. For the unity feedback system shown in figure find the location for compensating pole for designing the compensator [considering Z.=3] that reduce the setting time by a factor of a 2 while maintaining 30% overshoot.[ assume that the uncompensated system has Wn=2.9%rad RIS) C(S) s(s + 4)(s + 8)

. For the unity feedback system shown in figure find the location for compensating pole for designing the compensator [considering Z.=3] that reduce the setting time by a factor of a 2 while maintaining 30% overshoot.[ assume that the uncompensated system has Wn=2.9%rad RIS) C(S) s(s + 4)(s + 8)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Discuss the difference between the current series negative feedback amplifier and voltage shunt…

Q: Construct Nyquist plot for a feedback control system whose open- loop transfer function is given by,…

Q: In a feedback system, the basic amplifier open-loop low frequency gain is 400k and the open loop 3…

A: An operational amplifier is termed as an op-amp. Two inputs, a negative and a positive input is…

Q: In the following unity feedback system, R(s) + G(s) G(s) C(s) K(s + 6) s(s+ 1)(s + 4) a. Find the…

Q: Rs R 91 www R Rot

A: In the schematic shown, the feedforward amplifier is a voltage amplifier. The output voltage is…

Q: 1) Explain the concept of positive and negative feedback And derive the formula of closed loop…

A: Feedback can either be negative or positive. In negative feedback, a portion of output signal is…

Q: Loop gain analysis in a feedback system applies for __________. Option (1) small-signal…

A: Loop gain is measure how strong or weak the given loop.

Q: feedback system root locus graph shown in figure below. On the edge of stability, the gain K =

A: According to question: The open loop transfer function of the given system is calculated as…

Q: What is closed loop gain?

A: Closed loop gain: To achieve stable operation, op-amps are used in negative feedback. Gain of an…

Q: Describe the series and shunt input connections of a feedback amplifier.

Q: A feedback system root locus graph shown in figure below. For damped frequency 8.04 Hz, the gain K =…

Q: Question 6 Calculate the gain margin in linear scale of a feedback control loop, when its open loop…

A: Control systems are represented by transfer function. This can be written in both time domain and…

Q: Consider the following feedback amplifier circuit. Assume lambda= 0, . VDD ERD2 M₂ ERDI Vin M₁…

Q: The open loop transfer function of a unity feedback system is given by G(s) = (s+1)…

A: In this question we need to find centroid and choose a correct option

Q: Subject : Electronics Engineering Derive the gain equation with feedback by taking an inverting…

A: Given, Inverting opamp. We have to derive gain equation. Please find the below attachments for the…

Q: For the Feedback Control system given in the figure.

A: "Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Give examples for one open-loop system and one closed-loop system. Describe the system’s…

A: Introduction Control System: A control system is a system designed to monitor and manage a…

Q: f the input impedance and voltage gain of an open loop voltage series feedback amplifier are 3KQ and…

A: In the Feedback amplifier there is total 3 types of signal. The source signal, the output signal and…

Q: Q5- Sketch the polar plot of the open loop transfer function of 1 unity feedback control system:…

Q: 5.Consider the feedback system shown in figure. Determine system parameters (a, K, z, p, Ko) to…

A: The Here two blocks are cascaded. And in control system if two blocks (x1 and x2) are cascaded with…

Q: Consider a system with no zeros and only one pole as +5. Place this system in the forward path of a…

A: Here the system has only pole at +5. So G(s)=1s-5 Also the PD controller has Kp=300 and…

Q: Cunsider a general feedback system with parameters À = 10° and A,= 100. If the magnitude of A…

A: Amplifier is an electronic device whose output is amplified version of the input signal. The…

Q: (a) A unity feedback control system in Figure Q2a has an open loop transfer function of Gis) Rea 5…

A: Since you have posted the questions with multiple subpart so we are supposed to answer 3 subpart.

Q: In Negative Feedback Amplifier the gain without feedback is 100. Feedback ratio is 1/75 and if the…

A: Given: Av=100β=175Vin=100 mV

Q: edback system has the following open-loop poles: -2+j1, -2-j1, -0.2. The a

Q: QUESTION 1 A unity feedback system has open loop transfer function shown below. Find K1 so that the…

A: Given, Open loop transfer function of the system, HGs=k1ss+k1k2 ζ=0.4tp=2 sec

Q: Sy stem is for the System to be critically stable, the Value of k hould be

A: The solution can be achieved as follows.

Q: A feedback system signal flow graph diagram shown in figure below. Then, the denominator of total…

A: Mason's Gain Formula: It is used to compute transfer function of a system from signal flow graph.…

Q: ) Explain the concept of positive and negative feedback And derive the formula of closed loop…

A: Solution- FEEDBACK SYSTEM- -If the output is fed back to the reference input it is called as closed…

Q: State whether the following statement is true or false. “Dominant pole compensation increases the…

A: Dominant ple compenstaion is used to increase the stability of the system by introducing a pole…

Q: (B) The state space representation for a closed loop system is shown in figure (5): 1. What is the…

Q: a) An operational amplifier with non-inverting voltage feedback is given in Figure Q4.a. It has the…

A: An op-amp circuit is given as shown below. Open loop gain, AOL=100000 Open loop output impedance,…

Q: S Q4 A For the system described by *=1-²₂ -3)*+124 It is desired to have eigenvalues at -3 and -5 by…

Q: Problem 6. A feedback loop has the three stages shown. Find the operating point and the open-loop…

A: From the given loop: y=2-x z=y√3 x=z2 From the above equations: (z/√3)= 2-z2 Solving this quadratic…

Q: Q-3: A- (a) The closed-loop gain of a negative-feedback amplifier is AFg = -80 and the open-loop…

A: For negative feed back , closed loop gain with feedback AFB = A1+Aβ From above , feedback factor β =…

Q: Explain how the Nyquist stability criterion can be used to determine a stability of a closed-loop…

A: Need to explain the nyquist plot stability criteria

Q: 2-3: A- (a) The closed-loop gain of a negative-feedback amplifier is Arg=-80 and he open-loop gain…

A: We need to calculate feedback factor and we will also calculate feedback gain.

Q: You can refer to the FAQ in the last section for guide. Design the value of gain, K, for the…

Q: R(S) E(S) K s(s+b) K s C(s).

A: DC motor is machine which converts the DC current to electrical energy to mechanical energy.

Q: feedback system root locus graph shown in figure below. he angle of departure theta= 12 10 8. 6. 4 2…

Q: Draw a Nyquist plot for the unity-feedback control system with the open-loop transfer function 1…

A: Given dataTo find outNyquist plot.Stability using Nyquist stability criterion.

Q: A feedback system root locus graph shown in figure below. For damped frequency 8.04 Hz, the gain K =…

Q: The negative feedback closed-loop system was subjected to 15V. The system has a forward gain of 2…

A: It is given that:

Q: identify the following 1. It characterizes the feedback system stability and transient properties.…

A: According to the question, we need to find the best suitable word for the given statements as shown…

Q: Calculate the gain margin in linear scale of a feedback control loop, when its open loop transfer…

A: Properties of the control system are analyzed in frequency as well as Time Domain. Frequency domain…

Q: what will happen to the feedback fraction and frequency of oscillation of the circuit when the…

Q: Hi there, I need help with this question for control systems engineering. Thank you.

A: Step 1: Step 2:

Question

4. For the unity feedback system shown in figure find the location for compensating pole for
designing the compensator [considering Z.=3] that reduce the setting time by a factor of a
2 while maintaining 30% overshoot.I assume that the uncompensated system has
Wn=2.9%rad
R(S)
k
C(S)
s(s + 4)(s + 8)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For a lead compensator whose zero is (-2,0) is used in a feedback control system to provide a phase lead of 45 .for desired pole location (S1=-2+3.3j), that represents the design specifications, this compensators pole is at
Q2) Consider the following feedback system outlined in Figure Q2 Plant R(s) 10 C(s) S+1 Figure Q2 a) Derive the closed loop transfer function GRe(s). b) Calculate the value of Ky that will result in the closed loop system to have a maximum overshoot of 35% and a peak time of approximately 1 second. c) For the following systems assume zero initial conditions. Determine i) The peak overshoots. ii) Corresponding peak times iii) Decay rate characteristics. Produce a sketch of the unit step response using the above values calculated. vate ett
A unity feedback system with forward loop transfer function of 5 G(s) = s(s² + 6s + 10) 1- Determine the closed-loop dominate poles. 2- Design a lag compensator such that the velocity constant will increase to 10. 3- Determine the settling time of the compensated system. 4- Discuss the results.
a) The closed-loop gain of a negative-feedback amplifier is Af = -80 and the open-loop gain is A = -10°. Find the feedback transfer function B.
The delay in the response of any feedback system is called as control mode Select one: True False
Q4) (A) For the circuit shown in figure (3). Drive the transfer function V.(s)/V:(s) R C L. Vo Vi R Figure (3) (B) The characteristic equation of a feedback control system is S* + 2S³ + 3S² + 4S + 5 = 0 Check its stability using Routh 's criterion.
I need the answer as soon as possible
A feedback system root locus graph shown in figure below. On the edge of stability, K= Root Locus 15 12 6. -9 -12 -15 -17 -15.3-13.6-11.9-10.2 -8.5 -6.8 -5.1-3.4 -1.7 0 1.7 3.4 5.1 6.8 8.5 10 Real Axis (seconds") Imaginary Axis (seconds)
5.Consider the feedback system shown in figure. Determine system parameters (a, K, z, p, Ko) to guarantee closed-loop system stability. K. (s+z) K (s +p) e RO E O Y (s² – a²)
I have 30 min plz
Solve it correctly
Please solve this problem I do not understand If my answer is true, solve it clearly please as my question is clear.