Define elastic and plastic behaviors at the micro and macro levels.
Define elastic and plastic behaviors at the micro and macro levels.
Explanation of Solution
Elasticity:
It is the property by which the object retrieves its original form on removal of applied force.
Plasticity:
It is the tendency of a substance to undergo permanent deformation while a load is applied to it.
At a micro level, the objects are very small. Hence, the object does not experience deformation effortlessly on use of force. Plasticity is lesser than its elasticity.
At a macro level, deformation is estimated by the Hooke’s law. As indicated by this law, stress is proportional to strain within an elastic limit. Materials for which this law is appropriate are called as linearly elastic materials.
Want to see more full solutions like this?
Chapter 2 Solutions
Materials for Civil and Construction Engineers (4th Edition)
Additional Engineering Textbook Solutions
Elementary Surveying: An Introduction To Geomatics (15th Edition)
Foundation Design: Principles and Practices (3rd Edition)
Structural Analysis (10th Edition)
Elementary Surveying (14th Edition)
Artificial Intelligence: A Modern Approach
Starting Out with Java: From Control Structures through Data Structures (3rd Edition)
- Explain in detail the relationship between stress and strain for non linear elastic material . Also explain why non linear elastic material does follow Hook's Law.arrow_forwardOn the stress-strain diagram of a steel bar, show and explain the following: proportional limit, yield stress, ultimate stress, yield strain, and modulus of elasticity.arrow_forwardExplain in detail the effect of Temperature on the Elastic Modulus and Yield Strength ofEngineering materials.arrow_forward
- I need the answer as soon as possiblearrow_forwardExplain the relationship between the toughness, stress and strain of a material. 2. Explain the relationship between the toughness and ductility of a material.arrow_forwardTwo bars of different materials and same size are subjected to the same tensile force. If the bars have unit elongation in the ratio 2: 5, then the ratio of modulus of elasticity of the two materials will be (a) 2:5 (c) 4 :3 (b) 5:2 (d) 3:4arrow_forward
- Discuss the concept of strain hardening in materials?arrow_forwardA 19-mm reinforcing steel bar and a gauge length of 75 mm was subjected to tension, with the results shown in Table Using a computer spreadsheet program, plot the stress–strain relationship. From the graph, determine the Young’s modulus of the steel and the deformation corresponding to a 150-kN load.arrow_forward1. The tensile strength vs. temperature curves of aluminum are plotted below. Explain the meaning of these two curves. 400 Ultimate strength 300 Yield strength 200 100 -200 -150 -100 -50 50 100 150 200 250 Temperature, °C Strength, kPaarrow_forward
- On the diagram, what is point 1?arrow_forwardA steel rod with length equal to 7.5 ft, has a diameter of 0.78 inches in quarter of its length and a diameter of 0.38 inches the rest. If it is subjected to a tensile load of 6,000 lbs, what will be the tótal deformation of the bar if it has a modulus of elasticity E= 28.5 x 10^6 psi. %3D O 0.1378 inches O 0.1338 inches O 0.1352 inches O 0.1364 inches O 0.1423 inchesarrow_forwardThe thermal stresses in structural members are an important but generally ignored part of the overall structural analysis procedure. At times, these are of the order of load induced stresses as well which makes them worth the attention. Write a short note on the importance of recognising and evaluating thermal stresses in structures and also compare them with load induced stresses.arrow_forward
- Materials Science And Engineering PropertiesCivil EngineeringISBN:9781111988609Author:Charles GilmorePublisher:Cengage Learning