.A soil sample from the construction in its natural state has a wet density of 155.i pcf and a moisture content of 36 percent. After compaction, its maximum dry density is 118.5 pcf. Determine the percent compaction of the soil. Let Gs = 2.65

.A soil sample from the construction in its natural state has a wet density of 155.i pcf and a moisture content of 36 percent. After compaction, its maximum dry density is 118.5 pcf. Determine the percent compaction of the soil. Let Gs = 2.65

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A Standard Proctor compaction test performed on a sample of crushed limestone (G; = 15.70) obtained…

Q: A structure is built on a normally consolidated clay of thickness of H(m), where H is the last digit…

A: Given: H = 10m Natural moisture content of clay = 45% Liquid limit of clay = 50% Depth of sand layer…

Q: Answer 4.3

Q: EXERCICE 3 Classify the following soil using the Unified Soil Classification (ASTM standard).…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: (3) A certain soil (Gs = 2.65) was used in an earth work. When the soil was placed in the site, its…

A: Gs = 2.65 = 1.6 g/cm3 or 1600 kg/m3 or 1920 kg/m3 OMC = 18% or 0.18

Q: Problem 14. The plastic limit and liquid limit of a soil are 36% and 54% respectively. The…

Q: 10. The results of a Standard Proctoretest is tabulated as follows: (SEE PICTURE) Determine the…

Q: A clayey sand (SC) was compacted into a 1/30th cubic foot cylindrical Proctor steel mold with the…

A: Given:Volume of the mold (V) = 1/30 ft3 Weight of dry soil (Wd) = 4.18 lbWeight of wet soil (W) =…

Q: For a granular soil, the following are given:●● Gs = 2.6●● Liquid limit on the fraction passing No.…

A: Determine the maximum dry density (ρd(max)) using the formula,…

Q: The maximum and minimum dry unit weights of a sand were determined in the laboratory to be 16.9 kN/m…

Q: end of compaction, the in-place void ratio was found to be 0.70. If the moisture content of the soil…

A: We will use formula of void ratio.

Q: 3. The coefficient of permeability of a soil A. Increases with a increase in temperature B.…

A: Permeability is inversely proportional to viscosity . Viscosity is inversely proportional to…

Q: is placed in the rain. During the rain the volume of the sample rem but the degree of saturation…

Q: 4. Sand cone equipment is used to perform a field density test on a compacted earth fill. Soil…

A: Given, Wfield = 20.60 lb Wd,field = 17.92 lb ρsand = 15.74 kN/m3

Q: Problem G A saturated 110 cu.cm clay sample has a natural water content of 29.85%. It is found that…

Q: The ff are results of a field unit weight determination test Volume hole 0.0016 Mass of moist soil…

Q: A saturated 100 cm³ clay sample has a natural water content of 30%. It is found that the shrinkage…

Q: The following are the data of the compaction test: Volume of mold = 0.000945 m^3 Determine the…

A: Calculation of water content water content=wwws

Q: The Atterberg limits of a clay soil are: Liquid limit = 75%; Plastic limit = 45%; and Shrinkage…

Q: 9. A cubic meter of a saturatod, normally consolidated clay has a dry mass of 4 kg and a porosity of…

Q: The laboratory compaction test of a certain type of soil gives a maximum dry density of 1.486 g/cc…

Q: The dry unit weight of a soil is ya = 17.5 kN/m, the specific gravity is G, = 2.68 and the degree of…

A: Given data : Dry unit weight (γDry)=17.5 KN/m3Unit weight of water (γW)=9.81 KN/m3Degree of…

Q: How do i solve problem 6.4 a & b

A: The given data is shown below:

Q: The volume of the soil measured before drying is 120cc. The moist soil is 215g and dried weight is…

Q: shrinkage limit test for a saturated specimen had the initial volume Vi = 21.35 cm3 and initial…

Q: The field unit wt of the soil sample is 1960 kg/m and the unit wt of the soil particle is 2700…

A: Given, Unit Weight of soil= 1960 kg/m³ Unit Weight of soil solids = 2700kg/m³ eMax= 0.69 eemin= 0.44…

Q: Classify the following soil using the Unified Soil Classification (ASTM standard). Percentage…

A: Given:- The percentage of soil passing No. 4 sieve = 98 The percentage of soil passing No. 10 sieve…

Q: A standard compaction test was carried out in a mould of volume 0.001 m³1. Test results ar tabulated…

A: V = 0.001 m3Gs = 2.67

Q: The relative compaction of a sand in the field is 94%. The maximum and minimum dry unit weights of…

Q: The laboratory compaction test of a certain type of soil gives a maximum dry density of 1.486 g/cc'…

A: Given:- The laboratory compaction test of a certain type of soil gives a maximum dry density of…

Q: In its natural state the soil in a borrow pit, the total (moist) unit weight is 120 lb/ft³, and the…

Q: SITUATION: It is known that the natural soil at a construction site has a void ratio of 1.0. At the…

Q: 2. A saturated soil has the following characteristics: Initial Volume = 21 cc Final Volume = 16 cc…

A: Given data A saturated soil has the following characteristics: Initial Volume (V 1 )= 21cc Final…

Q: A Standard Proctor compaction test performed on a sample of crushed limestone (G; = 9.70) obtained a…

Q: Problem B: For questions 8 to 11. A cubicmeterof soil in its natural state is 18.907 KN.…

A: Using relationships

Q: compaction test of a certain type of soil

A: Field unit weight of soil is = weight / volume. Volume = 0.001337 cubic meter = 1337 cubic…

Q: Modified Proctor compaction test results for excavated soil at a construction site indicated that…

A: Solution:

Q: Mass of soil (kg) Moisture content (%) 1.791 8.4 1.937 10.6 2.038 12.9 2.050 14.4 2.022 16.6 1.985…

A: Maximum dry density : A style of residence that includes measures of strength, density, durability,…

Q: The coefficient of gradation for certain soil is 4. Given that is D10 and D30 is 0.045 mm and 0.210…

Q: A sample of saturated soft clay has a moisture content of w. The specific weight of solids é y, em…

A: Use formulas for density and porosity.

Q: Find the void ratio, porosity, degree of saturation, total density of soil sample has volume of 100…

A: step 1-

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 75 mm diameter and 150 mm high clay specimen has a mass of 1392.5 g. When it is dried, the mass becomes 1196.5 g. Find the degree of saturation in the specimen, assuming the specific gravity of the soil grains is 2.70. Show handwritten solution.
The laboratory compaction test of a certain type of soil gives a max dry density of 1.486 gm/cu.cm with an optimum water content of 12.5%. The ff are the results of a field density test using sand code equipment: Volume of soil excavated from the hole= 0.001337 cu.m. Weight of wet soil from the hole- 2220 grams Weight of soil after oven drying= 1890 grams a. Determine the field unit weight of the soil in gm/cu.cm. b. Find the water content of soil. c. What is the relative compaction?
A sample of fully saturated clay weighs 2.98 pounds in its natural state and 2.15 poundsafter drying. Determine the following:a. Natural water contentb. Void ratioc. Porosityd. Moist densitye. Dry density (Hand written please)
A modified Proctor compaction test was carried out using a cylindrical moldwith a 1000 ml volume. Table 2 summarizes the results.a. Plot the compaction and ZAV curves (RD=2.75 and ρwater=1000 kg/m3).b. Determine the maximum dry density and the optimum moisture content.
A field sand cone test is performed on a layer of compacted fill. determined that the fill soil has a maximum dry unit weight of approximately 120 pcf. Determine the relative compaction of the compacted fill. Unit weight of dry uniform of sand: 95 pcf Weight of sand to fill the cone: 1.10 lb weight of jar + cone + sand (before test): 16.5 lb Weight of jar + cone + sand (after test): 10.5 lb Weight of moist soil excavated from hole: 6.60 lb Moisture content of soil from hole: 10 %
9. The field unit weight of the soil sample is 1960 kg/m³, and the unit weight of the soil particle is 2700 kg/m³. If emax=0.69 and emin = 0.44. a) Compute the dry unit weight if the water content is 11% b) Compute the void ratio of the soil sample. c) Compute the relative density of the soil sample.
Q2) Classify a soil using USCS from the following information: 75% of the material is retained on the sieve No.200. less than of the percent above and more than 50%, is passing on the sieve No.4. L.L. 35% and P.L.= 29% D10 0.18mm, D30 = 0.88mm, and D60 = 1.12mm d)
.
15. The relative compaction of a sand in the field is 94%. The max and min dry unit weights of the sand are 16.2 kN/m³ and 14.9 kN/m³, respectively. a. Compute the dry unit weight in the field. b. For field conditions, compute the relative density of compaction.
a. The moisture content of the soil specimen is 20%, and the total weight is 300 gr. Calculate the void ratio and degree of saturation if the total volume was 180 cm3. (Gs = 2.5) b. A soil layer with a moisture content of 10 percent and a unit weight of 16.5 KN per cubic meter has a decrease in volume by 10 percent after compaction. Find the dry specific weight of the soil.
A modified Proctor compaction test was carried out using a cylindrical moldwith a 1000 ml volume. Table 2 summarizes the results. a. Plot the compaction and ZAV curves (RD=2.75 and ρwater=1000 kg/m3)b. Determine the maximum dry density and the optimum moisture content Table 2 Moisture Content (%)Mass of WetSample (g)10.5 2033.211.8 2146.613.0 2203.514.9 2183.116.4 2147.617.6 2116.8