The pressure, temperature, velocity, Mach number, and stagnation pressure downstream of the shock and Compare for helium undergoing a normal shock under the same conditions.
Answer to Problem 90P
The Mach number value of air after the normal shock through the nozzle is
The actual temperature of air after the normal shock through the nozzle
is
The actual pressure of air after the normal shock through the nozzle is
The stagnation pressure of air after the normal shock though the nozzle
is
The velocity of air after the normal shock through the nozzle is
Thus, the Mach number of helium gas after the normal shock through the nozzle
is
Thus, the actual temperature of helium after the normal shock through the nozzle is
Thus, the actual pressure of helium after the normal shock through the nozzle
is
Thus, the stagnation pressure of helium after the normal shock though the nozzle
is
Thus, the velocity of helium after the normal shock through the nozzle is
Comparison between the obtained results of air and helium is shown in below Table:
Parameters/ Conditions | Air | Helium |
Mach number value | ||
Actual temperature of air | ||
Actual pressure of air | ||
Stagnation pressure | ||
Velocity |
Explanation of Solution
Write the expression for the velocity of sound after the normal shock.
Here, velocity of sound after the shock is
Write the expression for the velocity of airafter the normal shock.
Write the expression for the Mach number for helium after the normal shock.
Here, Mach number of helium before the normal shock is
before the normal shock is
Write the expression for the actual pressure of helium gas after the normal shock.
Here, actual pressure of helium after the shock is
Write the expression for the actual temperature of helium gas after the normal shock.
Here, actual temperature of helium after the shock is
Write the expression for the actual pressure of helium gas after the normal shock.
Here, stagnation pressure of helium after the shock is
Write the expression for the velocity of sound after the normal shock.
Here, velocity of sound after the shock is
Write the expression for the velocity of helium after the normal shock.
Conclusion:
Refer to Table A-33, “One-dimensional normal-shock functions for an ideal gas with k 5 1.4”, obtain the expressions of temperature ratio, pressure ratio, stagnation pressure ratio, and Mach number after the shock for a Mach number of 2.6 before the shock.
Thus, the Mach number value of air after the normal shock through the nozzle is
Here, actual pressure after the shock is
Substitute
Thus, the actual temperature of air after the normal shock through the nozzle
is
Substitute
Thus, the actual pressure of air after the normal shock through the nozzle is
The actual pressure before the normal shock is the same as the stagnation pressure before the normal shock
Substitute
Thus, the stagnation pressure of air after the normal shock though the nozzle
is
Refer to thermodynamics properties table and interpret the value of k, and R for a temperature of
Substitute 1.4 for k,
Substitute 0.5039for
Thus, the velocity of air after the normal shock through the nozzle is
Substitute 2.6for
Thus, the Mach number of helium gas after the normal shock through the nozzle
is
Substitute 1.667 for k, 2.6for
Substitute 1.667 for k, 2.6for
Substitute 1.667 for k, 2.6for
Substitute
Thus, the actual temperature of helium after the normal shock through the nozzle is
Substitute
Thus, the actual pressure of helium after the normal shock through the nozzle
is
Since,
Substitute
Thus, the stagnation pressure of air after the normal shock though the nozzle
is
Refer Table A–1, “Molar mass, gas constant, and critical2point properties”, obtain
the value of k, and R for a temperature of
Substitute 1.667 for k,
Substitute 0.5455 for
Thus, the velocity of air after the normal shock through the nozzle is
Want to see more full solutions like this?
Chapter 17 Solutions
THERMODYNAMICS: ENG APPROACH LOOSELEAF
- Nitrogen enters a converging–diverging nozzle at 620 kPa and 310 K with a negligible velocity, and it experiences a normal shock at a location where the Mach number is Ma = 3.0. Calculate the pressure, temperature, velocity, Mach number, and stagnation pressure downstream of the shock. Compare these results to those of air undergoing a normal shock at the same conditions.arrow_forwardAir flowing at 32 kPa, 240 K, and Ma1 = 3.6 is forced to undergo an expansion turn of 15°. Determine the Mach number, pressure, and temperature of air after the expansion.arrow_forwardConsider air entering a heated duct at p1 = 1 atm and T1 = 288 K. Ignore the effect of friction. Calculate the amount of heat per unit mass (in joules per kilogram) necessary to choke the flow at the exit of the duct for an inlet Mach number of M1 = 2.2.arrow_forward
- Ahead of the normal shock wave, the upstream pressure, temperature, and Mach number are O.53 atm, 255 K, and 2.8, respectively. Determine the Mach number downstream of the shock wave.arrow_forwardQ1: Air enters a converging-diverging nozzle of a supersonic wind tunnel at 1 MPa and 300 K with a low velocity. If a normal shock wave occurs at the exit plane of the nozzle at Ma = 2.4, determine the pressure, temperature, Mach number, velocity, and stagnation pressure after the shock wave.arrow_forwardMach number at a certain section in a diverging part of a c-d nozzle is 0.7. At farther section (towards the exit), Mach number reduces to 0.4. Hence, the cross-sectional area of the farther section is greater byarrow_forward
- In compressible flow, velocity measurements with a Pitot probe can be grossly in error if relations developed for incompressible flow are used. Therefore, it is essential that compressible flow relations be used when evaluating flow velocity from Pitot probe measurements. Consider supersonic flow of air through a channel. A probe inserted into the flow causes a shock wave to occur upstream of the probe, and it measures the stagnation pressure and temperature to be 620 kPa and 340 K, respectively. If the static pressure upstream is 110 kPa, determine the flow velocity.arrow_forwardAir flowing steadily in a nozzle experiences a normal shock at a Mach number of Ma = 2.6. The pressure and temperature of air are 52 kPa and 270 K, respectively. Now, helium undergoes a normal shock under the same conditions. Calculate the entropy changes of air and helium across the normal shock. The properties of air are R = 0.287 kJ/kg-K and cp= 1.005 kJ/kg-K, and the properties of helium are R=2.0769 kJ/kg-K and cp=5.1926 kJ/kg.K. The entropy change for air is The entropy change for helium is kJ/kg-K. kJ/kg-K.arrow_forward1. Find the pressure of air at a point in a stream where M equals 1.8 when the pressure and Mach number at another point in the stream are 25 psia and 0.8 respectively. Assume isentropic conditions. 2. Air having a reservoir pressure of 30 psia and density of 0.15 lb/ft is accelerated to a Mach number of 1.6. Find the static pressure, density, and temperature at this Mach number. 3. Consider the flow of air through a supersonic nozzle. The reservoir pressure and temperature are 5 atm and 500 K, respectively. If the Mach number at the nozzle exit is 3, calculate the exit pressure , temperature, and density. 4. A supersonic nozzle is a convergent-divergent duct , which is fed by a large reservoir at the inlet to the nozzle. In the reservoir of the nozzle, the pressure and temperature are 10atm and 550°R , respectively. At the nozzle exit, the pressure is 1 atm. Calculate the temperature and density of the flow at the exit. Assume the flow is isentropic and , of course, compressible. 5.…arrow_forward
- Ahead of the normal shock wave, the upstream pressure , temperature, and Mach number are 0.53 atm, 255 K, and 2.8, respectively. Determine the pressure downstream of the shock wave.arrow_forwardn aircraft is flying at an altitude of 12000 metres (T=216.65 K. p = 0.193 bar) at a Mach number of 0.82. The cross sectional area of the inlet diffuser before the L.P. compressor stage is 0.5 m. Determine (a) the mass of air entering the compressor per second (b) the speed of the aircraft (c) the stagnation %3D pressure and temperature of air at the diffuser entry.arrow_forward- Air at 200 kPa, 100°C, and Mach number Ma = 0.8 lows through a duct. Calculate the velocity and the stagnation pressure, temperature, and density of the air.arrow_forward
- Elements Of ElectromagneticsMechanical EngineeringISBN:9780190698614Author:Sadiku, Matthew N. O.Publisher:Oxford University PressMechanics of Materials (10th Edition)Mechanical EngineeringISBN:9780134319650Author:Russell C. HibbelerPublisher:PEARSONThermodynamics: An Engineering ApproachMechanical EngineeringISBN:9781259822674Author:Yunus A. Cengel Dr., Michael A. BolesPublisher:McGraw-Hill Education
- Control Systems EngineeringMechanical EngineeringISBN:9781118170519Author:Norman S. NisePublisher:WILEYMechanics of Materials (MindTap Course List)Mechanical EngineeringISBN:9781337093347Author:Barry J. Goodno, James M. GerePublisher:Cengage LearningEngineering Mechanics: StaticsMechanical EngineeringISBN:9781118807330Author:James L. Meriam, L. G. Kraige, J. N. BoltonPublisher:WILEY