. Two identical cylinders are applied in series as shown in Fig.2. The cylinder piston and rod diameters are 80 mm and 40 mm respectively. The valve is working in position 2. Assuming the tank pressure is 1Bar. . In order to lift the mass 3000 kg in velocity of 0.1m/s, how much pressure in MPa are needed from the motor? • How much volume in liter/min are needed from the motor?

Q: 3) The piston on a single stroke compressor is 4" in diameter and has a stroke of 3.75". When it…

A:

Q: A frictionless piston fitted inside a cylinder containing gas at a pressure of 200 kPa, volume of 1…

A:

Q: Problem 2. A garden hose with an attached nozzle is used to fill a container with water. The nozzle…

A:

Q: Suppose the master cylinder in a hydraulic system is at a greater height than the slave cylinder.…

A: Understand that the pressure is defined as the ratio of the force applied to the cross-sectional…

Q: Provide one question and its solution involving an external flow of fluid .

A:

Q: 1.) A hand pump is used to inflate a bicycle tire to a gauge pressure of 70 psi. a) How much work…

A:

Q: In figure below, water enters at point A and leaves at point C. The process is steady state. The…

A: Draw the free body diagram for the fluid and the pipe at joint A as:

Q: Problem 4. A nuclear power station produces 800 MW of useful energy, with an efficiency of 32%.…

A: Given Data    Power P=800mw  η=32 % ∆T: 8.3°C  no. of pipes =5 v=1.8 m/s To find  1) Q in m3/s  2) D…

Q: Q.3 Briefly explain why it is necessary for gases to flow in and out of a cylinder with minimum…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A tank initially holding 90 gal of fluid with 30 lb of salt has two sources of fluid being pumped…

A: Let V be the volume of the tank. Write the expression for change in volume of the tank.…

Q: A syringe (X), forces air, at a high velocity, over a straw (Y). The air in the water chamber (Z) is…

A: Solution is attached below

Q: 2. Some of the first power-generating wind turbines were small, having blades with a radius of 8.00…

A: Given data: -  The blade radius of the small wind turbine is r = 8.00 m. The large radius of the…

Q: The pressure at an opening in the side of a tank of water is 40 lb/in^2 greater than atmospheric…

A: Given:Pressure at the opening in the side tank, P=40 psi

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.