.For the following voltage and current phasors, calculate the real power in Watts V = 125 4 8⁰ Vrms 1 = 23 / 48⁰ Arms

Q: a) A sinewave is having a frequency of 100 Hz and instantaneous value of 250 Volts at 1.2 milli…

A:

Q: A 30 60-Hz induction motor runs at 715 rpm at no load and at 670 rpm at full load. The slip-torque…

A:

Q: 12. Determine @ for the circuit in Figure 16-62. ► FIGURE 16-62 V₁ 3.0/0° V R www 47 Q 60 Hz Hell L…

A: 12.The given circuit isWe need to determine the value of θ for the circuit.

Q: Geometric Mean Radius (GMR)

A:

Q: Three wires are parallel and carry constant currents as shown below. What is the net magnetic force…

A: In the question, currents are flowing in 3 parallel wires as shown in the figure.  Find the force on…

Q: 2. Show that a rfo/Q for a parallel RLC resonance cir 4 R ww CA

A:

Q: SOLVE C. A school classroom with the general dimensions of 20 x 30 feet is lighted with 10…

A:

Q: Exercise 12 Minimize the expression f-Em(0,2,3,4,5,6) using K-map and implement it in AOI logic as…

A:

Q: Calculate the voltage across the dependent source.

A:

Q: R, = 20 2 En= las R = 20 2 V En R, = 10 2 V R, = 10 2 A %3D En, V=100V R, = 5 à V R, = 15 2 V En R,…

A: When two resistors R1 and R2 are connected in series. their equivalent resistance is Req = R1 + R2…

Q: 7. Determine V1 in the network shown below (Mesh analysis) 50 N 20 2 20 2 5 A 0.4V1 0.01 V,

A: Given circuit, Applying mesh current, I1, I2 and I3

Q: Qi Find Fcwl for the fullowing function using differentiatioa praperty >t 7.

A:

Q: 48V + 20k ww + 2Vx + I + V₂ 10k 10k www + 12V Determine V₁

A: To solve the following circuit we will use thevenin theorem.

Q: A- A 10 kHz signal wanted to be sent and encrypted using FHSS with a factor of 10, if Af-5KHz…

A: FHSS stands for Frequency Hopping spread spectrum. It is a wireless communication technique where…

Q: +V;- +4.2V- R, R2 Determine V, E, 16V Ez 9V

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: the output terminsls, calculate the values of IL, ILs, and IL. 1á. The current I = 15/-30° when E =…

A: Given,  E1 = 120<10° V I1 = 15<(-30°) A E2 = 110<40° V I2 = ?

Q: QUESTION 12 In an RL parallel circuit, ET = 120 V, R = 15 ohms, and X L= 20 ohms. What is the power…

A: Answer 12:  Given that R= 15 ohm XL= 20 ohm

Q: Q2) A generator is connected to a constant voltage bus through an external reactance of 0.3 per unit…

A: In this question we need to find the critical angle and critical time for the given system

Q: A: A single core cable covered by the lead, if the radius of the cadactor is r and the insulator…

A: Cross Section of Underground Cable: Given:Single Core Cable covered by Lead Radius of conductor =…

Q: In a double sideband amplitude modulation with suppressed carrier (DSB-SC AM) system, the carrier is…

A: NOTE : “Since you have posted a question with multiple sub-parts, we will solve first three…

Q: Q1 (b). For a unity feedback system with G(S) = S(S²+4 i center & angle of asymptotes breakaway &…

A:

Q: 1. The current density J 5ay A/m2 for z| 2 m. (b) Repeat part (a) for 0 2 m assuming Vm 0 at P(0,…

A: c)Determine Vm for z>2 m assuming Vm=0 at P(0,0,2). d)Determine A for 0<z<2m assuming A=0…

Q: Use Mesh analysis to calculate Vo. 32 ww 22 2i, 16 V

A:

Q: 12. Noise generated by an amplifier of radio is an example for? a) Discrete signal b) Deterministic…

A: Noise generated by an amplifier of radio is an example for

Q: The op amp in the inverting amplifier circuit has the following typical parameters: AOL = 2 x 104,…

A:

Q: Determine v, for each network of Fig. 2.176 for the input shown OW Si 20 V 100 k2 -20 V FIG. 2.176…

A:

Q: An inductive load is controlled by an impulse commutation chopper in Fig.1 and peak load current…

A: “Since you have posted question with multiple sub parts,we will provide the solution only to the…

Q: Refer to the circuit below, Solving the values of IA and Ig involves which method/s?

A: Solving electrical circuits typically involves using a combination of circuit laws and techniques,…

Q: 12.solve

A: The solution is provided in the following section:

Q: admittance Hybird paramter(h).

A: The solution can be achieved as follows.

Q: (i) Describe the working of a single-phase series inverter with appropriate circuit and waveforms…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: 1. Consider the following Laplace Transform s+2 X(s) s2 + 7s + 12 (a) List all possible ROCS. (b)…

A: Given transfer function: (a) To determine the possible ROCs The transfer function can be written…

Q: 12. Three basic modes of operation of SCR not includes: * Reverse blocking Reverse conduction…

A: SCR is three terminal devices i.e. Gate, anode and cathod. Number of junction in SCR is 3 and number…

Q: Calculate the node voltages in Fig. 9. show the value of each node voltages. - 8A - 3A 3'u 4U 20…

A:

Q: The amplifier circuit to be used is the one shown in Figure 1. Size the components to obtain a gain…

A: The ac circuit is given as Now the small signal modeling of the amplifier will be

Q: Could you help me with this one please, thank you.

A: Given: A periodic signal,  To find: Fourier series coefficient of the above signal.

Q: R(s) + 6₁ = S G₁ G₂ H₁ for G3 G5 G4 G₂ = 25 G3 = S 2 H₁ = G3 G3 S G4= C(s) 2 G4=25+2 G5 = 4

A:

Q: For the following circuit, find Vo a. 18.6V b. 19.6V c. 19.3V d. None 20V Si www 1k 2k Ge Si www Vo…

A:

Q: SOLVE B. A hall 30 m long and 12 m wide is to be illuminated and the illumination required is 50…

A: The following data is given in the question  Area of the room =30*12 =360 meter square Illumination…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.