams and columns, bending moment concept, torque, twisting moment, etc.