Lab 2 Report

bessel bandpass filter analysis and all formula. lecture summary

communaction system 2

For the filter: a) Determine type of filter and the cut-off frequency (Fc). Determine the peak voltage at the cut-off frequency (Fc). b) Find GAIN (Vo/Vi) at f = .1*Fc . Find GAIN (Vo/Vi) at f = 10*Fc . c) Determine the frequency at which GAIN = .4 (i.e., Vo = .4*Vi) . Draw the “Frequency Response Plot” in “Log-Log” format .

Solve in digital format 1.- Describe in your words the definition of bandwidth.2.- Describe the definition of bandwidth of a system.3.- Describe the definition of bandwidth of a signal4.-What is the function of a filter?

The circuit is shown below, Vin is the sinusoidal waveform with magnitude 5V and frequency is 100 Hz, R = 1 k, C = 1 uE, the chip is supplied by + 12 V source. a) What is the waveform of Yout? b) Calculate the magnitude of Vo c) If Vin is triangle waveform, what is the output waveform? -Vout , if Vin is triangle waveform with magnitude of 5 V (peak-to-peak value is 10 V) and frequency is 10 kHz, calculate waveform of you and the magnitude of I/?

Is=20*10-16 B=100 question A&B

I need proper solution for the following( underdstandable writing and well explained) thank you  What is resonance in LCR circuit? and tell the difference between impedance and resistance?

(b) High-frequency ECG biopotentials analysis in the ST-T segment of a high-resolution ECG signal recording requires the analysis of signal components above 30 Ilz and below 800 Hz. Design a first order band pass passive filter to accommodate this specified frequency bandwidth. Sketch the circuit configuration. You may use an op- amp buffer stage in your circuit design.

Please do fast, I will like the solution.

Design a first order active low pass filter using a single ideal Operational Amplifier (Op-Amp) as follows:  a) Draw the circuit diagram of the filter.  b) Derive the transfer function of the filter.

(a) Explain the function of a high pass filter. Draw a diagram of a simple high–pass filter using a capacitor and a resistor.

Please show work

Topic : Pulse Modulation and Sampling theorem 1.C.)

Explain the RC time constant and what its value means in terms of circuit characteristics.

Full the following blanks: