Concept explainers
In mice, the dominant allele Gs of the X-linked gene Greasy produces shiny fur, while the recessive wild-type Gs+ allele determines normal fur. The dominant allele Bhd of the X-linked Broadhead gene causes skeletal abnormalities including broad heads and snouts, while the recessive wild-type Bhd+ allele yields normal skeletons. Female mice heterozygous for the two alleles of both genes were mated with wild-type males. Among 100 male progeny of this cross, 49 had shiny fur, 48 had skeletal abnormalities, 2 had shiny fur and skeletal abnormalities, and 1 was wild type.
a. | Diagram the cross described and calculate the distance between the two genes. |
b. | What would have been the results if you had counted 100 female progeny of the cross? |
a.
To draw:
The diagram of the cross described in the problem and calculate the distance between the two genes.
Introduction:
Genes present on the same chromosome that do not assort independently are said to be linked. Recombination is a process in which small DNA sequences are broken and then recombined to give new combinations of alleles. The genetic diversity at the level of genes is created by the recombination. This reflects variation in the DNA sequences of different organisms.
Explanation of Solution
In mice, the dominant allele Gs of the X-linked gene Greasy gives shiny fur. The recessive wild-type Gs+ allele gives normal fur. The dominant allele Bhd of the X-linked Broadhead gene causes skeletal abnormalities. The recessive wild-type Bhd+ allele gives a normal skeleton. The heterozygous female mice for the two alleles of both genes were mated with wild-type males.
The genotype of heterozygous female mice for the two alleles of both genes:
The genotype of wild type male:
The following table explains the cross between the heterozygous female mice for the two alleles of both genes and the wild type male:
Male/Female gametes | ||||
Y | (1 wild type) |
(49 shiny fur) |
(2 shiny fur, skeletal abnormalities) |
(48 skeletal abnormalities) |
Here, 49 and 48 male progenies are parental gametes; whereas, 1 and 2 are recombinant gametes. Recombination frequency (RF) is the rate of occurrence of recombination between a pair of linked genes. It can be calculated using the following formula:
Assuming, 1 map unit is equal to 1% recombination. Recombination frequency helps in determining the distance between two genes and in generating linkage map.
So,
Therefore, the distance between the given genes is 3 cM.
b.
To determine:
The results if 100 female progeny would have counted.
Introduction:
Recombination frequency (RF) is the rate of occurrence of recombination between a pair of linked genes. It helps in determining the distance between two genes and in the generation of the linkage map.
Explanation of Solution
The genotype of heterozygous female mice for the two alleles of both genes:
The genotype of wild type male:
The following table explains the cross between the heterozygous female mice for the two alleles of both genes and the wild type male:
Male/Female gametes | ||||
So, in this case, the same number of progeny would be obtained, even 100 female progeny would have been counted.
Therefore, the distance between the two given genes would be 3 cM.
Want to see more full solutions like this?
Chapter 5 Solutions
ND STONY BROOK UNIVERSITY LOOSELEAF GENETICS: FROM GENES TO GENOMES
- You will use the following scenario to answer a group of 5 questions. You have isolated a microbe from an environmental sample. The microbe has the ability to perform a new metabolic reaction at a very low temperature, so you are excited that it could be a new species. You have shipped your samples off for sequencing and are now waiting for the results. Out of curiosity (and maybe boredom...) you decide to test your culture for the Catalase and Oxidase enzymes. Upon testing your sample for catalase, you don't see any bubbles; however, you do see a color change to purple during the Oxidase test. What results can you conclude from this? O Catalase-/ Oxidase + O Catalase +/ Oxidase + Catalase + / Oxidase- O Catalase / Oxidase - O None of the abovearrow_forwardWhich of the following is not a strength of using 16S rRNA for phylogenetic analyses? OA. It's cheap OB. It's easy to do C. It can be used to identify all the way down to the strain level OD. Both A & B OE. None of the abovearrow_forwardWhy are molecular approaches important to the field of microbial taxonomy and phylogeny? Phylogenetic inferences based on molecular approaches provide the most robust analysis of microbial evolution currently available. It allows for the collection of a large and accurate dataset from many organisms Almost no fossil record was left by microbes when compared to plants and animals All of the above None of the abovearrow_forward
- You will use the following scenario to answer a group of 5 questions. You have isolated a microbe from an environmental sample. The microbe has the ability to perform a new metabolic reaction at a very low temperature, so you are excited that it could be a new species. You have already cultured it and gone through the plate isolation procedure. Before you ship your samples off for sequencing, you want to do one final check of the A260 ratios. You get back the following ratios: A260/280 ratio is 1.89; A260/230 is 2.01. These ratios are close enough to the accepted "pure" values so they could be considered "pure" and mostly (if not completely) free of contaminants from the PCR process. True Falsearrow_forwardYou will use the following scenario to answer a group of 5 questions. You have isolated a microbe from an environmental sample. The microbe has the ability to perform a new metabolic reaction at a very low temperature, so you are excited that it could be a new species. After receiving your sequence back from the sequencing lab, you feel that you have, in fact, discovered and isolated a new species. You ask a fellow labmate about how you should proceed, and he tells you the following is the proper way to introduce a new species for recognition: Cultures have to be sent to international culture collections. Then a paper must be published describing the new organism and providing a genus and species name. You recall learning about this in your Microbiology course in college. Is this information from your colleague true or false? True Falsearrow_forwardis often a good indication of phylogenetic relatedness in phenotypes. Life-cycle patterns Cleavage patterns O Gene expression O Morphological similarityarrow_forward
- Which of the following is a weakness of using 16S rRNA for phylogenetic analyses? It can only go down to the family and genus levels It takes months to complete O Both of the above O None of the abovearrow_forwardAn unrooted tree containing ten unrelated species can become rooted by adding a descendant group related to two of the species. an unrelated outgroup. O a distantly related outgroup. O a descendant related to only one of the species.arrow_forwardWhat is the most appropriate purpose of building a phylogenetic tree? They look awesome You can use a tree to compare morphological characteristics of organisms It can be used to establish and analyze evolutionary relationships between species All of the abovearrow_forward
- Which of the following sequencing techniques can identify down to the strain level? O Multilocus sequence typing Genomic fingerprinting Whole genome sequencing OSNP analysis All of the abovearrow_forwardWhat is the "gold standard" that is currently applied to species designations in microbiology? 97% between species: 50% among whole genome 90% between species: 75% among whole genome 99% between species; 97% among whole genome 97% between species: 70% among whole genome Onone of the abovearrow_forwardYou will use the following scenario to answer a group of 5 questions. You have isolated a microbe from an environmental sample. The microbe has the ability to perform a new metabolic reaction at a very low temperature, so you are excited that it could be a new species. You have decided to send your sample off for sequencing. You need to determine which type of sequencing to use for the preliminary identification of your species. You decide that, for now, you only need to be able to identify the family and genus levels. Which type of sequencing do you think is the most appropriate? O Genomic Fingerprinting O Whole Genome Sequencing O 16S rDNA Sequencing O DNA-DNA hybridization Nextarrow_forward
- Human Anatomy & Physiology (11th Edition)BiologyISBN:9780134580999Author:Elaine N. Marieb, Katja N. HoehnPublisher:PEARSONBiology 2eBiologyISBN:9781947172517Author:Matthew Douglas, Jung Choi, Mary Ann ClarkPublisher:OpenStaxAnatomy & PhysiologyBiologyISBN:9781259398629Author:McKinley, Michael P., O'loughlin, Valerie Dean, Bidle, Theresa StouterPublisher:Mcgraw Hill Education,
- Molecular Biology of the Cell (Sixth Edition)BiologyISBN:9780815344322Author:Bruce Alberts, Alexander D. Johnson, Julian Lewis, David Morgan, Martin Raff, Keith Roberts, Peter WalterPublisher:W. W. Norton & CompanyLaboratory Manual For Human Anatomy & PhysiologyBiologyISBN:9781260159363Author:Martin, Terry R., Prentice-craver, CynthiaPublisher:McGraw-Hill Publishing Co.Inquiry Into Life (16th Edition)BiologyISBN:9781260231700Author:Sylvia S. Mader, Michael WindelspechtPublisher:McGraw Hill Education