Please answer number 7 6. In an experiment the following fluids are poured into a container:Olive oil (911 kg/m³); Corn Syrup (1370kg/m³); Water (1000 kg/m³); Gasoline (711 kg/m³).The result found that the liquids stayed on top of each other the following order from to bottom: Gasoline, OliveOil, Water, Corn SyrupWhat conclusion can we derive from the said experiment? (-7. What happens when you apply current through an inductor?

7.We know that when we apply current through the resistor, It opposes the flow of electrons through…

Answered: . What happens when you apply current…

Engineering

Electrical Engineering

. What happens when you apply current through an inductor?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What are the steps for plotting points on microstation uisng offset, station, side and elevation?

A: We need to tell about steps for plotting points on microstation uisng offset, station, side and…

Q: Flag question Time period of voltage waveform(household power supply) in Sultanate of Oman is…

A: Oman country using 50 hz supply frequency

Q: 2. A facility manager replaces all the TS lights in an office when they have reached 80% of their…

A: Group re-lamping: It is process in which all the old lights are replaced by new ones on…

Q: Fire due to faulty equipment's will result in emission of Answer:

A: According to the given question, it is required to determine that what will result in the emissions…

Q: mostly don't know how to do question (d) and (e)

Q: Define the unit step function and the shifted unit step function. Need

A: The unit step function and its shifted counterpart has been defied in the following section.

Q: What is the FOA ratings in MVA

Q: Define the unit step function and the shifted unit step function. Need correct solution within 20…

A: The unit step function and the shifted unit step function have been defined in the following…

Q: resistor

A: Note- “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: solution!) If Ibc is equal to 353.338∠146 and Ia is 204∠56, Ica should be

Q: Draw the block diagram for the light pupil system using close loop system

A: The block diagram for the light pupil is drawn below:

Q: A luminaire installed no less than 7.5 feet above the floor in a patient care area does not have to…

A: Given statement: A luminaire installed no less than 7.5 feet above the floor in a patient care area…

Q: Sent Mail - fatimaoctober09eg x + Vw/0/Bsearch/akm/FMfcgzGmthgmlPbPzrGgcwkqLIvFcbSF?projector=1 O…

Q: A luminaire installed no less than 7.5 feet above the floor in a patient care area does n have to be…

A: The answer as given below:

Q: the amount of current that the circuit breaker can interrupt without damaging itself electrically…

A: Short circuit limit of CB :- It is the ability of the circuit breaker to withstand 85% to 90% of…

Q: what is vehicle servicing

A: A motor vehicle service or tune-up is a series of maintenance procedures carried out at a set time…

Q: 4. Determine the failure rate of a repairable item if its failure rate to first failure is A=0,002…

A: Given Failure rate and mean time to restore,we need to determine the failure rate of repairable…

Q: DIRECTION. write the appropriate answer from the parenthesis that will complete the idea about light…

A: 1..>> The speed of light is 3*108 m/sec 2..>> Specular reflection 3..>> Angle…

Q: Please answer in typing format

A: The Peltier effect is the result when electric current is passed between two materials,such that it…

Q: Discuss the arcing phenomenon in a circuit breaker. Please write more answer

A: Phenomenon of Arc :- A Circuit breaker consists of two contacts namely "fixed" and "moving contacts"…

Q: Underground cables are least affected by lightning. Select one: O True False

A: Underground cables are least affected by lightning .

Q: -6) Solid grounding is used for voltages

A: Solid is used for the voltages below:

Q: 0.048L 0.2728 0.32 0.08503 9A 4.7 2.80A Radio 20. 4.20V(* Battery Wind Solar Panel Repeator…

A: A thevenins equivalent circuit is used for solving complicated circuits, by converting the voltage…

Q: write paragraph about how to concat and installation circuit breaker with socket ,what is…

Q: write with technical material, digrams and pictures about Domestic electrical installation system

A: Domestic electrical installation system:

Q: Hi can you give me an answer about What is the difference between Primary and Secondary Lighting?

A: As per the rules we can answer only one question, please post the remaining questions as the…

Q: IS it a requirement to have a light ixture outside the garage door for a vehicle? O No Yes For two…

Q: Define the unit step function and the shifted unit step function. Need

A: The solution is provided in the following section.

Q: 24. Which of the following is not one of the technical reasons for grounding the starpoint ? a)…

A: According to question: For Limiting inductive interference between power and communication…

Q: Only correct answer with diagrams

A: Given Data:A stranded conductor with,Side of the reference pentagon Number of strands n=5To…

Q: Choose the correct Answer: In the TIA 568-B wiring standard, the colors white green and blue have…

A: In the TIA 568-B wiring standard, The pin has following color Pin 1: White/OrangePin 2:…

Q: Problem 1 is a review of your understanding of KVL (Kirchhoff's voltage law) Using KVL find the…

A: A simple question based on network analysis and the topics described in the solution are kirchoff's…

Q: 7- What is the uses of circuit breaker?

A: Step-1-> A circuit breaker is an electrical safety device designed to protect an electrical…

Q: Draw a schematic diagram for closed circuit

A: In this question , we will draw a schematic diagram for closed circuit....

Q: A 636 kcmil 26/2 ACSR conductor has a GMR of _____ inch at 60 Hz. (Round-off answer in 3 decimal…

A: The GMR or Geometric Mean Radius of a conductor is an important parameter used in calculating its…

Q: 8. A larger time delay has been provided with over-voltage protection compared to the under-voltage…

A: Time delays are used to control the flow of power in different parts of the system and by…

Q: explain outdoor substation

A: Outdoor substations: Outdoor substations are substations that handle all voltage ranges from 55 KV…

Q: The installation of plenum certified cabling above the ceiling tile is necessary because.

A: The installation of plenum certified cabling above the ceiling tile is necessary for fire safety…

Q: Draw one example of each short circuit and open circuit.

A: To Draw one example of each short circuit and open circuit.

Q: The nec requires that the disconnecting means for central heating equipment other than Fixed…

A: Article 422 of National electric code (NEC) have rules and regulation of using central heating…

Q: Two 36 cell PV modules are connected in series. One is shaded and the other is fully illuminated,…

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

Please answer number 7

6. In an experiment the following fluids are poured into a container:
Olive oil (911 kg/m³); Corn Syrup (1370kg/m³); Water (1000 kg/m³); Gasoline (711 kg/m³).
The result found that the liquids stayed on top of each other the following order from to bottom: Gasoline, Olive
Oil, Water, Corn Syrup
What conclusion can we derive from the said experiment? (-
7. What happens when you apply current through an inductor?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Using group revamping all lamps are usually replaced when they have reached what percentage of rated life expectancy
What is the minimum height of electrical service entrance
Define the unit step function and the shifted unit step function. Need correct solution within 20 mins. Posted multiple times, still not a single correct response. Please Help.
Hello, I am doing some practice and I am getting hung up on my cross product derivation. I know it is supposed to be zero, but I want to prove it with the math. Could you help me out with this? Thank you for your time and effort, I appreciate the help. Please see attached for probelm.
Tubular strip lights is an best example for |type lamp.
The voltage drop is as we proceed from the supply end to the consumer points
Please answer ASAP for like this please Asap for like this please... Please
Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…
Direction: Must carefully read the direction. You must Answer no.1 to no. 5. Identification only which the appropriate/correct answer is in the parenthesis. Choose correct answer in parenthesis in each question. No need to explain each answer. Provide a correct answer to each question. Zoom in the picture in order to see it clearly. Thank you in advance.
can you do question iii please?
Hello. Attached is a practice problem I am working on. I am super confused on how to get started and not sure how to complete the problem. Could you help me through it? Thank you. I appreciate your time.
Answer ONLY the items in number 07. Circuit Diagram is given below. Thanks!!!NOTE: I only included number 5 question because it has connection to number 7.