In Figure D-10a and D-10b, every region of constructive interference and destructive interference between the HOMO and LUMO is to be labeled. Concept introduction: Molecular orbitals are constructed from the AOs of different atoms. When two atoms are brought close enough together (i.e., about a bond length apart), the AOs of one atom significantly overlap the AOs of the other atom, enabling them to undergo constructive and destructive interference, or mix, to produce new orbitals. When two orbitals overlap with the same phases, constructive interference takes place. When two orbitals overlap with the opposite phases, destructive interference takes place. Constructive interference results in a new orbital that is more stable than the σ bonding orbital, and destructive interference results in a new orbital that is less stable than the ρ atomic orbital. Constructive interference predominantly takes place in both Figure D-10a and Figure D-10b

Question

Want to see the full answer?

Answer 1

Question

Chapter D, Problem D.12YT

Interpretation Introduction

Interpretation:

In Figure D-10a and D-10b, every region of constructive interference and destructive interference between the HOMO and LUMO is to be labeled.

Concept introduction:

Molecular orbitals are constructed from the AOs of different atoms. When two atoms are brought close enough together (i.e., about a bond length apart), the AOs of one atom significantly overlap the AOs of the other atom, enabling them to undergo constructive and destructive interference, or mix, to produce new orbitals. When two orbitals overlap with the same phases, constructive interference takes place. When two orbitals overlap with the opposite phases, destructive interference takes place. Constructive interference results in a new orbital that is more stable than the σ bonding orbital, and destructive interference results in a new orbital that is less stable than the ρ atomic orbital. Constructive interference predominantly takes place in both Figure D-10a and Figure D-10b

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Don't used hand raiting

at 32.0 °C? What is the osmotic pressure (in atm) of a 1.46 M aqueous solution of urea [(NH2), CO] at 3 Round your answer to 3 significant digits.

Reagan is doing an atomic absorption experiment that requires a set of zinc standards in the 0.4-1.6 ppm range. A 1000 ppm Zn solution was prepared by dissolving the necessary amount of solid Zn(NO3)2 in water. The standards can be prepared by diluting the 1000 ppm Zn solution. Table 1 shows one possible set of serial dilutions (stepwise dilution of a solution) that Reagan could perform to make the necessary standards. Solution A was prepared by diluting 5.00 ml of the 1000 ppm Zn standard to 50.00 ml. Solutions C-E are called "calibration standards" because they will be used to calibrate the atomic absorption spectrometer. a. Compare the solution concentrations expressed as ppm Zn and ppm Zn(NO3)2. Compare the concentrations expressed as M Zn and M Zn(NO3)2 - Which units allow easy conversion between chemical species (e.g. Zn and Zn(NO3)2)? - Which units express concentrations in numbers with easily expressed magnitudes? - Suppose you have an analyte for which you don't know the molar…