Concept explainers
In which diagram do the physical locations of the wiring and the devices match the drawing?
Explain in which diagram the physical locations of the wiring and the devices match.
Answer to Problem 1SQ
The physical locations of the wiring and the devices match in wiring diagrams.
Explanation of Solution
Discussion:
Most of the electrical circuits can be represented by two types of diagrams; they are as follows:
- 1. Wiring diagram
- 2. Line diagram
In a wiring diagram, physical relation among all devices in the system can be shown.
The wiring diagrams are mostly useful in wiring circuits because the connections can be made exactly as they appear on the circuit diagram.
The line diagrams are also called as schematic, elementary, and ladder diagrams. It is also used to represent the electrical circuits in the simplest possible manner.
Conclusion:
Thus, the physical locations of the wiring and the devices match in wiring diagrams.
Want to see more full solutions like this?
Chapter 5 Solutions
Electric Motor Control
- What does the circuit work like?arrow_forward12. Which Insulators can be used for both horizontal and vertical positioning? A. SUSPENSION TYPE INSULATORS B. SHACKLE TYPE INSULATORS C. PIN TYPE INSULATORS D. POST TYPE INSULATORSarrow_forwardWhat is the importance of electrical wiring symbols and diagrams used in the electrical plan?arrow_forward
- What's the maximum number of conductors a split-bolt connector can connect to, unless the labeling indicates that more conductors can be spliced? A. 2 B. 1 C. 5 D. 3arrow_forwardList the different Wire Gauge and its uses. Note: Typical wires at home.arrow_forwardWe are running 3 wires and a ground in a RMC to a control panel with a 60 amp circuit breaker disconnect in the control panel. The conduit is run along the ceiling where the ambient air temperature is 100 degrees. The control panel feeds our secondary cooling pump. What size are the ungrounded conductors? All conductors have typeTHHN insulation. A #6 AWG B 600 Kcmil C #8 AWG D #2 AWG What size RMC do we need? A 3" B 3/4" C 1" D 1 1/2"arrow_forward
- Create an electrical diagram.: Lamps A and D are controlled individually by a single pole switch in one location and Lamps B and C are controlled by a single pole switch. Have one master switch for all lightings.arrow_forwardHi, for electric circuits with both current and voltage sources present what is the fastest way to do the analysis manually?arrow_forwardComplete the information in the table about rotary switch 8 way and micro switcharrow_forward
- EBK ELECTRICAL WIRING RESIDENTIALElectrical EngineeringISBN:9781337516549Author:SimmonsPublisher:CENGAGE LEARNING - CONSIGNMENTElectricity for Refrigeration, Heating, and Air C...Mechanical EngineeringISBN:9781337399128Author:Russell E. SmithPublisher:Cengage Learning