0.15 m³/s through pipe A, while oil of specific gravity 0.8 is forced in at the rate 0.05 m³/s through pipe B, If the liquids are incompressible and form a homogeneous mixture of oil globules in water, what is the average velocity and density of the mixture leaving through pipe C having a diameter of 0.564 m

Q: 3. As shown in the figure below, water at 20°C is flowing through the tubes A and B, then joining…

A: Temperature of water, T=20°C Diameter of tube A, DA=1 mm=1×10-3 m Maximum velocity through tube A,…

Q: A 4 inch Sched 40 steel pipe carries crude oil at 80°C. The crude oil has a dynamic viscosity of 1.2…

A: Given: 4 inch Schedule 40 steel pipe dynamic viscosity μ =1.2 x 10-2 Pa·s density ρ= 680 kg/m3

Q: 5. A Pitot tube in the pipe in which air is flowing is connected to a manometer containing water as…

A: Given that- Manometer difference in water level, x=87.5 mm= 0.0875m Tube coefficient, CP=0.90…

Q: 1. Water is flowing from the inlet to the exit. At the inlet the speed is 20m/s. Calculate (a) the…

A: Given,

Q: The value of the maximum velocity of a fluid flowing inside a circular pile has a value of O A.…

A:

Q: Air is carried through a tube with an inside diameter of 12.7 mm. At a point 145 ft upstream of the…

A: Given that: Initial pressure, P1 =20 psia, Since, 1 psia = 6894.76 Pa Hence, P1 = 20×6894.76 Pa =…

Q: Q3) Water flows through a 10-mm diameter pipe at a flow rate of 1.33×104 m³/s. Find (a) Velocity (V)…

A: As water is flowing through the pipe with a flow rate of Q. Reynold's number is the dimensionless…

Q: Water is flowing through a 30-m-long and 5-cm-diameter horizontal pipe at a rate of 9 L/s. Using…

A:

Q: For a FOPTD process and an IMC controller, show that setting G₊=e^(−θs)leads to a Smithpredictor…

A: The block diagram for a Smith predictor controller is shown below as:

Q: Water flows steadily from an open tank as represented in the diagram below. The elevation (from…

A: Area at point A = 0.048m2 Area at point B =0.0160 m2 elevation at point A =10m elevation at point B=…

Q: A centrifugal exhauster is takin in dry air from a room where the temperature is 60 °F and the…

A: Simple figure for above question Z=1ft pressure change=1.2 in of water Find Temperature of air in…

Q: Water at 20°C is flowing through a tube of diameter 0.010 m at a velocity of 0.10 m/s. a. Calculate…

A: Water is flowing through the tube at 200C. Tube diameter, D=0.010 m velocity of the water through…

Q: As is shown in figure 1, the lower plate moves in the x direction with the velocity of U1, and the…

A:

Q: Consider a uniform flow of a liquid with density and viscosity equal to 760 kg/m³ and 0.05 Pa s past…

A:

Q: A particle 'A' of diameter 10 microns settles in an oil of specific gravity 0.9 and viscosity 10…

A:

Q: The initial free fall of water from a faucet can be thought of as an inviscid flow because friction…

A: Given: The distance between points 1 and 2 is 7 cm i.e. z1 - z2 = 7 cm or 0.07 m The diameter of…

Q: An open container is filled with water up to a depth of 3 meters and above water it is filled with…

A: As per the given information, the tank is filled with oil and water as shown in Figure1.Density of…

Q: Water is flowing inside the pipe shown in the sketch below. A Venturi meter equipped with a…

A: Given thatdp =12 cmdt = 6 cmh =4.5 cm

Q: Derive the velocity profile for system using shell momentum balance. State all your postulate and…

A:

Q: A liquid is flowing from one large tank to another through a 1 in. diameter pipe. The level in tank…

A:

Q: 4. Initially filled with water, a conical reservoir is 24 ft deep and 12 ft across the top. Water…

A: The orifice is a small hole or space in any flowing fluid system. An orifice meter is using to…

Q: 33. Viscous flow in a plunger-M. A tube of diameter D = 2.0 cm and length L = 100 cm is initially…

A: Given data: Diameter of tube = 2 cm Length = 100 cm Density of the fluid = 1 g/cm3 Viscosity of the…

Q: Show illustration of a large, open cylindrical tank is 18ft deep having a radius of 7ft is layered…

A: This is a problem of fluid statics and comprises of three materials:   Mercury Water Oil We will…

Q: A stream of water from a fire hose with a flow rate of 320 gallons per minute and a speed of 35 m/s…

A:

Q: An open container is filled with water up to a depth of 3 meters and above water it is filled with…

A: Oil density = ρ1 = 1500 kg/m3  Depth of oil = Z1 =  1 meter  Water density = ρ2 = 1000  kg/m3…

Q: 15 cm Water Ah = ? 20 cm S=3.0

A: Given Tank have water(top)+liquid(bottom) connected with manometer Specific gravity (S) of liquid=…

Q: Q1/ A distillation Cokumn was designed to purity = 95 wt.% in the top stream from a mixtwre, whigh…

A:

Q: 1. What is the net force acting on a car cruising at a constant velocity of 70 km/h (a) on a level…

A: Given that  constant velocity = 70 km/h  we have to find the net force acting on a car cruising on a…

Q: 3.36 Determine v the velocity V in the pipe if the fluid in the pipe of Fig. 3.15 is: (a)…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: A fluid is placed between two large parallel plates. The distance between the plates is 5 mm. The…

A: a) The momentum flux (or force per unit area) is τfyz=FA=0.5+22.5=1 Pa b) Let V2 be the velocity of…

Q: A Newtonian fluid with a viscosity μ and density ρ, is flowing at a laminar condition through a…

A:

Q: A 1-m deep, open container is filled with an unknown fluid. The absolute pressure of the fluid at…

A: The specific gravity of the fluid is the ratio of the density of the fluid to the density of the…

Q: 1.35 kg is suspended by a A sphere with diameter D = 0.12 m and mass m = jet of air as shown below.…

A: Given data: Diameter of the sphere = 0.12 m Mass of the sphere = 1.35 kg Drag coefficient fro the…

Q: The wastewater treatment process at a polymer plant consists of a longitudinal bio-remediation pond…

A:

Q: In a manufacturing plant, there is a pressurized water tank having an orifice at the bottom with…

A: Given data: Diameter of orifice = 0.1 m Height of tank = 5 m Air pressure above the water level =…

Q: Water at 30°C is being pumped through the annular area of a laboratory scale 1-pass, 1-shell tube…

A: Volumetric flow rate of water = 0.1 m3/s Inside diameter of the shell, d2 = 18.4 cm Outside diameter…

Q: 3. Determine the pressure exerted on the surface of a submarine cruising 175 ft below the free…

A: