Reading of the galvanometer linked to the coil.

Question

Want to see more full solutions like this?

Answer 1

Question

Chapter 21, Problem 1OQ

To determine

Reading of the galvanometer linked to the coil.

Expert Solution & Answer

Answer to Problem 1OQ

Solution:

E. current spikes as the magnet enters the coil, then a current sparks in the opposite direction as the magnet exits the coil.

Explanation of Solution

when the bar magnet is inserted down into the coil of wire, magnetic flux linked with the changes, an induced EMF and hence the induced current is set up in it.

When the bar magnet is left in the coil for one minute, there will be no change in flux linked with the coil, so no induced current would be produced.

When the bar magnet come out of the coil again, magnetic flux linked with the coil changes, an induced EMF and hence, an induced current is set up in the coil in the opposite direction.

Conclusion: Whenever the magnetic flux linked with a closed-circuit change, an induced EMF and hence, an induced current is set up in it.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Students have asked these similar questions

Four capacitors are connected as shown in the figure below. (Let C = 12.0 μF.) a C 3.00 με Hh. 6.00 με 20.0 με HE (a) Find the equivalent capacitance between points a and b. 5.92 HF (b) Calculate the charge on each capacitor, taking AV ab = 16.0 V. 20.0 uF capacitor 94.7 6.00 uF capacitor 67.6 32.14 3.00 µF capacitor capacitor C ☑ με με The 3 µF and 12.0 uF capacitors are in series and that combination is in parallel with the 6 μF capacitor. What quantity is the same for capacitors in parallel? μC 32.14 ☑ You are correct that the charge on this capacitor will be the same as the charge on the 3 μF capacitor. μC

In the pivot assignment, we observed waves moving on a string stretched by hanging weights. We noticed that certain frequencies produced standing waves. One such situation is shown below: 0 ст Direct Measurement ©2015 Peter Bohacek I. 20 0 cm 10 20 30 40 50 60 70 80 90 100 Which Harmonic is this? Do NOT include units! What is the wavelength of this wave in cm with only no decimal places? If the speed of this wave is 2500 cm/s, what is the frequency of this harmonic (in Hz, with NO decimal places)?

Four capacitors are connected as shown in the figure below. (Let C = 12.0 µF.) A circuit consists of four capacitors. It begins at point a before the wire splits in two directions. On the upper split, there is a capacitor C followed by a 3.00 µF capacitor. On the lower split, there is a 6.00 µF capacitor. The two splits reconnect and are followed by a 20.0 µF capacitor, which is then followed by point b. (a) Find the equivalent capacitance between points a and b. µF(b) Calculate the charge on each capacitor, taking ΔVab = 16.0 V. 20.0 µF capacitor µC 6.00 µF capacitor µC 3.00 µF capacitor µC capacitor C µC

Answer 2

Question

Chapter 21, Problem 1OQ

To determine

Reading of the galvanometer linked to the coil.

Expert Solution & Answer

Answer to Problem 1OQ

Solution:

E. current spikes as the magnet enters the coil, then a current sparks in the opposite direction as the magnet exits the coil.

Explanation of Solution

when the bar magnet is inserted down into the coil of wire, magnetic flux linked with the changes, an induced EMF and hence the induced current is set up in it.

When the bar magnet is left in the coil for one minute, there will be no change in flux linked with the coil, so no induced current would be produced.

When the bar magnet come out of the coil again, magnetic flux linked with the coil changes, an induced EMF and hence, an induced current is set up in the coil in the opposite direction.

Conclusion: Whenever the magnetic flux linked with a closed-circuit change, an induced EMF and hence, an induced current is set up in it.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 3

Question

Chapter 21, Problem 1OQ

To determine

Reading of the galvanometer linked to the coil.

Expert Solution & Answer

Answer to Problem 1OQ

Solution:

E. current spikes as the magnet enters the coil, then a current sparks in the opposite direction as the magnet exits the coil.

Explanation of Solution

when the bar magnet is inserted down into the coil of wire, magnetic flux linked with the changes, an induced EMF and hence the induced current is set up in it.

When the bar magnet is left in the coil for one minute, there will be no change in flux linked with the coil, so no induced current would be produced.

When the bar magnet come out of the coil again, magnetic flux linked with the coil changes, an induced EMF and hence, an induced current is set up in the coil in the opposite direction.

Conclusion: Whenever the magnetic flux linked with a closed-circuit change, an induced EMF and hence, an induced current is set up in it.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 4

Question

Chapter 21, Problem 1OQ

To determine

Reading of the galvanometer linked to the coil.

Expert Solution & Answer

Answer to Problem 1OQ

Solution:

E. current spikes as the magnet enters the coil, then a current sparks in the opposite direction as the magnet exits the coil.

Explanation of Solution

when the bar magnet is inserted down into the coil of wire, magnetic flux linked with the changes, an induced EMF and hence the induced current is set up in it.

When the bar magnet is left in the coil for one minute, there will be no change in flux linked with the coil, so no induced current would be produced.

When the bar magnet come out of the coil again, magnetic flux linked with the coil changes, an induced EMF and hence, an induced current is set up in the coil in the opposite direction.

Conclusion: Whenever the magnetic flux linked with a closed-circuit change, an induced EMF and hence, an induced current is set up in it.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 5

Chapter 21, Problem 1OQ

To determine

Reading of the galvanometer linked to the coil.

Expert Solution & Answer

Answer to Problem 1OQ

Solution:

E. current spikes as the magnet enters the coil, then a current sparks in the opposite direction as the magnet exits the coil.

Explanation of Solution

when the bar magnet is inserted down into the coil of wire, magnetic flux linked with the changes, an induced EMF and hence the induced current is set up in it.

When the bar magnet is left in the coil for one minute, there will be no change in flux linked with the coil, so no induced current would be produced.

When the bar magnet come out of the coil again, magnetic flux linked with the coil changes, an induced EMF and hence, an induced current is set up in the coil in the opposite direction.

Conclusion: Whenever the magnetic flux linked with a closed-circuit change, an induced EMF and hence, an induced current is set up in it.

Answer 6

Chapter 21, Problem 1OQ

To determine

Reading of the galvanometer linked to the coil.

Expert Solution & Answer

Answer to Problem 1OQ

Solution:

E. current spikes as the magnet enters the coil, then a current sparks in the opposite direction as the magnet exits the coil.

Explanation of Solution

when the bar magnet is inserted down into the coil of wire, magnetic flux linked with the changes, an induced EMF and hence the induced current is set up in it.

When the bar magnet is left in the coil for one minute, there will be no change in flux linked with the coil, so no induced current would be produced.

When the bar magnet come out of the coil again, magnetic flux linked with the coil changes, an induced EMF and hence, an induced current is set up in the coil in the opposite direction.

Conclusion: Whenever the magnetic flux linked with a closed-circuit change, an induced EMF and hence, an induced current is set up in it.

Answer 7

Chapter 21, Problem 1OQ

To determine

Reading of the galvanometer linked to the coil.

Answer 8

Expert Solution & Answer

Answer to Problem 1OQ

Solution:

E. current spikes as the magnet enters the coil, then a current sparks in the opposite direction as the magnet exits the coil.

Answer 9

Expert Solution & Answer

Answer 10

Expert Solution & Answer

Answer 11

Explanation of Solution

when the bar magnet is inserted down into the coil of wire, magnetic flux linked with the changes, an induced EMF and hence the induced current is set up in it.

When the bar magnet is left in the coil for one minute, there will be no change in flux linked with the coil, so no induced current would be produced.

When the bar magnet come out of the coil again, magnetic flux linked with the coil changes, an induced EMF and hence, an induced current is set up in the coil in the opposite direction.

Conclusion: Whenever the magnetic flux linked with a closed-circuit change, an induced EMF and hence, an induced current is set up in it.