What occurs when a wheel hits a dip or hole and moves downward? a. Jounce b. Free length c. Deflection d. Rebound

Q: Outer Bearing Nut Lock Inner Bearing Thrust Washer Spindle Oil Seal 01100 Hub Сaр Cotter Pin Nut…

A: tapered wheel  as Follows

Q: The moment of a couple is called a a. Free b. Spinning c. Fixed d. Sliding vector.

A: It is asked, what is moment of a couple called, four options are given - a) Free   b) spinning  c)…

Q: Explain the Jog/shuttle mechanism.

A: The explanation about the Jog/shuttle is given as under.

Q: What is the safest way to drive a forklift in reverse? Keep your eye on the load, but turn around…

A: 11. Steel jacks are mainly needed to provide support to the trailer jack. When the trailer is…

Q: The axle of a front wheel of a bicycle shall belong to_____. A.Rotating shaft B. Drive shaft…

A: I think its answer should be part C- mandrel.

Q: When trying to accommodate only axial loading, which of the following bearings is most likely to be…

A: (a) Tapered roller bearing This type of bearing is used in the places where, vertical and horizontal…

Q: GIVEN: Solid steel shaft shown below with a 12 mm diameter. Gstee = 80 x 10° N/m² E 40 N-m 280 N-m…

A: Given, d = 12 mm = 0.012 mGsteel = 80 × 109 N/m2LAC = 0.4 mLCD = 0.3 mLDE = 0.5 m   From diameter,…

Q: identify the tapered and drive axle bearing parts in the drawing. Place the identifying letter nexe…

A: Tapered roller bearings contain tapered inner and outer ring raceways with tapered rollers…

Q: When discussing axle hub nuts, Technician A says that they are never to be reused after they have…

A: Solution:

Q: Design for 95% male grip force. Use a minimum factory of safety of 2.50. Determine dimensions not…

A: By using the above data and some engineering principles, we can calculate the value of dimension C…

Q: When reviewing the service procedures for CV joints and drive axles, Technician A says that the axle…

A: The axle can be used as a slide hammer to help remove a stubborn inboard joint from the transaxle as…

Q: Instructions: Identify the tapered and drive axle bearing parts in the drawing. Place the…

A: Tapered roller bearings contain tapered inner and outer ring raceways with tapered rollers…

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.