The possible consequences of the industrialization of countries on the world’s demand for geologic resources. Also determine source of the geological resources that will be needed by the world’s population. Introduction: The ecological footprint or the amount of resources used by an individual in the United States is much more than that is used by an individual from developing countries. The U.S contains only 6% of the world population which uses around 15%-40% of the world’s production of many resources. Industrialization was brought about by the great industrial revolution of the twentieth century. Due to this, the world population increased tremendously over the years, and led to the over-exploitation of the natural geological resources.

Question

Want to see the full answer?

Answer 1

Question

Chapter 22, Problem 1EYK

Summary Introduction

The possible consequences of the industrialization of countries on the world’s demand for geologic resources. Also determine source of the geological resources that will be needed by the world’s population.

Introduction:

The ecological footprint or the amount of resources used by an individual in the United States is much more than that is used by an individual from developing countries. The U.S contains only 6% of the world population which uses around 15%-40% of the world’s production of many resources. Industrialization was brought about by the great industrial revolution of the twentieth century. Due to this, the world population increased tremendously over the years, and led to the over-exploitation of the natural geological resources.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

44) In periglacial environments, the layer of ground that thaws every summer and freezes every winter is called A) frost layer B) permafrost C) active layer D) discontinuous permafrost

Use the attached piezometer map to make your own, clean version of the map, and indicate the elevation of the water table at all piezometer locations. Draw equipotential lines (lines of equal water table elevation) using regular intervals – creating a contoured map of the water table. Determine the direction of groundwater flow based on the horizontal gradient. Label the areas of recharge and discharge directly on your map. Flow lines: Draw flow lines on your water table map. The lines should be at right angles to the equipotential lines and extend from the recharge area to the discharge area. Hydraulic Gradient, Specific Discharge (Darcy Flux), Average Linear Velocity: Using your water table map, estimate an average hydraulic gradient between two locations, call them locations A and B, one at the eastern-most and a second at the western-most extent of your dataset (note the north arrow on the map). Calculate the specific discharge, q, between the two locations. For this calculation…

Calculate all the values of table 1: Q in (L/day) Q out (L/day) Residence time (days) Please show all steps