Based on your observations in Part 1 (as well as previous labs), select the three TRUE statements about voltage and resistors in series below. O Resistors in series divide voltage proportionally depending on the relative value of each resistor, meaning the highest voltage will be across the highes value resistor and the lowest voltage will be across the lowest value resistor. O Resistors in series will divide voltage equally, with the total voltage determined by the total resistance. O Resistors in series add to total resistance in a path. O Resistors in series divide voltage proportionally depending on their order (R1 has higher votage, R2 has less, and so on). O Resistors in series reduce total resistance by adding distance to the path, so more charge can flow. O The voltage across each resistor in a series will be inversely proportionate to its resistance, meaning the highest voltage will be across the lowest value resistor and the lowest voltage will be across the highest value resistor. O Resistors in series reduce the potential from the source (in this case, the PSB), allowing paths to be connected with a lower voltage across them. This can be used for greater control over voltage levels in a circuit.

Q: • In the source room you connect a battery of 20V to terminals A and B, A being the point of higher…

A: Here, we have given two rooms, one of them is the source room and the other one is the sink room.…

Q: what are two common types of variables resistors

A: The two common types of variables resistors are

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: 20. Refer to graphic H. What is the resistance needed to be equivalent to the circuit in the box,…

A:

Q: What is the correct way to measure current in a completed circuit using a DMM? O Connected in series…

A: MultimeterThis type of meter is used for the measurement of electrical characteristics. It can…

Q: Find the individual (not combinations of ) elements (voltage sources and/or resistors) that are in…

A:

Q: provide specific values for the resistor, power source, and Red LED

A: Power Source: Typically a battery or a DC power supply.LED (Light Emitting Diode): A semiconductor…

Q: Can I see an example of how to measure a load voltage and current using breadboard with multimeter

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.