The appropriate heat treatment in terms of temperature and time.

Question

Want to see the full answer?

Answer 1

Question

Chapter 5, Problem 3DP

To determine

The appropriate heat treatment in terms of temperature and time.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

a. Determine the effective area for the case shown in the figure below. Suppose that l = 6 in. For L5 × 5 × 5/8: A₁ = 5.90 in.², = 1.47 in. L5 × 5 × 5/8 Weld (Express your answer to three significant figures.) A₁ = in.² b. Determine the effective area for the case shown in the figure below. Suppose that l = 5 in. PL³/8 X 4 Weld (Express your answer to three significant figures.) Ae = in.2 2 c. Determine the effective area for the case shown in the figure below. -5" PL5/8 X 5 Weld (Express your answer to three significant figures.) Ae in.2 d. Determine the effective area for the case shown in the figure below. 2" 2" PL1/2 X 512 ос 3/4-in.-diam. bolts (Express your answer to three significant figures.) Ae = in.² e. Determine the effective area for the case shown in figure below. PL³/8 X 6 7/8-in.-diam. bolts (Express your answer to three significant figures.) Ae= in.2

The net force exerted on the piston by the exploding fuel-air mixture and friction is 5 kN to the left. A clockwise couple M = 200 N-m acts on the crank AB. The moment of inertia of the crank about A is 0.0003 kg-m2 . The mass of the connecting rod BC is 0.36 kg, and its center of mass is 40 mm from B on the line from B to C. The connecting rod’s moment of inertia about its center of mass is 0.0004 kg-m2 . The mass of the piston is 4.6 kg. The crank AB has a counterclockwise angular velocity of 2000 rpm at the instant shown. Neglect the gravitational forces on the crank, connecting rod, and piston – they still have mass, just don’t include weight on the FBDs. What is the piston’s acceleration?

A single-angle tension member of A36 steel must resist a dead load of 35 kips and a live load of 84 kips. The length of the member is 18 feet, and it will be connected with a single line of 1- inch-diameter bolts, as shown in the figure below. There will be four or more bolts in this line. For the steel Fy = 36 ksi and F₁ = 58 ksi. Try the tension members given in the table below. Tension member rz (in.) A, (in.²) L6 × 6 × 9.75 1.17 L 5 × 3 × 1/10 4.93 0.746 L5 × 3 × 16 5 2.56 0.758 L5 × 3 × 166 3.31 0.644 Bolt line a. Select a single-angle tension member to resist the loads. Use LRFD. A) L 6 × 6 × B) L 5 × 3 × C) L5 × 3 X D) L 5 × 3 × 6 -Select- V What is the required gross area? (Express your answer to three significant figures.) Ag = in.2 What is the required effective area? (Express your answer to three significant figures.) Ae = in.2 What is the minimum radius of gyration? (Express your answer to three significant figures.) 1min = in. b. Select a single-angle tension member to…