Skittles data recording sheet 2023-1

QUESTION 9 When a ground wire is connected to an interior gas piping system and the underground portion of the gas pipe into the building is plastic, which of the following is (or are) true? a   A.This would be approved by code as the gas pipe is only being bonded to the electrical system. b   B.This installation would be approved by code, as the gas pipe is not a grounding electrode. c   C.Both A and B d   D.Neither A nor B

1)Aluminum piping is permitted to be used as a grounding electrode only if other electrodes specified in 250.52(A) are not available for use. a) True b) False  2)The Code requires that more than one grounding electrode be installed to form a system of installed electrodes when none are present. a) True b) False

Four electricians are discussing wiring under raised floors in information technology equipment rooms. Electrician A says that wiring under the raised floor requires fire-resistant walls, floors, and ceilings between other occupancies. Electrician B says that wiring under the raised floor requires fire resistant halfway up the walls and floors between other occupancies. Electrician C says that the room must employ a disconnecting means that removes half of the power to all equipment in the room. Electrician D says that a disconnecting means isn't necessary for the room. Which of the following statements is correct? A. Electrician B is correct. B. Electrician D is correct. C. Electrician A is correct. D. Electrician C is correct.

True or false

Messages AA Statement one Training will allow you to safely erect a mobile. tower scaffold on any ground surface condition. and access the tower both internal and externally Statement two In windy conditions placing sheeting around the mobile tower scaffold will protect the workers on the tower a) Statement two is incorrect b) Statement one and two are correct c) Statement one is correct and statement two is incorrect d) Both statements are incorrect actclass.co.uk 22 Questi 23 Questi 24 Questi 25 Questi 26 Questi Submit Answers Ć

6.a. Extreme _______ may cause some nonmetallic conduits to become brittle and therefore moresusceptible to damage from physical contact.A. coldB. corrosionC. voltageD. heat6.b. Snap switches are permitted to be grouped or ganged in an enclosure provided the voltage between theadjacent snap switches does not exceed ___ V.A. 400B. 300C. 200D. 100

Complete the following statement about multimeters using the following words. Words: Accuracy, Advanced, Available, Circuits, Current, Digital, Diode, Direct, Display, Electronic, Functions, High, Hundredths, Impedance, Measure, Multimeter, Needle, Ohms, Provide, Range, Selected, Test A digital __________ (DMM) can __________ many more things than volts, __________, and lowcurrent. Most multimeters measure __________ current (dc) and alternating __________ (ac)amperes, volts, and ohms. More __________ multimeters may also measure __________ continuity,frequency, temperature, engine speed, and dwell, and/or duty cycle.Multimeters are __________ with either digital or analogue displays. DMMs __________ great__________ by measuring volts, ohms, or amperes in tenths, __________, or thousandths of a unit.Several test __________ are usually provided for each of these __________. Some meters havemultiple __________ ranges that must be manually __________; others are auto-ranging.Analogue…

What is LASIK for and is it used for therapeutic or a diagnostic applications? What type of laser and wavelength is used in the LASIK application?   hello,  please write in a very short paragraph about the above question by answering all the questions. thank you

(7) The three things that must be present for a fire to burn are __________. Select one: A. FUEL, OXYGEN, AND CHEMICAL REACTION B. HEAT, FUEL, AND CHEMICAL REACTION C. HEAT, FUEL, AND OXYGEN D. OXYGEN, FUEL, AND PRESSURE

The system having ±0.5% of F.S.D if the full scale deflection is 50 units, then accuracy is _____ a. ±0.25 b. ±1 c. ±0 d. ±0.5

Please answer in typing format

6. Ferrous metal raceways or enclosures are made with _______ content.A. brass or aluminumB. steel or brassC. aluminum or ironD. iron or steel

Please answer in typing format