The function of controls rods, the substance used to prepare them and the reason for their use in the nuclear power reactor is to be determined. Concept Introduction: The control rods in nuclear power reactor made up of boron or cadmium used for controlling the chain reaction. It absorbs extra neutrons present in the chain reaction and maintains it to the moderate level. The cadmium and boron are used in control rods because it absorbs neurons and converts into the non radioactive isomer. To determine: The functions of control rods, the substances used to prepare them; also the reason for their use in the nuclear power reactors.

Question

Want to see the full answer?

Answer 1

Question

Chapter 21, Problem 59E

Interpretation Introduction

Interpretation: The function of controls rods, the substance used to prepare them and the reason for their use in the nuclear power reactor is to be determined.

Concept Introduction: The control rods in nuclear power reactor made up of boron or cadmium used for controlling the chain reaction. It absorbs extra neutrons present in the chain reaction and maintains it to the moderate level. The cadmium and boron are used in control rods because it absorbs neurons and converts into the non radioactive isomer.

To determine: The functions of control rods, the substances used to prepare them; also the reason for their use in the nuclear power reactors.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

In an effort to reduce costs and increase the accessibility of instruments that utilize spectrophotometric detection, some researchers are beginning to experiment with 3D-printed parts. One example of this is the 3D-printed flow cell, shown at right. This device was made using polylactic acid and accommodates a LED at one end and a detector at the other. It can be used for standalone flow injection spectrophotometry or coupled to a chromatographic separation to be used as a detector. Explain why the sensitivity varies with the length of the flow cell, as shown in the data below. Could this setup be used for fluorescence analysis? Why or why not?

The dark lines in the solar spectrum were discovered by Wollaston and cataloged by Fraunhofer in the early days of the 19th century. Some years later, Kirchhoff explained the appearance of the dark lines: the sun was acting as a continuum light source and metals in the ground state in its atmosphere were absorbing characteristic narrow regions of the spectrum. This discovery eventually spawned atomic absorption spectrometry, which became a routine technique for chemical analysis in the mid-20th century. Laboratory-based atomic absorption spectrometers differ from the original observation of the Fraunhofer lines because they have always employed a separate light source and atomizer. This article describes a novel atomic absorption device that employs a single source, the tungsten coil, as both the generator of continuum radiation and the atomizer of the analytes. A 25-μL aliquot of sample is placed on the tungsten filament removed from a commercially available 150-W light bulb. The…

Don't used hand raiting and don't used Ai solution