PRACTICE ITSuppose a block with mass 2.00 kg isresting on a ramp. If the coefficient of static friction between the block and the ramp is 0.370, whatmaximum angle can the ramp make with the horizontal before the block starts to slip down?EXERCISEHINTS:GETTING STARTED I I'M STUCK!Use the values from PRACTICE IT to help you work this exercise. The ramp in the figure is roughed up andthe experiment repeated.(a) What is the new coefficient of static friction if the maximum angle turns out to be 33.9°?(b) Find the magnitude of the maximum static friction force that acts on the block.

A force of friction acts between an object and the surface this object is placed on, when the object…

Answered: ". Suppose a block with mass 2.00 kg is…

Similar questions

(a) Calculate the tension (in N) in a vertical strand of spiderweb if a spider of mass 8.00 x 10¯° kg hangs motionless on it. (Enter a number.) 0.000784 N (b) Calculate the tension (in N) in a horizontal strand of spiderweb if the same spider sits motionless in the middle of it much like the tightrope walker in the figure. 5.0° 5.0° T. TR w T. TR The strand sags at an angle of 15.0° below the horizontal. (Enter a number.) 0.046688914 X N Compare this with the tension in the vertical strand (find their ratio). (Enter a number.) (tension in horizontal strand) / (tension in vertical strand) =
A crate of mass 17.0 kg rests on a level surface. If the coefficient of kinetic friction between the crate and surface is 0.440, calculate the following. edi ume (a) Calculate the normal force. (Give the magnitude.) (b) Calculate the magnitude of the kinetic friction force when a horizontal applied force of 91.0 N moves the crate. (c) Calculate the normal force when the 91.0-N applied force is exerted at an angle of 32.5 above the horizontal. (Give the magnitude.) (d) Calculate the magnitude of the kinetic friction force when the 91.0-N applied force is exerted at an angle of 32.5 above the horizontal.
The block in the figure below has a mass of 5.9 kg and it rests on an incline of angle 0. m 07 You pull on the rope with a force F = 38 N. Assume the incline is smooth and determine the angle of the incline if th moves with constant speed.
An elevator is supported by a cable and moving downward through the elevator shaft at a constant speed. How does the upward tension force compare to the downward force of gravity? O The upward tension force is stronger than the downward force of gravity. The downward force of gravity is stronger than the upward tension force. The tension force and the force of gravity are of equal strength.
Suppose you have a stack of 17 identical steel bars (steel bars have a mass of 1.00kg each). You are required to pull out bar number 16 from the stack (counting from the top of the stack down). Assuming that your assistant holds all other bars in place. If the coefficient of friction between steel and steel is 0.750, how hard do you have to pull (in N)?
Two boxes are stacked as shown in the diagram below. The bottom box has a mass of 3.5 kg and the top box has amass of 1.5 kg. They are pushed up a ramp inclined at 15° by an applied force of 25 N, applied to the lower boxand directed parallel to the ramp. The coefficient of kinetic friction between the ramp and the bottom box is 0.12.Determine the minimum coefficient of static friction required to keep the top box in place on the bottom box.
3. The force F required to move a box by pulling on an attached rope that forms an angle w with the horizontal is given by fmg F(w) = cOSw + f sin w where f, m, g > 0 are all constant. (a) Show that the angle wo that minimizes the required force to set the box in motion is given by arctan(f) (b) Show that this minimal force F(wo) is proportional to (a constant multiple of)
Needs Complete typed solution with 100 % accuracy.
What is the magnitude of the static friction force required to keep a 2.00 kg block resting on an inclined plane at an angle 25 degrees? If the angle was increased, such that the incline plane was steeper, would the magnitude of the static friction force required to hold the block at rest increase, decrease, or stay the same?
A 1.5 kg block resting ina rough flat surface is pulled by a string. The string makes an angle of 20 degress with the horizontal. The coefficient of static friction between the blodk and the surface is 0.35. What is the maximum tension in the string to keep the block unmoved?