0 0.3 0.5 1.0 8 28 46 94.5

Q: If the resistors used for charging and discharging were the same, the charging and discharging…

A:

Q: Assume each diode to be OFF when V₂ ≤ 0.7V and ON when VĎ >0.7V. Find iD1, İD2, İD³, and vō in each…

A: Given:a circuit,when , the diode is off. when , the diode is on. Find:iD1, iD2, iD3 and v0.

Q: R1 D1 R3 D2 6.15kO D3 V3 V1 R2 -15V 10V 79KQ R4 V2 2kQ 5V

A:

Q: An LM317 is connected between two decoupling capacitors. There is a 220ohm resistor between the…

A: Given information about a LM317 regulator IC is Resistance of the resistor connected between the…

Q: Explain the exponential relationship between the charge on capacitor and time during charging or…

A: Explanation of exponential relationship between the charge on capacitor and time during charging or…

Q: 2. Determine the TEC and NEC (Ans. RTH = 9 0; VTH = 8 V; In = 0.89 A) %3D 4A

A:

Q: Q3 (a) Figure Q3(a) shows the circuit diagram diode as a clamper. (i) Name the type of clamper.…

A: 1) this is negative clamper because it will shift the waveform in  downward direction. ii)

Q: Problem 3 The current flowin through a 5 H coil is given by 12e 10t A. Find an expresion for the…

A: Given: Inductor = 5HCurrent = 12e-10t A Find: expression for the voltage, power, and stored energy.…

Q: Linear voltammetry is so called because: The current changes linearly with the potential.…

A: Linear voltammetry is so called because....

Q: Aluminum has a resistivity of 10.6×108 Om at 20°C. What will the resistivity of Aluminum when then…

A:

Q: We want to investigate how the field strength will be with air as dielectric and with steatite. A…

A: Parallel plate capacitor, Line voltage, VL=24 kV. Area of parallel plate A=1 m2. Distance between…

Q: nvestigates and explains in detail the concept of induced current and induced voltage

A: If the wire is then wound into a coil, the magnetic field is greatly intensified producing a static…

Q: Eie15.0V Ri= 5,002 1,00A E2=? 92.00A un 4.00V2 =Rg

A:

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.