The surveyor’s authority if the line established is agreeable to both clients. It is the surveyor’s responsibility to resolve any dispute that exists between the parties involved. Disputes between two neighborsregarding their boundary line should be at first tried to be solved by l cooperation if parties are not ready to set any compromise then the surveyor should act asthe witness ofthe legal proceedings. The surveyor’s authority or responsibility if the line established is agreeable to both clients is to go for the written agreement of acompromise between the parties involved.

Question

Want to see the full answer?

Answer 1

Question

Chapter 21, Problem 21.17P

(a)

To determine

The surveyor’s authority if the line established is agreeable to both clients.

It is the surveyor’s responsibility to resolve any dispute that exists between the parties involved. Disputes between two neighborsregarding their boundary line should be at first tried to be solved by l cooperation if parties are not ready to set any compromise then the surveyor should act asthe witness ofthe legal proceedings.

The surveyor’s authority or responsibility if the line established is agreeable to both clients is to go for the written agreement of acompromise between the parties involved.

(b)

To determine

The surveyor’s authority if the line established is not accepted by one or both clients.

It is the surveyor’s responsibility to resolve any dispute that exists between the parties involved. Disputes between two neighbors regarding their boundary line should be at first tried to be solved by cooperation if parties are not ready to set any compromise then the surveyor should act as witness of the legal proceedings.

The surveyor’s authority if the line established is not accepted by one or both clients then the disputes can’t be solved by mutual compromise. Here boundaries must be established by legal proceedings of the court where surveyor will be an expert witness.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The dam presented below is 180 m long (in the direction perpendicular to the plane of the cross-section). For the water elevations given on the drawing: a) Construct the flow net (minimum number of equipotential lines should be 10), b) Calculate the rate of seepage for the entire dam, c) Find the total uplift force on the dam (ignore barriers), and d) Estimate the hydraulic gradient at points A, B, and D. Recommended to use a spreadsheet to include all equations for calculations of potentials.

Using A36 steel select the lightest equal leg single angle member to resist a factored (LRFD) tensile load Pu = 167 kips. The member will be connected through one leg with one line of three 3/4-in Ø bolts spaced at 3 in between centers as shown. The edge distances Leh = Lev = 1.5 in. Use LRFD Method Use U from Table D3.1, Case 8. See attached (D3.1 Case 8, Shear Strength of Bolts, Table 1-7 Dimensions of Angles).

The system in Fig. consists of 1200 m of 5 cm cast-iron pipe e=0.26mm, two 45° and four 90° elbows, a globe valve, and a sharp exit into a reservoir. If the elevation at point 1 is 400 m, what gage pressure is required at point 1 to deliver 0.005 m3/s of water into the reservoir? U= 10-6m² 1 * sec -, K 45° elbows= 0.2, K 90° flanged = 0.2, K globe valve 10, K Sharp exit=1 G Elevation 500 m 45° Open globe 45° Sharp exit