Answer for A, and the answer has to be in mm A cylinder that has a 45.0-cm radius and is 50.0 cm deep is filled with air at 19.5°C and 1.00 atm shown in figure (a). A 21.0-kg piston is now lowered into the cylinder, compressing the air trapped inside as it takes equilibrium height h; as shown in figure (b). Finally, a21.5-kg dog stands on the piston, further compressing the air, which remains at 19.5°C as shown in figure (c).Ah50.0 cmh;(a) How far down (Ah) does the piston move when the dog steps onto it?mm(b) To what temperature should the gas be warmed to raise the piston and the dog back to h,?°CAdditional Materials1 eBook

Radius of the cylinder is r=45 cm Height of the cylinder is H=50 cm Temperature of the air is T=19.5…

A cylinder that has a 45.0-cm radius and is 50.0 cm deep is filled with air at 19.5°C and 1.00 atm shown in figure (a). A 21.0-kg piston is now lowered into the cylinder, compressing the air trapped inside as it takes equilibrium height hị as shown in figure (b). Finally, 21.5-kg dog stands on the piston, further compressing the air, which remains at 19.5°C as shown in figure (c). Ah 50.0 ст a (a) How far down (Ah) does the piston move when the dog steps onto it? mm (b) To what temperature should the gas be warmed to raise the piston and the dog back to h,?

A cylinder that has a 45.0-cm radius and is 50.0 cm deep is filled with air at 19.5°C and 1.00 atm shown in figure (a). A 21.0-kg piston is now lowered into the cylinder, compressing the air trapped inside as it takes equilibrium height hị as shown in figure (b). Finally, 21.5-kg dog stands on the piston, further compressing the air, which remains at 19.5°C as shown in figure (c). Ah 50.0 ст a (a) How far down (Ah) does the piston move when the dog steps onto it? mm (b) To what temperature should the gas be warmed to raise the piston and the dog back to h,?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Convert the following measurements to metric units with power-of-ten prefixes. Do not use scientific or engineering notation. Numeric values must range from 1 to less than 1000. Metric prefixes, which are case-sensitive, must be one of the following: M, m, c, k, or µ. (You may use lower-case 'u' in place of 'p'.) Example: 2.00 × 105 m = 200 km Enter the numeric value in the first box, and enter the metric prefix in the second box. a. 3.51 x 10-5 L = b. 7.98 x 108 J = C. -0.000230 W = - W d. 11,200 K = K (note: upper-case 'K' is the abbreviation for the temperature unit 'kelvin')
An astronomical unit (AU) is the average distance between the Earth and the Sun, approximately 1.50 × 10° km. The speed of light is about 3.00 x 10° m/s. Express the speed of light in astronomical units per minute. Number Units
In the equation F= xt +yt?, F = Force and t= time. The dimensions of x and y respectively are O a. MLT-1 & MLTO Ob. MLT1 & MLT2 O. ML-'T & MLTO O d. M°LT-1 & MLT
The wheel of an odometer has a radius of 30.00 cm. It was used to measure the distance between two stations A and B. If the odometer counter reads 226. How far is the distance from A to B? Express your answer in meters.
Pls help ASAP. Pls give the significant figures of each of the answer.
Q8 A variable Wis reported to have a value of 4.612* 10° g.cm/sec. Write a dimensional equation for W the equivalent variable value expressed in American Engineering units using hours as unit for time?
A prism with square base each side with length x, height h.The measurements are: x = 25.3 +/- 0.5 cm h = 35 +/- 0.3 cm %3D so the volume is V = h.x? The reported volume is V + 8V find SV in cm3. Answer to first decimal place. given av 2xh %3D
The number of significant digits is set to 2
The number of significant digits is set to 2
Convert 0.20 m²/s into micro m²/min considering significant figures
The amount of water in reservoirs is often measured in acre-ft. One acre-ft is a volume that covers an area of one acre to a depth of one foot. An acre is 43,560 ft2. Find the volume in SI units of a reservoir containing 35.0 acre-ft of water. m3
Find the dimensions of the quantity in the equation, An 2nV 2m(Uo - En) O L O T O L·T O L·M/ T2 O M O L/T2