PXL_20231017_152544427

Please answer all questions

Please answer allquestions

Fourier Methods Question

Need a sectional view of this drawing

Which of these statements are correct?

mechanical design and drawing

Please show how to get answer

Needs Complete typed solution with 100 % accuracy.

I can't find the symbols for the blank ones

s = 2  t = 0

document/d/11ESFR3NHpvVDpT8547vIXvI0DjvEfWbtK6dw 5rC4vU8/edit#heading-h.gjdgxs ormat Tools Extensions Help Normal text 1/ C Calibri Exercise: 1. 1 E 1000 2 11 BIU A O 1000 3 A section of commercial shafting, 2 m long between bearings, carries a 1000N pulley at its midpoint, as shown in Fig. The pulley is keyed to the shaft and receives 30 kW at 150 rev/min that is transmitted to a flexible coupling just outside the right bearing. The belt drive is horizontal and the sum of the belt tensions is 8000 N. Assume K = Kb = 1.5. Calculate the necessary shaft diameter .The allowable shear stress for the shaft is 40 MN/m² . (Ans : 94.8 mm) D O F₁ JE · : 7 F₁+F₂=8000N F2 1

Match the following statements with the term that best describes each statement. hooks law creep impact strength proportional limit fatigue elastic

Please. Answer parts please. Attempt Once. Use cosine and show in rad and degree (2 diff eq)

Determine, using the principle of superposition, the reactions at supports A and B for equilibrium. The beam is fixed at A and supported by a roller at B. Take Wo = 900 N/m and consider El is constant. WO B 3 m Select one: Ax = 0, Ay = 120 N (upward), MA = 540 N.m (counter-clockwise) and By 90 N (upward).

Please Fill In the blanks where I have marked red X's using the questions and Image below. 1. On the drawing above, before any geometric controls are applied, what is the coaxility tolerance is implied between the diameters? 2. On the part above, apply datum feature symbols to create a datum axis A-B by using the right and left diamters. 3. Apply a position coaxility between the right and left diamter of 0.1 at MMC. 4. Apply a position tolerance to the large center diameter within a diameter of 0.3 in relation to the single datum axis established by both datum features A and B.

explain the Static here? include the minimum and the max .

please answer do not image format

Please resolve within 15 minutes