The dislocation formed by adding an extra half plane of atoms to a crystal:

Question

Want to see the full answer?

Answer 1

Question

Chapter 7, Problem 2FEQP

To determine

The dislocation formed by adding an extra half plane of atoms to a crystal:

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The thin-walled open cross section shown is transmitting torque 7. The angle of twist ₁ per unit length of each leg can be determined separately using the equation 01 = 3Ti GLIC 3 where G is the shear modulus, ₁ is the angle of twist per unit length, T is torque, and L is the length of the median line. In this case, i = 1, 2, 3, and T; represents the torque in leg i. Assuming that the angle of twist per unit length for each leg is the same, show that T= Lic³ and Tmaz = G01 Cmax Consider a steel section with Tallow = 12.40 kpsi. C1 2 mm L1 20 mm C2 3 mm L2 30 mm C3 2 mm L3 25 mm Determine the torque transmitted by each leg and the torque transmitted by the entire section. The torque transmitted by the first leg is | N-m. The torque transmitted by the second leg is N-m. The torque transmitted by the third leg is N-m. The torque transmitted by the entire section is N-m.

Consider a new 1800 MW power plant that burns dry sub-bituminous coal in a PC-wall-fired, wet bottom furnace with plant efficiency of 39%. Use the emission factors in your lecture notes to determine the emission rates of all particulates, PM10, SOx, NOx and CO in ton per year. No gas treatment equipment was installed.

A lignite-fired power plant was designed to produce electricity at a maximum capacity of 750 MW. By average over a year, the plant is operated at 35% plant efficiency and 65% of the design capacity. Assume that the entire amount of sulfur in lignite coal entering the plant is converted to sulfur dioxide (SO2). The power plant is equipped with an 85% efficiency SO2 removal unit. Use the engineering calculation approach and the coal information (dry basis) found in your lecture notes to determine emission rate of SO2 in lb/hr and in lb/BTU input.