soil ضحهفنيحسوذ 02A 4.576 Kg of a soil with = 20% & G, -2.68 were extracted from a hole at the surface of the soillayer. The hole was then just filled with 3.54 Kg of loose dry sand. If a container with volume =0.0042 m³ filled with 6.57 Kg of the same sand that filled the hole. Find the dry density and thedegree of saturation of the soil.Scanned with CamScanner

Answered: Image /qna-images/answer/12b9d47a-c105-44ca-ae6e-95cfc13abfcd.jpg

02 A 4.576 Kg of a soil with = 20% & G, -2.68 were extracted from a hole at the surface of the soil layer. 0.0042 m³ filled with 6.57 Kg of the same sand that filled the hole. Find the dry density and the degree of saturation of the soil.

02 A 4.576 Kg of a soil with = 20% & G, -2.68 were extracted from a hole at the surface of the soil layer. 0.0042 m³ filled with 6.57 Kg of the same sand that filled the hole. Find the dry density and the degree of saturation of the soil.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter11: Compressibility Of Soil

Section: Chapter Questions

Problem 11.15P

See similar textbooks

Related questions

Q: fc' Mpa 20.1 fy Mpa 335

A: fc' = 20.1 Mpa fy = 335 Mpa

Q: P4-52 Smooth skot g D 4-52. The pin-connected structure of Fig. P4-52 has the 2400-ft-lb monent…

Q: nooth hump produses a drop of 15 cm in the water sur sses and calculate the discharge per unit width…

Q: KN 4m 上 4m 100 t Kat 200

Q: The composite beam shown in the figure is simply supported and carries a total uniform load of 50…

Q: ۱۳ Q2:- Determine the centroid of shaded area the figure below (dimension in cm). x را ے و مستل (…

A: Determine the centroid of shaded area the figure below

Q: Q.3 Determine the internal total and effective stresses at points A, B and C in figuer? G.L A. B…

A: The soil properties at different levels are shown in the above figure. We have to find out the total…

Q: 1. Two tangents converge at an angle of 19°34'49". The second tangent is due east. The distance of…

A: Note : Since you have asked multiple questions, we will solve the first question for you. If you…

Q: The right-angle uniform slender bar AOB has mass m. If friction at the pivot O is neglected,…

Q: Given: A : 290 kN 8: 487KN C: 197KN a ef :v 6:610 い290 Find : x anal y companent For ce A, Resultent…

Q: Problems (1) Determine the stress in each material if the left wall yields 0.6mm Bronze A=2400mm…

A: Given data in questionLoad 120 and 50 kNSpan 600 , 400 and 300 mm of bronze, aluminum and…

Q: 3m EVALUA Sego 777777 4m B C Am ↓ 30KN D E 4m 6 4m 70KN Find GAC: & BD Area tross member = 900mm²…

A: Given and required:

Q: Q2/[A]: A 12 m thick layer of sandy soil overlies an impermeable rock. Ground water level (GWL) is…

Q: Q4-The followings data relate to a pump-out test: Diameter of well = 24 cm Thickness of confined…

Q: e, the organic silt is preconsolidated by rapidly lowering the w e ground surface) and…

Q: If Lo =5 m and Co = 2, the design flexural strength , Mn for W250x58 section of A992M bent about the…

A: Hi! Thank you for the question, As per the honor code, We’ll answer the first question since the…

Q: Q5// For the sand stratum shown in the figure, determine 1. The head loss across each portion of the…

A: Depth of portion 1, Width of portion 1, Depth of portion 2, Width of portion 2, Coefficient of…

Q: Q3A: The foundation soil at the toe a masonry dam has a porosity of 41 percent and a specific…

Q: The cross-sectional dimensions of the beam shown in the figure are a = 4.2 in., b = 5.5 in., d = 4.5…

Q: B. Classify the soils A and B, with the properties as shown below, according to USCS system. %…

A: The soil properties of Soil A and Soil B is given. We have to classify them as per USCS system.

Q: DETERMINE THE maGniTuOE ano DIRE CTIO OF RES ULTANT OF TW0 FORCES 5kN 650 300

A: Given first force P= 5 kN; Second force Q= 4KN Let resultant of these two forces is R which makes…

Q: 5. Field Permeability Testing Calculate the permeability of the soil from a confined aquifer given…

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: A box beam is composed of four planks, each 2 inches by 8 inches, securely spiked together to form…

Q: 250 1. Derive p=0.65+(8,-0.002)- 3 fc' 2. Derive P=0.858, and Pas and Poes 0.850, 8 fc'

A: Please find the below figure

Q: Detarnine the vertical sport B of the coupond (GERBER) becn. Assıune there sapin at C.(Aisrolle the…

Q: The 30-N force P is applied perpendicular to the portion BC of the bent bar. Determine the moment of…

Q: Q4) The exerciser begins with his arm in the relaxed vertical position OA, He then rotates his arm…

A: Force required to elongate band each additional meter is 60 N. We need to calculate moment about O

Q: R=25B 908 dit 25 300 2-49. The 25-lb force R in Fig. of four forces, three of which are shown.…

A: Given a set of four parallel forces and their resultant. The magnitude of three forces is known and…

Q: Q5) If 0= 30°, determine the magnitude of force F so that the resultant couple moment is 100 N.m,…

Q: A bronze bar 3 m long with a cross sectional area of 320 mm' is placed between two rigid walls as…

A: I'll solve only the first question as per Bartleby T and C.

Q: Replace the two forces acting on the bent pipe by a single equivalent force R. Specify the distance…

Q: 3) ỳ + 2ỳ – 3y = 3e¬*

Q: Q2-4 A coarse-sand sample is 15 cm high and has 5.5 cm diameter. It is placed in a constant-head…

A: l = 15 cmd = 5.5 cmh = 40 cmq=40 gt= 6 sec.

Q: Q.5 Draw the flow net for seepage under the structure detailed in the figure below and determine the…

A: Seepage with two sheet piles.To find: Quantity of seepage.

Q: A direct shear test was performed on a 7.5 x 7.5 cm sample of dry sand. It was found that the normal…

A: Direct shear testSample size = 7.5×7.5 cmDry sand Normal force =560NShear force = 280N

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

soil ضحهفنيحسوذ

02
A 4.576 Kg of a soil with = 20% & G, -2.68 were extracted from a hole at the surface of the soil
layer. The hole was then just filled with 3.54 Kg of loose dry sand. If a container with volume =
0.0042 m³ filled with 6.57 Kg of the same sand that filled the hole. Find the dry density and the
degree of saturation of the soil.
Scanned with CamScanner

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data and calculation:

VIEW

Step 2: Final Calculation:

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Correct option
Note: Read the question carefully and give me right solutions according to the question. Phase diagram is mandatory.. Don't miss anything. Thank you
Solve correctly otherwise skip it
Pressure (kN/m²)27 54 107 214 429 214 107 54 Void ratio1.243 1.217 1.144 1.068 0.994 1.001 1.012 1.024 The table above shows results obtained from an oedometer test on a specimen of saturated clay. A layer of this clay 2.5 m thick lies below a 10 m depth of sand, the water table being at the surface. The saturated weight for both soils is 19 kN/m³. A 10-m depth of fill of unit weight of 21 kN/m³ is placed on the sand over an extensive area. If the fill was to be removed some time after the completion of consolidation, what heave (mm) would eventually take place due to swelling of the clay? (0 d.p). Use unit weight of water of 9.8 kN/m3. Use log base 10.
Question attached
The following data were obtained from sand-cone experiment where a volume of a certain soil is replaced with a sand in order to find the density of the soil. Density of sand used in test = 1.3 g/cc Wt. Of soil excavated from the pit = 925 g Wt. of sand filling the pit = 675 g Water content of natural soil = 15% Specific gravity of Solid = 2.7 a) Determine the wet density of the soil in g/cc. b) Determine the dry density of the soil in g/cc. c) What is the porosity of the soil?
Q1/ specimen of the fine-grained soil, 75 mm in diameter and 20 mm thick was tested in an oedometer in a laboratory. At applying pressure (240 kN/m²), the time with dial gauge readings are: Time (min) 0 Settlement (mm) 0 0.25 1 0.22 0.42 4 9 0.6 0.71 16 0.79 36 64 100 0.86 0.91 1.04 d 1- Find Coefficient of consolidation in cm²/s using root time and TV90% = 0.848. Scanned by TapScanner
Q1/ specimen of the fine-grained soil, 75 mm in diameter and 20 mm thick was tested in an oedometer in a laboratory. At applying pressure (240 kN/m²), the time with dial gauge readings are: Time (min) 0 Settlement (mm) 0 0.25 1 0.22 0.42 Vertical pressure (kPa) 15 Settlement (mm) 0.1 Void ratio 1.88 4 0.6 30 0.11 1.87 9 0.71 16 0.79 And the void ratio and settlement for each load increment is shown in the table below. 60 0.21 1.85 120 1.13 1.72 100 1.04 36 64 0.91 0.86 240 2.17 1.57 480 3.15 1.43 1- Find Coefficient of consolidation in cm²/s using root time and TV90% = 0.848. 2- Find Preconsolidation pressure (oc) and compression index (Cc). Scanned by TapScanner
Sand cone equipment is used to perform a field density test on a compacted earth fill. • Soil sample dug from the test hole = 20.60 N • Dry weight of soil sample = 17.92 N Ottawa sand used to fill the hole weighs 16.05 N and is known to have a density of 15.74 kN/m³. Determine the volume of the test hole. Answer:
Please Help me With All Work Shown. I need to learn how to do this please.
The total volume of a soil specimen is 80,000 mm^3 and has a mass of 152 g. the dry mass of the specimen is 122g, and the density of the soil is 2.65 Mg/m^3. Compute the following index properties: (a) e; (b) n; (c) S; (d) ρt; and (e) ρd. Include phase diagrams.
- once answered Correctly will UPVOTE!!