The shape of the curve, when rate of reaction is plotted with substrate concentration. Introduction: Enzymes catalyze biological reactions at a faster velocity. They achieve this by combining substrate molecules at their active site and stabilizing complex, and in this process they lower the activation energy. Each enzyme is unique to its substrate molecule by the virtue of its active site. The enzymes on binding with substrate convert them into products and made available to bind with other molecules to carry out the same reaction.

Question

A sample of blood was taken from the above individual and prepared for haemoglobin analysis. However, when water was added the cells did not lyse and looked normal in size and shape. The technician suspected that they had may have made an error in the protocol – what is the most likely explanation? The cell membranes are more resistant than normal. An isotonic solution had been added instead of water. A solution of 0.1 M NaCl had been added instead of water. Not enough water had been added to the red blood cell pellet. The man had sickle-cell anaemia.

Answer 1

Question

Chapter 8.4, Problem 3R

Summary Introduction

To review:

The shape of the curve, when rate of reaction is plotted with substrate concentration.

Introduction:

Enzymes catalyze biological reactions at a faster velocity. They achieve this by combining substrate molecules at their active site and stabilizing complex, and in this process they lower the activation energy. Each enzyme is unique to its substrate molecule by the virtue of its active site. The enzymes on binding with substrate convert them into products and made available to bind with other molecules to carry out the same reaction.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

A sample of blood was taken from the above individual and prepared for haemoglobin analysis. However, when water was added the cells did not lyse and looked normal in size and shape. The technician suspected that they had may have made an error in the protocol – what is the most likely explanation? The cell membranes are more resistant than normal. An isotonic solution had been added instead of water. A solution of 0.1 M NaCl had been added instead of water. Not enough water had been added to the red blood cell pellet. The man had sickle-cell anaemia.

With reference to their absorption spectra of the oxy haemoglobin intact line) and deoxyhemoglobin (broken line) shown in Figure 2 below, how would you best explain the reason why there are differences in the major peaks of the spectra? Figure 2. SPECTRA OF OXYGENATED AND DEOXYGENATED HAEMOGLOBIN OBTAINED WITH THE RECORDING SPECTROPHOTOMETER 1.4 Abs < 0.8 06 0.4 400 420 440 460 480 500 520 540 560 580 600 nm 1. The difference in the spectra is due to a pH change in the deoxy-haemoglobin due to uptake of CO2- 2. There is more oxygen-carrying plasma in the oxy-haemoglobin sample. 3. The change in Mr due to oxygen binding causes the oxy haemoglobin to have a higher absorbance peak. 4. Oxy-haemoglobin is contaminated by carbaminohemoglobin, and therefore has a higher absorbance peak 5. Oxy-haemoglobin absorbs more light of blue wavelengths and less of red wavelengths than deoxy-haemoglobin