The main sedimentary environments on land along with some characteristics of each.

Answer to Problem 1BYL
Terrestrial, fluvial, deltaic, lacustrine, and glacial settings are the principal sedimentary environments on land.
Explanation of Solution
The terrestrial sedimentary environments can include mountainous regions and desert regions. Steep slopes developed on the bedrock are typical for a mountain setting. Several mountains, except some, own a higher elevation. Steep slopes and high elevation enhance the erosional activity as a result of which a huge quantity of sediments (of various sizes) is produced. The so-formed sediments would later be carried out of the mountains into some other enviroments.
The desert environment where arid or semi-arid climates prevail is another terrestrial sedimentary setting. Wind is the active geologic agent in such regions with a dry climate. The wind takes up and carries the sand and finer particles along with it and deposits them when it loses its carrying capacity and energy. The deposited sediments would take the form of sand dunes that are entirely made up of sand and loess.
The fluvial environment comprises streams as the main agents. The streams in the mountains characteristically possess steep gradients and are confined by the bedrock canyons. The streams usually become braided as they leave the mountains, which is evident from the multitude of channels that riven and rejoin. A stream brings a lot of sediments along its way to the ocean and deposits at places wherever its velocity, capacity, and competence reduce or wherever it encounters with some barriers.
The streams that run over a gentle landscape usually meander elegantly. A majority of streams are bordered by fairly flat lands called floodplains that would be covered during flooding events. The floodwaters carry sand and mud, which may be deposited layer upon layer that results in the formation of floodplains of the meandering streams.
As the stream enters a standing water body such as a lake or ocean, its velocity decreases and currents slow down, which leads to the spreading out and deposition of much of the transported sediments. The sediment heaps up at the mouth of the stream and develops into a delta that stretches into the ocean or lake.
The lacustrine environment is concerned with lakes. Lakes include a variety of environments that range from quiet, deep water found in the center to more dynamic water along with waves driven by winds along the shoreline. The beaches found along the shoreline could be rocky or sandy. Certain lakes may be permanently filled with water; however, others get dried up entirely due to the eveporation of water or seepage of water into the underlying materials.
The highly saturated soil, commonly found in very wet environments, such as those nearby lakes or delta regions, paves the way for the development of lakes, swamps, marshlands, and ponds. These type of wetlands characteristically possess profuse water- dependent vegetation, which could be a significant component of the sediment. The underlying sediment would be protected from the atmosphere by the water, which controls the amount of oxidation.
The high mountains and higher latitude or polar regions will have thick accumulations of snow with an accumulation rate greater than the rate at which snow gets removed through melting or other processes. As time passes, the snow turns out to be even more compacted into ice, which would move downhill as a glacier . When glaciers move, the underlying materials are eroded and carried along with them. The eroded sediment and water might be released when the ice melts, mostly at the terminus of the glacier.
Want to see more full solutions like this?
Chapter 7 Solutions
PRINT UPGRADE-EXPLORING GEOLOGY
- Discussion Question: Atmospheric Water & Weather A+ This chapter beautifully focuses on water from the small molecular scale to large-scale weather patterns. The surplus of heat at the equator and the deficit at the Poles drives our atmospheric instability. Instability is a good thing! Without the unstable conditions, there would not be any atmospheric motion. The overheating of the equator pumps atmospheric uplift. As the air rises into lower pressures, it expands and cools... adiabatic cooling! The air migrates north and south and becomes denser than the surrounding air and sinks. The sinking air enters higher pressures and creates the subtropical high pressures and adiabatic heating...whaaaa-la! We have Hadley Cells! Not to mention, the Rainforests and World's largest deserts too! We now can imagine the Hadley cells in three-dimensions. They more or less "sandwich" the equator during the spring and fall equinoxes. However, what happens in the summer and winter? mP Maritime polar…arrow_forwardUsing the map. Solve part e f garrow_forwardAnswer the below questions in detail using the attached pictures. Please ensure it is all 100% done by human, please do not use AI or chatgpt. using the provided hydraulic head data (attached spreadsheet), plot the values at their corresponding piezometer locations (attached piezometer map), contour the head data to create equipotential lines that allow you to demonstrate the groundwater flow direction, indicate the flow direction with arrows, provide comments/observations about the characteristics of the groundwater flow system, for example, are the equipotential lines equally spaced? If not, can you comment on why there are areas with close spacing and other areas with wide spacing? Are there any areas where the aquifer displays artesian conditions? If so, where?arrow_forward
- Please answer the question in detail. Please ensure it is 100% done by human, please do not use AI or chatgpt. Organize your spreadsheets carefully and make sure they are easy to follow. Make sure that your units are consistent, use SI units and make sure your graphs are clear and well labelled.arrow_forwardPlease answer each question in detail. Please ensure it is 100% done by human, please do not use AI or chatgpt.arrow_forwardI need help on this questionarrow_forward
- Please answer the question in detail. Please ensure it is 100% done by human, please do not use AI or chatgpt.arrow_forwardAnswer the below questions in detail using the attached pictures using the provided hydraulic head data (attached spreadsheet), plot the values at their corresponding piezometer locations (attached piezometer map), contour the head data to create equipotential lines that allow you to demonstrate the groundwater flow direction, indicate the flow direction with arrows, provide comments/observations about the characteristics of the groundwater flow system, for example, are the equipotential lines equally spaced? If not, can you comment on why there are areas with close spacing and other areas with wide spacing? Are there any areas where the aquifer displays artesian conditions? If so, where?arrow_forwardPlease answer the three questions in detail and as best as you can. plotting grain-size distribution curves from the grain data provided, calculating D10 values for each sample and using it to estimate the hydraulic conductivity, calculating the porosity for each sample Please ensure it is 100% done by human, please do not use AI or chatgpt.arrow_forward
- Please answer the question in detail. Please ensure it is 100% done by human, please do not use AI or chatgpt.arrow_forwardActivity 9.4 Depositional Features of Glaciers Pg 158Use Figure 9.7, which illustrates a hypothetical retreating glacier, to complete the following. 1. As a glacier retreats, it sometimes stalls and deposits a recessional end moraine. Label the recessional end moraine on Figure 9.7. 2. On Figure 9.7, label an area covered by ground moraine. 3. On Figure 9.7, fill in the appropriate blanks with the names of the following depositional features: kettle lake, kame, drumlin, esker, and outwash plain. 4. Which area is composed of stratified drift: the ground moraine or the outwash plain? Activity 9.5 Depositional Features Associated with Ice Sheets Pgs 159-1611. After examining the map and stereogram, draw a line on the map to outline the area illustrated on the stereogram. 2. What evidence on the map indicates that portions of the area are poorly drained? On what part of the map are these features located? 3. Use Figure 9.11 to draw a topographic profile of the X-Y line on Figure 9.10.…arrow_forward3 1 O O O O Multiple Choice 1 point What is the geodesic distance between Fulton County Airport and the Toledo Express Airport? 27,301.7152 meters 25,923.833 meters 22, 743.621 meters 29,422.61 meters 2 Fill in the Blank 1 point How many airport complexes are in Cuyahoga County? type your answer.... Fill in the Blank 1 point How many airport complexes are in Mahoning County? type your answer... 4 Fill in the Blank 1 point If you lived in Uniopolis, OH, what airport complex would be the closest to you type your answer... two decimal points) type your answer... miles and how far away would it be? (Give this value in miles to -DOarrow_forward
- Applications and Investigations in Earth Science ...Earth ScienceISBN:9780134746241Author:Edward J. Tarbuck, Frederick K. Lutgens, Dennis G. TasaPublisher:PEARSONExercises for Weather & Climate (9th Edition)Earth ScienceISBN:9780134041360Author:Greg CarbonePublisher:PEARSONEnvironmental ScienceEarth ScienceISBN:9781260153125Author:William P Cunningham Prof., Mary Ann Cunningham ProfessorPublisher:McGraw-Hill Education
- Earth Science (15th Edition)Earth ScienceISBN:9780134543536Author:Edward J. Tarbuck, Frederick K. Lutgens, Dennis G. TasaPublisher:PEARSONEnvironmental Science (MindTap Course List)Earth ScienceISBN:9781337569613Author:G. Tyler Miller, Scott SpoolmanPublisher:Cengage LearningPhysical GeologyEarth ScienceISBN:9781259916823Author:Plummer, Charles C., CARLSON, Diane H., Hammersley, LisaPublisher:Mcgraw-hill Education,





