FIRST CRSE.IN DIFF.EQUAT..-ACCESS
11th Edition
ISBN: 9781337652469
Author: ZILL
Publisher: CENGAGE L
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 9.1, Problem 11E
Consider the initial-value problem y′ = (x + y – 1)2, y(0) = 2. Use the improved Euler’s method with h = 0.1 and h = 0.05 to obtain approximate values of the solution at x = 0.5. At each step compare the approximate value with the actual value of the analytic solution.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
do question 2
21. ANALYSIS OF LAST DIGITS Heights of statistics students were obtained by the author as
part of an experiment conducted for class. The last digits of those heights are listed below.
Construct a frequency distribution with 10 classes. Based on the distribution, do the
heights appear to be reported or actually measured? Does there appear to be a gap in the
frequencies and, if so, how might that gap be explained? What do you know about the
accuracy of the results?
3 4
555
0 0 0 0 0 0 0 0 0 1 1 23 3
5 5 5 5 5 5 5 5 5 5 5 5 6 6 8 8 8 9
A side view of a recycling bin lid is diagramed below where two panels come together at a right angle.
45 in
24 in
Width? —
Given this information, how wide is the recycling bin in inches?
Chapter 9 Solutions
FIRST CRSE.IN DIFF.EQUAT..-ACCESS
Ch. 9.1 - In Problems 1–10 use the improved Euler’s method...Ch. 9.1 - In Problems 1–10 use the improved Euler’s method...Ch. 9.1 - In Problems 110 use the improved Eulers method to...Ch. 9.1 - Prob. 4ECh. 9.1 - In Problems 110 use the improved Eulers method to...Ch. 9.1 - Prob. 6ECh. 9.1 - In Problems 1–10 use the improved Euler’s method...Ch. 9.1 - In Problems 110 use the improved Eulers method to...Ch. 9.1 - In Problems 110 use the improved Eulers method to...Ch. 9.1 - In Problems 110 use the improved Eulers method to...
Ch. 9.1 - Consider the initial-value problem y′ = (x + y –...Ch. 9.1 - Consider the initial-value problem y = 2y, y(0) =...Ch. 9.1 - Repeat Problem 13 using the improved Eulers...Ch. 9.1 - Repeat Problem 13 using the initial-value problem...Ch. 9.1 - Repeat Problem 15 using the improved Euler’s...Ch. 9.1 - Consider the initial-value problem y = 2x 3y + 1,...Ch. 9.1 - Repeat Problem 17 using the improved Euler’s...Ch. 9.1 - Repeat Problem 17 for the initial-value problem y′...Ch. 9.1 - Repeat Problem 19 using the improved Euler’s...Ch. 9.1 - Answer the question Why not? that follows the...Ch. 9.2 - Use the RK4 method with h = 0.1 to approximate...Ch. 9.2 - Assume that (4). Use the resulting second-order...Ch. 9.2 - In Problems 3–12 use the RK4 method with h = 0.1...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - In Problems 3–12 use the RK4 method with h = 0.1...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - In Problems 312 use the RK4 method with h = 0.1 to...Ch. 9.2 - If air resistance is proportional to the square of...Ch. 9.2 - Consider the initial-value problem y = 2y, y(0) =...Ch. 9.2 - Repeat Problem 16 using the initial-value problem...Ch. 9.2 - Consider the initial-value problem y′ = 2x – 3y +...Ch. 9.2 - Prob. 19ECh. 9.2 - Prob. 20ECh. 9.3 - Prob. 1ECh. 9.3 - Prob. 3ECh. 9.3 - Prob. 4ECh. 9.3 - Prob. 5ECh. 9.3 - Prob. 6ECh. 9.3 - Prob. 7ECh. 9.3 - In Problems 58 use the Adams-Bashforth-Moulton...Ch. 9.4 - Use Eulers method to approximate y(0.2), where...Ch. 9.4 - Use Euler’s method to approximate y(1.2), where...Ch. 9.4 - Prob. 3ECh. 9.4 - In Problems 3 and 4 repeat the indicated problem...Ch. 9.4 - Prob. 5ECh. 9.5 - In Problems 110 use the finite difference method...Ch. 9.5 - Prob. 2ECh. 9.5 - Prob. 3ECh. 9.5 - Prob. 4ECh. 9.5 - Prob. 5ECh. 9.5 - Prob. 6ECh. 9.5 - Prob. 7ECh. 9.5 - In Problems 1 – 10 use the finite difference...Ch. 9.5 - Prob. 9ECh. 9.5 - Prob. 10ECh. 9.5 - Prob. 11ECh. 9.5 - The electrostatic potential u between two...Ch. 9.5 - Prob. 13ECh. 9 - In Problems 14 construct a table comparing the...Ch. 9 - In Problems 14 construct a table comparing the...Ch. 9 - Prob. 3RECh. 9 - Prob. 4RECh. 9 - Prob. 5RECh. 9 - Prob. 6RECh. 9 - Prob. 7RECh. 9 - Prob. 8RE
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, subject and related others by exploring similar questions and additional content below.Similar questions
- f'(x)arrow_forwardIf you are using chatgpt leave it I will downvote .arrow_forwardTemperature measurements are based on the transfer of heat between the sensor of a measuring device (such as an ordinary thermometer or the gasket of a thermocouple) and the medium whose temperature is to be measured. Once the sensor or thermometer is brought into contact with the medium, the sensor quickly receives (or loses, if warmer) heat and reaches thermal equilibrium with the medium. At that point the medium and the sensor are at the same temperature. The time required for thermal equilibrium to be established can vary from a fraction of a second to several minutes. Due to its small size and high conductivity it can be assumed that the sensor is at a uniform temperature at all times, and Newton's cooling law is applicable. Thermocouples are commonly used to measure the temperature of gas streams. The characteristics of the thermocouple junction and the gas stream are such that λ = hA/mc 0.02s-1. Initially, the thermocouple junction is at a temperature Ti and the gas stream at…arrow_forwardA body of mass m at the top of a 100 m high tower is thrown vertically upward with an initial velocity of 10 m/s. Assume that the air resistance FD acting on the body is proportional to the velocity V, so that FD=kV. Taking g = 9.75 m/s2 and k/m = 5 s, determine: a) what height the body will reach at the top of the tower, b) how long it will take the body to touch the ground, and c) the velocity of the body when it touches the ground.arrow_forwardA chemical reaction involving the interaction of two substances A and B to form a new compound X is called a second order reaction. In such cases it is observed that the rate of reaction (or the rate at which the new compound is formed) is proportional to the product of the remaining amounts of the two original substances. If a molecule of A and a molecule of B combine to form a molecule of X (i.e., the reaction equation is A + B ⮕ X), then the differential equation describing this specific reaction can be expressed as: dx/dt = k(a-x)(b-x) where k is a positive constant, a and b are the initial concentrations of the reactants A and B, respectively, and x(t) is the concentration of the new compound at any time t. Assuming that no amount of compound X is present at the start, obtain a relationship for x(t). What happens when t ⮕∞?arrow_forwardConsider a body of mass m dropped from rest at t = 0. The body falls under the influence of gravity, and the air resistance FD opposing the motion is assumed to be proportional to the square of the velocity, so that FD = kV2. Call x the vertical distance and take the positive direction of the x-axis downward, with origin at the initial position of the body. Obtain relationships for the velocity and position of the body as a function of time t.arrow_forwardAssuming that the rate of change of the price P of a certain commodity is proportional to the difference between demand D and supply S at any time t, the differential equations describing the price fluctuations with respect to time can be expressed as: dP/dt = k(D - s) where k is the proportionality constant whose value depends on the specific commodity. Solve the above differential equation by expressing supply and demand as simply linear functions of price in the form S = aP - b and D = e - fParrow_forwardFind the area of the surface obtained by rotating the circle x² + y² = r² about the line y = r.arrow_forward3) Recall that the power set of a set A is the set of all subsets of A: PA = {S: SC A}. Prove the following proposition. АСВ РАСРВarrow_forwardA sequence X = (xn) is said to be a contractive sequence if there is a constant 0 < C < 1 so that for all n = N. - |Xn+1 − xn| ≤ C|Xn — Xn−1| -arrow_forward3) Find the surface area of z -1≤ y ≤1 = 1 + x + y + x2 over the rectangle −2 ≤ x ≤ 1 and - Solution: TYPE YOUR SOLUTION HERE! ALSO: Generate a plot of the surface in Mathematica and include that plot in your solution!arrow_forward7. Walkabout. Does this graph have an Euler circuit? If so, find one. If not, explain why not.arrow_forwardarrow_back_iosSEE MORE QUESTIONSarrow_forward_ios
Recommended textbooks for you
Algebra & Trigonometry with Analytic GeometryAlgebraISBN:9781133382119Author:SwokowskiPublisher:Cengage
Algebra & Trigonometry with Analytic Geometry
Algebra
ISBN:9781133382119
Author:Swokowski
Publisher:Cengage
01 - What Is A Differential Equation in Calculus? Learn to Solve Ordinary Differential Equations.; Author: Math and Science;https://www.youtube.com/watch?v=K80YEHQpx9g;License: Standard YouTube License, CC-BY
Higher Order Differential Equation with constant coefficient (GATE) (Part 1) l GATE 2018; Author: GATE Lectures by Dishank;https://www.youtube.com/watch?v=ODxP7BbqAjA;License: Standard YouTube License, CC-BY
Solution of Differential Equations and Initial Value Problems; Author: Jefril Amboy;https://www.youtube.com/watch?v=Q68sk7XS-dc;License: Standard YouTube License, CC-BY