. Find the currents through and the voltage across all the resistors.

Q: A wire has a resistance R are cut into 2 pieces and the small pieces are connect in parallel…

A: resistance is directly proportional to length of the wire . if two resistors R1 , R2 are connected…

Q: Two resistors R₁ and R₂ (where R₁ = R₂) are connected in parallel to an ideal battery. Which of the…

A:

Q: What is the equivalent resistance value of the circuit in the diagram? What is the current value in…

A:

Q: Using KIRCHOFF’S LAW find the current in all resistors R1=19 Q, R2=20 Q, R3=21 Q, R4=22 Q, R5=23 Q,…

A: The equivalent circuit with assumed direction of currents and voltage drop based on current…

Q: 5. Three 15-2 resistors are connected in parallel and placed across a 30-V ba a. What is the…

A: Given data, The value all the three resistances are R1= R2 = R3 =15 Ω. All the three resistance are…

Q: Two resistors R1=100 Ohm and R2=100 Ohm (parallel connection) are connected in series with a battery…

A:

Q: AMA

A:

Q: What is the equivalent resistance in ohms between points A and B? All resistances are in ohms *

A: The solution can be achieved as follows.

Q: Solve for all current values though and voltage across each resistor.

A:

Q: A 12 V battery of 0.05 internal resistance r₁ and another battery of 12 V and 0.075 internal…

A:

Q: Compute for the equivalent resistance of the circuit 50 a o- ww ww 5Ω 3Ω 10 0 ww wwww 40

A: If two resistors R1 and R2 are connected in series than equivalent resistance is R1 +R2.  If two…

Q: 3. There are three resistors, and their values are 20 ohm, 30 ohm and 40 ohm. Find out its…

A: It is mentioned that there are three resistors, and their values are 20 ohm, 30 ohm and 40 ohm.

Q: 12. For the circuit shown below, find the potential difference between points a and b. Each resistor…

A: Given circuit, R=160 Ω

Q: Fourteen 3-ohm resistors are available. Make a sketch showing how all resistors should be connected…

A:

Q: Calculate the current through each resistor in figure. If each resistance R = 1.2 kN and V = 12…

A: Find the voltage across terminal A and B.  We are solving this problem using voltage division and…

Q: I2> や、 Is Res"

A:

Q: If resistor R1, R2 are connected in parallel total resistance is 2.4 ohms. R2 and R3 in parallel is…

A:

Q: 1. Connect the circuit shown in the following figure and measure the currents & voltages for each…

A: As per the guidelines, we supposed to answer one question at a time so please ask second question…

Q: Three-phase, 50 Hz 34500/10500 T/S ​​connected transformer single-phase visible on the side of the…

A: There is confusion in the transformer connection T/S it would be D/S that is delta-star. Hence,…

Q: .…………………... In series connection of resistances, the relationship between the resistance and the…

A:

Q: The total current drawn by a circuit consisting of three resistors connected in parallel is 12 A.…

A:

Q: Two resistors R1=100 Ohm and R2=100 Ohm (series connection) are connected in series with a battery…

A:

Q: Given four 1ohms resistor. State how they must be connected to give an overall resistance of…

A: When resistors are connected in series, their total resistance is the sum of individual resistances.…

Q: Find the equivalent resistance at terminals A and B if each resistor is rated 1k-ohm. A B c-M- M- D…

A: consider the given question;

Q: Two resistors R₁ and R2 (where R₁ > R₂) are connected in series to an ideal battery. Which of the…

A:

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Given     Rating of lamp ,P = 50W Voltage rating of lamp ,VL= 12V Available Voltage, V= 24 V

Q: The solar panel, and each panel has 180 Watts, 10 A and 18v. So there 5 panels in each and the total…

A: Solar panel: Solar panel is a device that collects sunlight and convert it into electrical energy. I…

Q: Q3 Find the voltage in each resistor using Kirchhoff's law R1-R2-R3-R4-R5-1k ohm & E1- 10 V.

A:

Q: For each of the 4 resistors types document the optimal multimeter setting to measure resistance and…

A:

Q: In the network shown in the figure, each of the resistance is equal to 20. The resistance between…

A: The given figure each resistance is equal to 2 ohm, the resistance between A and B has been asked.…

Q: 3. Two resistances of 100 and 150respectively are connected in parallel. The two are then connected…

A:

Q: Five resistors are connected as shown in the figure. What is the equivalent resistance of this…

A:

Q: Two resistors, of resistance 3 ohm and 6 ohm, are connected in parallel across a battery having a…

A: Given data: The voltage, V=12 V Resistance, R1=3 Ω Resistance,R2=6 Ω

Q: Description: 1 is Serial In - Parallel Out (SIPO)shift register.Parallel In - what | Serial Out…

A: A register is usually used to store data for a period of time. Almost Every time, to create a…

Q: What value of R

A:

Q: 6. Three resistors of 100 ohms, 60 ohms, and 80 ohms are connected in parallel, and the 60 ohm…

A: Given three resistors are connected in parallel, R1=100 ΩR2=60 ΩR3=80 Ω And then the 60 Ω resistor…

Q: 7) A wire has a resistance R are cut into 2 pieces and the small pieces are connect in parallel…

A:

Q: the value of Vs1,Vs2 ,Vs4 and Vs6 = 10 volt %3D and the value of all resistance is 1 kilo ohm .Using…

A: The equivalent circuit with assumed current direction is shown below:   From the equivalent…

Q: I want to see the solution or step by step process on how the current across resistors is solved

A: In this question,  Find the current in each branch?  We know I = V/Requivlent   We are calculating…

Q: 1. Connect the circuit shown in the following figure and measure the currents & voltages for each…

A:

Q: The three series resistors R1,R2 and R3, what is the value of resistor R1 if voltage V1=25 V and…

A:

Q: Find voltage drop and current across each resistor.

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.